Termination for Convenience TIPS may, by written notice to Vendor, terminate this Agreement for convenience, in whole or in part, at any time by giving thirty (30) days’ written notice to Vendor of such termination, and specifying the effective date thereof.
Scope of Services The specific scope of work for each job shall be determined in advance and in writing between TIPS Member, Member’s design professionals and Vendor. It is permitted for the TIPS Member to provide a general scope description, but the awarded vendor should provide a written scope of work, and if applicable, according to the TIPS Member’s design Professional as part of the proposal. Once the scope of the job is agreed to, the TIPS Member will issue a PO and/or an Agreement or Contract with the Job Order Contract Proposal referenced or as an attachment along with bond and any other special provisions agreed by the TIPS Member. If special terms and conditions other than those covered within this solicitation and awarded Agreements are required, they will be attached to the PO and/or an Agreement or Contract and shall take precedence over those in this base TIPS Vendor Agreement.
Introduction The Texas Health and Human Services Commission ("HHSC") and the Contractor named in Section I (HHSC and Contractor may be referenced in this document collectively as the “Parties” and individually as the “Party") hereby enter into this Community Services Contract - Provider Agreement (the “Contract”) for the provision of services under the Contract type specified in Section I for the considerations set forth herein. The Contract Begin Date specified in Section I is not valid until this Contract is signed by both parties.
Terms of procurement Terms of submission: Maximum number of lots for which one tenderer can submit tenders: 0
RECOGNITION 1. For the purposes of the fulfillment, in whole or in part, of its standards or criteria for the authorization, licensing or certification of services suppliers, and subject to the requirements of paragraph 3, a Party may recognize the education or experience obtained, requirements met, or licences or certifications granted in the other Party or a non-Party. Such recognition, which may be achieved through harmonization or otherwise, may be based upon an agreement or arrangement with the other Party or a non-Party concerned or may be accorded autonomously. 2. A Party that is a party to an agreement or arrangement of the type referred to in paragraph 1, whether existing or future, shall afford adequate opportunity for the other Party, if the other Party is interested, to negotiate its accession to such an agreement or arrangement or to negotiate comparable ones with it. Where a Party accords recognition autonomously, it shall afford adequate opportunity for the other Party to demonstrate that education, experience, licences or certifications obtained or requirements met in that other Party's territory should be recognized. 3. A Party shall not accord recognition in a manner which would constitute a means of discrimination between countries in the application of its standards or criteria for the authorization, licensing or certification of services suppliers, or a disguised restriction on trade in services. 4. Each Party should encourage the relevant bodies in its respective territory to conduct future negotiations for developing mutually acceptable standards and criteria for licensing, temporary licensing and certification of professional services suppliers.
Relationship of the Parties Nothing contained in this Agreement shall be construed to make one Party an agent of the other Party nor shall either party have any authority to bind the other in any respect, unless expressly authorized by the other party in writing. The Parties are independent contractors and nothing in this Agreement creates a relationship of employment, trust, agency or partnership between them.
Definitions and Interpretation 1.1 In this Agreement:
MANAGEMENT RIGHTS 3.01 The Union acknowledges that all management rights and prerogatives are vested exclusively with the Employer and without limiting the generality of the foregoing; it is the exclusive function of the Employer:
GRIEVANCE PROCEDURE 7.01 For purposes of this Agreement, a grievance is defined as a difference arising between the parties relating to the interpretation, application, administration or alleged violation of the Agreement including any question as to whether a matter is arbitrable.
Exclusions The Warrant Agent shall have no responsibility with respect to the validity of this Agreement or with respect to the validity or execution of any Warrant (except its countersignature thereof). The Warrant Agent shall not be responsible for any breach by the Company of any covenant or condition contained in this Agreement or in any Warrant. The Warrant Agent shall not be responsible to make any adjustments required under the provisions of Section 4 hereof or responsible for the manner, method, or amount of any such adjustment or the ascertaining of the existence of facts that would require any such adjustment; nor shall it by any act hereunder be deemed to make any representation or warranty as to the authorization or reservation of any shares of Common Stock to be issued pursuant to this Agreement or any Warrant or as to whether any shares of Common Stock shall, when issued, be valid and fully paid and non-assessable.
