We use cookies on our site to analyze traffic, enhance your experience, and provide you with tailored content.

For more information visit our privacy policy.

Pilot Duties Sample Clauses

Pilot Duties. Pilots shall exercise pilots’ duties and responsibilities in regard to the safety of each flight conducted pursuant to this Agreement in accordance with the applicable FAR. When safety may be compromised, in the view of the pilots of any Aircraft used pursuant to this Agreement, the pilots may terminate a flight, refuse to commence a flight or take other action necessitated by safety considerations. Nothing in this Agreement shall be construed to abridge the authority and responsibility of the pilot-in-command as provided under pertinent FAR Part 91 regulations.
Pilot Duties. A. XxxXxx may direct a pilot to carry out such duties as are within the limits of the pilot's skill, competency and training, such duties are not designed to promote deskilling, and are consistent with safety requirements. B. XxxXxx may direct a pilot to carry out such duties and use such tools and equipment as may be required provided that the pilot has been properly trained in the use of such tools and equipment. C. These additional duties may include but will not necessarily be limited to: i) Following consultation with the pilot and by mutual agreement partaking, in rostered shifts in areas other than flying. ii) All duties undertaken would be in accordance with, and subject to, the flight and duty limitations as set out in CAO 48 or exemption to CAO 48 issued to MacAir Airlines by the Civil Aviation Safety Authority (CASA). iii) If performing duties other than those of a pilot during a nominated shift, you will not be required to then perform the duties of a pilot during the same shift unless you consider yourself to be fit and able to safely carryout the proposed duties D. Pilot duties will include but will not be limited to: i) Operational duties associated with the preparation for and conduct of a flight, including normal fuelling, refueling and handling of passenger baggage and/or cargo subject to clause 2.8 – Classification and salary. ii) Completion of statutory and Company documentation associated with a flight. iii) Necessary maintenance of cabin tidiness consistent with passenger comfort. E. Pilot duties will be incidental or peripheral to pilotage.
Pilot Duties. 12.1 Pilot duties shall include but not be limited to: 12.1.1 Operational duties associated with the preparation for and conduct of a flight, including reasonable assistance with the normal handling of passenger baggage and/or cargo and if necessary refuelling. 12.1.2 Completion of statutory and Company documentation associated with a flight. 12.1.3 Necessary maintenance of cabin tidiness consistent with passenger comfort. 12.1.4 A pilot shall not be required to carry out the duties referred to in sub- clause 12.1.1 or 12.1.3 of this clause, if appropriate personnel or facilities are available. In addition, a pilot may be required to perform administrative duties that are considered within an individual pilots competence.
Pilot Duties 

Related to Pilot Duties

  • Job Duties It is understood by the parties that every incidental duty connected with operations enumerated in job descriptions is not always specifically described and employees may be required to perform other job-related duties not specifically contained in the job description; however, employees required to perform such duties shall be qualified for the work to be performed.

  • Specific Duties Manager’s duties include the following:

  • Extra Duties The Trustee shall be entitled to refuse to approve any Substituted Obligor if, pursuant to the law of the jurisdiction of incorporation of the Substituted Obligor, the assumption by the Substituted Obligor of its obligations hereunder imposes responsibilities on the Trustee over and above those which have been assumed under this Trust Deed.

  • Normal Duties (a) Faculty members are accountable for 10 months of the year. The 10 months accountable time includes such activities as teaching, the counselling of students, curriculum/program development, professional development and participation on a variety of educational committees. (b) At least one month before the commencement of any accountable time longer than four consecutive days, and covering activities other than teaching or professional development the faculty member will submit for approval to the appropriate administrator an activity plan for this period. Approval will not be unreasonably withheld. On an annual basis, the faculty member will submit to the appropriate administrator a written report of their accountable time activities.

