Minimum Condition and Warranty Requirements for TIPS Sales All goods quoted or sold through a TIPS Sale shall be new unless clearly stated otherwise in writing. All new goods and services shall include the applicable manufacturers minimum standard warranty unless otherwise agreed to in the Supplemental Agreement.
Inspection and Rejection of Nonconforming Goods The Buyer has the right to inspect the Goods on or after the Delivery Date. Buyer, at its sole option, may inspect all or a sample of the Goods, and may reject all or any portion of the Goods if it determines the Goods are nonconforming or defective. If Buyer rejects any portion of the Goods, Buyer has the right, effective upon written notice to Seller, to: (a) rescind the Order in its entirety; (b) accept the Goods at a reasonably reduced price; or (c) reject the Goods and require replacement of the rejected Goods. If Buyer requires replacement of the Goods, Seller shall, at its expense, promptly replace the nonconforming Goods and pay for all related expenses, including, but not limited to, transportation charges for the return of the defective goods and the delivery of replacement Goods. If Seller fails to timely deliver replacement Goods, Buyer may replace them with goods from a third party and charge Seller the cost thereof and terminate this Order for cause pursuant to Section 19. Any inspection or other action by Buyer under this Section shall not reduce or otherwise affect Seller's obligations under the Order, and Buyer shall have the right to conduct further inspections after Seller has carried out its remedial actions.
Certain Requirements as to Furniture, Equipment and Fixtures If the Assuming Institution purchases owned Bank Premises or accepts an assignment of the lease (or enters into a sublease or a new lease in lieu thereof) for leased Bank Premises as provided in Section 4.6(a) or 4.6(b), or if the Assuming Institution does not exercise such option but within twelve (12) months following Bank Closing obtains the right to occupy such premises (whether by assignment, lease, sublease, purchase or otherwise), other than in accordance with Section 4.6(a) or (b), the Assuming Institution shall (i) effective as of the date of Bank Closing, purchase from the Receiver all Furniture and Equipment and Fixtures owned by the Failed Bank at Fair Market Value and located thereon as of Bank Closing, (ii) accept an assignment or a sublease of the leases or negotiate new leases for all Furniture and Equipment and Fixtures leased by the Failed Bank and located thereon, and (iii) if applicable, accept an assignment or a sublease of any ground lease or negotiate a new ground lease with respect to any land on which such Bank Premises are located; provided, that the Receiver shall not have disposed of such Furniture and Equipment and Fixtures or repudiated the leases specified in clause (ii) or (iii).
Title to Properties; Absence of Liens and Encumbrances (a) The Company and each of its Subsidiaries have good and valid title to all of their respective properties, interests in properties and assets, real and personal, reflected on the Financial Statements, or, in the case of leased properties and assets, valid leasehold interests in such properties and assets, in each case free and clear of all Liens except for: (i) Liens reflected on the Financial Statements, (ii) Liens consisting of zoning or planning restrictions, easements, permits and other restrictions or limitations on the use of real property or irregularities in title thereto which do not materially detract from the value of, or materially impair the use of, such property as it is presently used, (iii) Liens for current Taxes, assessments or governmental charges or levies on property not yet due or which are being contested in good faith and for which appropriate reserves in accordance with GAAP have been created and (iv) mechanic's, materialmen's and similar Liens arising in the ordinary course of business or by operation of law (collectively, "Permitted Liens").
(b) Section 3.16(b) of the Disclosure Letter sets forth a true, complete and correct list of all real property leased by the Company or any of its Subsidiaries. Neither the Company nor any of its Subsidiaries owns any real property. Each of the Company and its Subsidiaries is in compliance in all material respects with the terms of all leases for real property to which it is a party. Neither the Company nor any of its Subsidiaries is a party to any lease, assignment or similar arrangement under which the Company or any Subsidiary is a lessor, assignor or otherwise makes available for use by any third party any portion of the owned or leased real property.
