ADJUSTING. (a) Employees in Adjusting jobs shall receive automatic progression and a one (1) pay band adjustment between Adjusting categories as follows: Adjuster 1 Auto to Adjuster 1 AP Auto Adjuster 1 Auto/General to Adjuster 1 AP Auto/General or Adjuster 1 AP General (dependent on branch requirements) Adjuster 1 General to Adjuster 1 AP General subject to all of the following conditions being met: • Two (2) years’ satisfactory job performance at the applicable level 1. • Satisfactory completion of eight (8) CIP courses of the Insurance Institute of Canada Program at the Associateship level. • Employees who auto progress will not be required to serve a new probationary period.
ADJUSTING. A. Adjust operating products and equipment to ensure smooth and unhindered operation.
ADJUSTING. A. After installation, calibrate meters according to manufacturer's written instructions.
B. Adjust faces of meters and gages to proper angle for best visibility.
ADJUSTING. A. Adjust or replace valve packing after piping systems have been tested and put into service, but before final adjusting and balancing. If leakage cannot be repaired, replace valve.
ADJUSTING. A. Adjust operating entrance door hardware to function smoothly as recommended by manufacturer.
1. For entrance doors accessible to people with disabilities, adjust closers to provide a 3-second closer sweep period for doors to move from a 70-degree open position to 3 inches from the latch, measured to the leading door edge. END OF SECTION 084113R SECTION 087100R - DOOR HARDWARE PART 1 - GENERAL
ADJUSTING. A. Inspect installation, correct misalignments, and tighten loose connections.
B. Doors: Adjust doors to operate smoothly and easily, without binding or warping. Adjust hardware to function smoothly, and lubricate as recommended by manufacturer.
C. Clean exposed frame surfaces promptly after installation, using cleaning methods recommended in writing by frame manufacturer and according to AAMA 609 & 610.
D. Touch Up: Repair marred frame surfaces to blend inconspicuously with adjacent unrepaired surface as viewed by Architect. Remove and replace frames with damaged finish that cannot be satisfactorily repaired. END OF SECTION 081216
ADJUSTING. Operation: Rehang or replace doors that do not swing or operate freely.
ADJUSTING. A. Adjust and check for proper operation and function. Replace units, which cannot be adjusted to operate freely and smoothly.
1. Hardware damaged by improper installation or adjustment methods: repair or replace to Owner’s satisfaction.
2. Adjust doors to fully latch with no more than 1 pound of pressure.
a) Door closer valves: turn valves clockwise until at bottom – do not force. Turn valves back out one and one-half turns and begin adjustment process from that point. Do not force valves beyond three full turns counterclockwise.
3. Adjust delayed-action closers on fire-rated doors to fully close from fully-opened position in no more than 10 seconds.
4. Adjust door closers per 1.9 this section.
ADJUSTING. Contractor shall adjust operating products and equipment to ensure smooth and unhindered operation.
ADJUSTING calibrating and repairing of meters and recorders to provide accurate gas and liquid volumes and rates from well tests and sales meters. Jovian will witness meter calibrations and testing performed by others to verify meter factors and volumes. These will be performed in accordance with Company's Hydrocarbon Measurement Standard.
