Time Off for Union Activities The employer agrees to grant the necessary time off, without discrimination or loss of seniority rights and without pay, to any employee designated by the Union to attend a labor convention provided that there is two-week notice of any union convention. Due consideration shall be given to the number of personnel affected in order that there shall be no disruptions of employer's operations due to lack of available employees.
Time Off for Union Business (a) Leave of absence without pay shall be granted upon request for the reasons set out below unless it would unduly interrupt the Employer's operations: (1) to an elected or appointed representative of the Union to attend conventions of the Union and bodies to which the Union is affiliated, to a maximum of 21 days per occurrence; (2) for elected or appointed representatives of the Union to attend to union business which requires them to leave their general work area; (3) for employees who are representatives of the Union on a bargaining committee. (b) Long-term leave of absence without pay shall be granted to employees designated by the Union to transact union business for specific periods of not less than 21 days unless this would unduly interrupt the operation of the department. Such requests shall be made in writing sufficiently in advance to minimize disruption of the department. Employees granted such leave of absence shall retain all rights and privileges accumulated prior to obtaining such leave. Seniority shall continue to accumulate during such leave and shall apply to such provisions as annual vacations, increments and promotions. (c) When leave of absence without pay is granted pursuant to Part (a) or (b), the leave shall be given with pay and the Union shall reimburse the Employer for salary and benefit costs, including travel time incurred, within 60 days of receipt of the invoice. It is understood that employees granted leave of absence pursuant to this clause shall receive their current rates of pay while on leave of absence. Leave of absence granted under this clause shall include sufficient travel time. The pay and benefits received by the employee and reimbursed by the Union under this article shall be based on the number of hours to which the Union indicates, in writing, the employee is entitled. This provision does not apply to employees on extended leaves of absence who are employed by the Union on a full-time basis. (d) Leave of absence with pay and without loss of seniority will be granted to an employee called to appear as a witness before an arbitration board, provided the dispute involved the Employer. On application, the Arbitration Board may determine summarily the amount of time required for the attendance of any witness. (e) The Union shall provide the Employer with reasonable notice to minimize disruption of the operation and shall make every reasonable effort to give a minimum of 14 days’ notice prior to the commencement of leave under (a) or (b) above. The Employer agrees that any of the above leaves of absence shall not be unreasonably withheld.
Information and Services Required of the Owner The Owner shall provide information with reasonable promptness, regarding requirements for and limitations on the Project, including a written program which shall set forth the Owner’s objectives, constraints, and criteria, including schedule, space requirements and relationships, flexibility and expandability, special equipment, systems, sustainability and site requirements.
Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.
Unbundled Copper Loop – Non-Designed (UCL-ND 2.4.3.1 The UCL–ND is provisioned as a dedicated 2-wire metallic transmission facility from AT&T’s Main Distribution Frame (MDF) to a customer’s premises (including the NID). The UCL-ND will be a “dry copper” facility in that it will not have any intervening equipment such as load coils, repeaters, or digital access main lines (DAMLs), and may have up to six thousand (6,000) feet of bridged tap between the End User’s premises and the serving wire center. The UCL-ND typically will be thirteen hundred (1300) Ohms resistance and in most cases will not exceed eighteen thousand (18,000) feet in length, although the UCL-ND will not have a specific length limitation. For Loops less than eighteen thousand (18,000) feet and with less than thirteen hundred (1300) Ohms resistance, the Loop will provide a voice grade transmission channel suitable for Loop start signaling and the transport of analog voice grade signals. The UCL-ND will not be designed and will not be provisioned with either a DLR or a test point. 2.4.3.2 The UCL-ND facilities may be mechanically assigned using AT&T’s assignment systems. Therefore, the Loop Makeup (LMU) process is not required to order and provision the UCL-ND. However, Covad can request LMU based on existing procedures for LMU on other Loop types, for which additional charges would apply. 2.4.3.3 For an additional charge, AT&T also will make available Loop Testing so that Covad may request further testing on the UCL-ND. Rates for Loop Testing are as set forth in Exhibit A. 2.4.3.4 UCL-ND Loops are not intended to support any particular service and may be utilized by Covad to provide a wide-range of telecommunications services as long as those services do not adversely affect AT&T’s network. The UCL-ND will include a NID at the customer’s location for the purpose of connecting the Loop to the customer’s inside wire. 2.4.3.5 OC will be provided as a chargeable option and may be utilized when the UCL-ND provisioning is associated with the reuse of AT&T facilities. OC-TS does not apply to this product.
