Internal Roads Sample Clauses

Internal Roads. Roads and other passageways within the operating Landfill shall be graded as necessary to maintain smooth, well drained surfaces. During dry periods, these operating roads and passageways shall be sprayed with water if necessary to reduce dust. Company shall be responsible for maintaining such roads and passageways in accordance with this Section 6.2.
AutoNDA by SimpleDocs
Internal Roads. In connection with development of Planning Area 1, and prior to issuance of certificates of occupancy for buildings in Planning Area 1, the Owner will construct Project accesses and internal roads approximately as shown on PCI Plan Sheet SP-3. These roads will be private roads designed to the road standards described and depicted in the PCI Plan at pages IV-31 through IV-32 and PCI Plan Sheet SP-3. The Owner may modify the locations of access points and internal roads in Planning Area 1 depicted in the PCI Plan as provided in Paragraphs 7.1 and 7.2 of this Agreement. The locations of access points and internal roads within Planning Areas 2 and 3 will be reviewed and approved in connection with development of those Planning Areas.
Internal Roads. Metalled roads, finished with carpet and seal - coat cover W.B.M. including pathways (brick/concrete) paving stones, if any.
Internal Roads. The Concessionaire shall provide good quality motorable roads within the Site which shall meet the minimum criteria as set out in Table 2.4.
Internal Roads. The Concessionaire shall provide good quality motorable roads within the Landfill Facility which shall meet the minimum criteria as set out in Table 2.4 of Schedule D.
Internal Roads. All roads within the confines of a Development Pod shall be deemed "Internal Roads." All Internal Roads shall be designed for local access, 30 feet wide, with a 50 right-of-way, all in accordance with the cross-section schematic attached as Exhibit 4 to this Agreement. All Internal Roads shall be designed to drain towards a collection ditch or biofiltration swale adjacent to the edge of pavement. Curbs, gutters and sidewalks shall not be required. To facilitate snow plowing activities in the area, a 5 foot easement immediately adjacent to any Internal Road will be recorded against all lots fronting the Internal Road. Roads have been designed in accordance with these requirements. Refer to sheets RS-01 to RS-03 of the Preliminary Engineering Plans for details which also contains notes regarding easement for snow removal. Xxxxxx adjacent to roadways have been utilized where road grades allowed. Bioswales have also been designed to provide water quality treatment immediately upstream of the proposed storm water detention facilities.
Internal Roads. The Concessionaire shall provide good quality motorable roads within the Sites which shall meet the minimum criteria. Parameter Specifications Carriageway width  5 m Pavement design  Flexible pavement with the following specifications (as per Specifications for Road and Bridge Works (latest Revision) by Ministry of Surface Transport published by Indian Roads Congress [IRC])  Sub-grade: CBR value of 5%  Sub-base: 200 mm thick, sand-gravel mix of 1:1, CBR value of 20%  Base course: 150 mm thick WBM in 2 layers of 75 mm each  Asphalt base: 50 mm thick Bituminous Macadam laid with mechanical spreaders  Seal Coat: Semi dense bituminous concrete or mixed seal surface
AutoNDA by SimpleDocs
Internal Roads. All roads within the confines of a Development Pod shall be deemed "Internal Roads." All Internal Roads shall be designed for local access, 30 feet wide, with a 50 right-of-way, all in accordance wit the cross-section schematic attached as Exhibit 4 to this Agreement. All Internal Roads shall be designed to drain towards a collection ditch or biofiltration swale adjacent to the edge of pavement. Curbs, gutters and sidewalks shall not be required. To facilitate snow plowing activities in the area, a 5 foot easement immediately adjacent to any Internal Road will be recorded against all lots fronting the Internal Road. Roads have been designed in accordance with thesrequirements with xxxxxx being replaced with thickened edge curb and storm water collection hsystem. Refer to sheets RS-01 and RD-01 of the Preliminary Engineering Plans for details which also contains notes regarding easement for snow removal. As approved with Phase 1, a modified local access with and without parking is proposed as well as a private road. Water quality is provided by a bioswale located downstream of Phase 3 All roads within City Heights outside Development Pods which connect Development Pods to one another or to the general road network beyond City Heights shall be deemed "Collector Roads." All Collector Roads shall have a 45' right of way, inclusive of 28' of hard surface comprised of 22' of travel lanes and 3' of shoulders on either side of the travel lanes, and shall be constructed in accordance with the applicable cross- section schematic attached as Exhibit 6 to this Agreement. All Collector Roads shall be designed to drain towards a collection ditch or bio-filtration swale adjacent to the edge of pavement. All Collector Roads between the point of connection with existing City streets and their point of entry into Development Areas shall be developed with hard-surfaced pedestrian trails of a width sufficient to safely accommodate 2 pedestrians travelling in opposite directions, which trails shall to the fullest extent practicable be off-set from and parallel to the hard-surface roadway of said Collector Roads. All Collector Roads should be aligned with existing City streets at intersections creating 90 degree cross or "T" intersections. Summit View Drive and Columbia Avenue shall be deemed "Collector Roads" to the extent within the Property, as shall Xxxxxxxxxx Avenue, to the extent within the Property and extending northward as far as Sixth Street. A 10' easement immediatel...
Internal Roads. 8.1 Internal roads or tracks must be sited as shown on the Approved Work Plan. 8.2 Any such road may be used – (a) by officers of, or persons authorised by the Department of Primary Industries or any persons engaged in fire control; (b) for the extraction of forest produce or for mining purposes by any other operator under the Mineral Resources Development Axx 0000 or Fxxxxxx Xxx 0000 (or any successor legislation) under such conditions as may be determined by agreement between the parties concerned; and (c) by the landowners or their agents where the licence covers private land. 8.3 The operator must ensure that all internal roads are properly formed, drained, surface treated and maintained to the satisfaction of an Inspector.
Internal Roads. All internal streets shall be constructed to meet or exceed the minimum requirements of City’s Code and the Fire and Rescue Department performing fire and rescue services within the City, or as specifically provided in the CSP and shall be reviewed and approved by the City Public Works
Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!