(c) The facilities, property and equipment owned, leased or otherwise used by the Company or any of its Subsidiaries that are material to the functioning of the businesses of the Company and its Subsidiaries are in a good state of maintenance and repair, free from material defects and in good operating condition (subject to normal wear and tear) and suitable for the purposes for which they are presently used.
(d) All tangible assets which are leased by the Company or any of its Subsidiaries that are material to the functioning of the businesses of the Company and its Subsidiaries have been maintained with the manufacturers' standards and specifications required by each such lease such that, at each such termination of the lease, such assets can be returned to their owner without any further material obligation on the part of the Company or any of its Subsidiaries with respect thereto.
Minimum Shipping Requirements for TIPS Sales Vendor shall ship, deliver, or provide ordered goods and services within a commercially reasonable time after acceptance of the order. If a delay in delivery is anticipated, Vendor shall notify the TIPS Member as to why delivery is delayed and provide an updated estimated time for completion. The TIPS Member may cancel the order if the delay is not commercially acceptable or not consistent with the Supplemental Agreement applicable to the order.
Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.
Early Construction of Base Case Facilities Developer may request Connecting Transmission Owner to construct, and Connecting Transmission Owner shall construct, subject to a binding cost allocation agreement reached in accordance with Attachment S to the ISO OATT, including Section 25.8.7 thereof, using Reasonable Efforts to accommodate Developer’s In-Service Date, all or any portion of any System Upgrade Facilities or System Deliverability Upgrades required for Developer to be interconnected to the New York State Transmission System which are included in the Base Case of the Class Year Study for the Developer, and which also are required to be constructed for another Developer, but where such construction is not scheduled to be completed in time to achieve Developer’s In-Service Date.
COMPLIANCE WITH COVENANTS, RESTRICTIONS AND BUILDING CODE Lessor warrants that any improvements (other than those constructed by Lessee or at Lessee's direction) on or in the Premises which have been constructed or installed by Lessor or with Lessor's consent or at Lessor's direction shall comply with all applicable covenants or restrictions of record and applicable building codes, regulations and ordinances in effect on the Commencement Date. Lessor further warrants to Lessee that Lessor has no knowledge of any claim having been made by any governmental agency that a violation or violations of applicable building codes, regulations, or ordinances exist with regard to the Premises as of the Commencement Date. Said warranties shall not apply to any Alterations or Utility Installations (defined in Paragraph 7.3(a)) made or to be made by Lessee. If the Premises do not comply with said warranties, Lessor shall, except as otherwise provided in this Lease, promptly after receipt of written notice from Lessee given within six (6) months following the Commencement Date and setting forth with specificity the nature and extent of such non-compliance, take such action, at Lessor's expense, as may be reasonable or appropriate to rectify the non-compliance. Lessor makes no warranty that the Permitted Use in Paragraph 1.8 is permitted for the Premises under Applicable Laws (as defined in Paragraph 2.4).
Conditions to Obligations of Buyer and Seller The obligations of Buyer and Seller to complete the transactions contemplated by this Agreement are subject to the satisfaction at or prior to the Closing of the following conditions:
Entitlements and Purchasing Requirements You must purchase the appropriate number of Software Subscription(s), based on the number of Socket-pairs for all Managed Nodes being managed by the Red Hat CloudForms Software. A “Socket-pair” is up to two sockets each occupied by a CPU on a Managed Node. Red Hat CloudForms Software is configured to manage virtual machines on certain public clouds (a “Red Hat CloudForms Enabled Cloud”). You must purchase the appropriate number of Red Hat CloudForms for Public Cloud Software Subscriptions based on the number of Managed VMs instantiated on a Red Hat CloudForms Enabled Cloud. Please confirm that a specific public cloud is a Red Hat CloudForms Enabled Cloud prior to purchasing. A Red Hat Enterprise Linux Software Subscription is bundled with the Red Hat CloudForms Software Subscription and the fees for the Red Hat CloudForms Subscription are based on such bundled use. Any use of the Red Hat Enterprise Linux other than to run the Red Hat CloudForms Software is subject to Red Hat’s standard Software Subscription fees for such use.