  • Fas Duties As Administrator, and subject to the supervision and control of the Investment Company’s Board of Trustees/Directors (the “Board”), FAS will provide facilities, equipment, and personnel to perform or cause to be performed the following “Administrative Services” for operation of the business and affairs of the Investment Company and each of its Funds and any additional Administrative Services that FAS shall agree in writing to perform, or cause to be performed, for the Investment Company from time to time:

  • Typical Duties Measures distance points from reference points and marks guidelines on working surface to lay out work. • Determines vertical and horizontal alignment of courses using xxxxx xxx, gauge line (tightly stretched cord) and level. • Spreads soft layer of mortar that serves as base and binder for brick or block using trowel. • Breaks or cut bricks or blocks to size, using power or hand tools. • Shapes stone preparatory to setting, using a chisel hammer and other shaping tools. • Applies mortar to end of brick or block and positions same in mortar bed. • Spreads mortar over stone and foundation with trowel and sets stone in place by hand or with aid of a crane. • Removes excess mortar from face using trowel. • Taps brick or block with trowel to level, align and embed in mortar, allowing for specified thickness of joint. • Aligns stone with plumb line and finishes joints between stone with a pointing trowel. • Fastens brick, block, or terra cotta veneer to face of buildings or structures with appropriate ties embedded in mortar between units or in anchor holes in units. • Grouts, insulates, and places all reinforcing rods, anchors, and flashing in masonry walls. • Lays refractory brick, block, and insulation in place by spreading, dipping, or spraying materials to build furnaces, line boilers or like fire resistant structures. • Finishes mortar between brick and block with pointing tool or trowel. • Points, cleans, caulks and waterproofs masonry. • Cleans excess mortar or grout from surface of stone using sponge, brush, water, or acid. Brick Trowel, Pointing trowel, Brick Hammer, 2’’& 4’’ Levels, Standard Square, Speed Square, Sliding T Bevel, Braided Masonry Line, Line pins & Line Blocks, Standard Tape Measure, Brick Spacing & Modular tapes, Gauge Rod, Tuck Pointers. APPENDIX A CLASSIFICATIONS, WAGES & BENEFITS UNION BASE RATE CREDIT UNION PROVISION (See Note b) PENSION FUND HEALTH & WELFARE APPREN- TICESHIP FUND ANNUITY (See Note b) CARPENTERS (Effective (06/01/2023 – 05/31/2024) Group I $ 36.55 (a) $ 2.40 $ 5.66 $ 8.00 $ 0.78 $ 0.50 Group II $ 36.98 (a) $ 2.40 $ 5.66 $ 8.00 $ 0.78 $ 0.50 Group III $ 37.22 (a) $ 2.40 $ 5.66 $ 8.00 $ 0.78 $ 0.50 General Xxxxxxx: To be negotiated between the GF and the Company but will be at a rate no less than 12% per hour over the Journeyman scale of the classification under his/her supervision.

  • Basic Duties 1. For each product the basic duty, to which the successive reductions set out in this Agreement are to be applied, shall be the most-favoured-nation rate of duty (MFN rate) applied on 1 January 2000. 2. If, before, by or after entry into force of this Agreement, any tariff reduction is applied on an erga omnes basis, in particular reductions in accordance with commitments resulting from multilateral negotiations under the WTO, such reduced duties shall replace the basic duties referred to in paragraph 1 as from the date when such reductions are applied, or from the entry into force of this Agreement if this is later. 3. The reduced duties calculated in accordance with Article 4(2) (Customs duties on imports and charges having equivalent effect) shall be applied rounded to the first decimal place or, in case of specific duties, to the second decimal place.

  • Contractor’s Duties Notwithstanding termination of the contract and subject to any directions from the procurement officer, Contractor shall take timely, reasonable, and necessary action to protect and preserve property in the possession of Contractor in which the State has an interest.

  • General Duties and Responsibilities 1. Responsibilities under the General Conditions of the Contract for Construction: In addition to the responsibilities herein set forth, Consulting Engineer/Architect agrees to be responsible for those matters identified in the General Conditions as being responsibilities of the Consulting Engineer/Architect. Consulting Engineer/Architect specifically acknowledges receipt of a copy of the General Conditions and acceptance of the responsibilities as set forth therein.

  • Executive Duties During and after Executive’s employment with the Company, Executive shall, without additional compensation: (i) promptly disclose to the Company any Employee Development, specifically identifying any inventions, improvements or other portions of the Employee Development that are potential patentable or susceptible to protection as a trade secret; (ii) execute and deliver any and all applications, assignments, documents, and other instruments that the Company shall deem necessary to protect the right, title and interest of the Company or its designee in or to any Employee Development; (iii) reasonably cooperate and assist in providing information for making and completing regulatory and other filings in connection with any Employee Development; (iv) reasonably cooperate and assist in providing information for or participating in any action, threatened action, or considered action relating to any Employee Development; and (v) take any and all other actions as the Company may otherwise require with respect to any Employee Development.