Calculation of pressure indicators Sample Clauses

Calculation of pressure indicators. To evaluate the response of the metrics composing EFAI, and the method itself, against anthropogenic pressure, 14 pressure indicators (Table 4) were assessed for each site to produce the site's total pressure level. In order to account for different measurement units, each pressure indicator was standardized, by its maximum and minimum values observed or possible (varying between 0-1), following Xxxxxxxxxxx et al., 2007. The pressure index (Pi sum) was calculated as the sum of all pressure indicators for each estuarine site. The Aubry & Xxxxxxx (2006) adapted method (A&E) was calculated as the sum of 15 environmental integrative indicators (EII) criteria (1,2 re-alignment schemes; 1,3 land claim; 1,4 gross change in bathymetry and topography; 1,5 interference with the hydrographic regime; 2,1 Anthropogenically affected coastline; 2,4 Maintenance dredging – dredging area; 2,5a Maintenance dredging – disposal area; 2,9 Aquaculture; 2,10 fisheries causing nearshore seabed disturbance; 2,11 intensity of marina developments; 2.12 intensity of port developments; 3,1 water chemical quality; 3,2 sediment chemical quality; 3,6 shellfish quality and 3.10 interference with fish migration routes - chemical barrier), according to the values and scales defined by these authors, in order to allow direct comparisons in a common pressure scale.
AutoNDA by SimpleDocs

Related to Calculation of pressure indicators

  • Temperature Measurement Temperature will be measured by the nearest automatic Melbourne Bureau of Meteorology Monitoring Station for example (but not limited to): Melbourne, Moorabbin, Dunns Hill, Melbourne Airport, Frankston, and Point Xxxxxx. At the commencement of each project, the onsite management and employee representatives shall agree which is to be the applicable automatic weather monitoring station.

  • Measuring EPP parameters Every 5 minutes, EPP probes will select one “IP address” of the EPP servers of the TLD being monitored and make an “EPP test”; every time they should alternate between the 3 different types of commands and between the commands inside each category. If an “EPP test” result is undefined/unanswered, the EPP service will be considered as unavailable from that probe until it is time to make a new test.

  • Project Specific Milestones In addition to the milestones stated in Section 212.5 of the Tariff, as applicable, during the term of this ISA, Interconnection Customer shall ensure that it meets each of the following development milestones: 6.1 Substantial Site work completed. On or before December 31, 2020 Interconnection Customer must demonstrate completion of at least 20% of project site construction. At this time, Interconnection Customer must submit to Interconnected Transmission Owner and Transmission Provider initial drawings, certified by a professional engineer, of the Customer Interconnection Facilities. 6.2 Delivery of major electrical equipment. On or before December 31, 2021, Interconnection Customer must demonstrate that all generating units have been delivered to Interconnection Customer’s project site.

  • Sector Sub-Sector Industry Classification Level of Government Type of Obligation Description of Measure Source of Measure All sectors : : - : Central : National Treatment Senior Management and Board of Directors : National Treatment and the Senior Management and Board of Directors obligations shall not apply to any measure relating to small and medium sized domestic market enterprise2. Foreign equity is restricted to a maximum of 40% for domestic market enterprises with paid-in equity capital of less than the equivalent of USD 200,000 Note: Members of the Board of Directors or governing body of corporation or associations shall be allowed in proportion to their allowable participation or share in the capital of such enterprises. : -1987 Constitution of the Republic of the Philippines. - Foreign Investments Act of 1991 (R.A. No. 7042, as amended by R.A. No. 8179). -Presidential and Administrative Issuances. ∞ 2 The concept of a small and medium sized domestic market enterprise is an enterprise with paid in equity capital of less than the equivalent of USD 200,000.00.

  • Particular Methods of Procurement of Goods Works and Services (other than Consultants’ Services)

  • Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.

  • Determination of Responsiveness 28.1 The Procuring Entity's determination of a Tender's responsiveness is to be based on the contents of the Tender itself, as defined in ITT28.2.

  • Indicator Home and Community Care • Reduce wait time for home care (improve access) • More days at home (including end of life care) Percent of Palliative Care Patients discharged from hospital with home support Sustainability and Quality • Improve patient satisfaction • Reduce unnecessary readmissions Overall Satisfaction with Health Care in the Community SCHEDULE 6: INTEGRATED REPORTING‌ General Obligations‌

  • JOC - PRICING OF After Hours Coefficient What is your after hours coefficient for the RS Means Price Book for work performed after normal working hours? (FAILURE TO RESPOND PROHIBITS PART 2 JOC EVALUATION)

  • Indicators Debt to Asset Ratio (10%) •Cash Flow (10%) •Total Margin (25%)

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!