MEASURING EQUIPMENT 1, Seller will maintain and operate, at its own, expense and at the point of delivery of gas hereunder, a meter or meters and other necessary equipment by which the volume of gas delivered hereunder shall be measured, Such meters and equipment shall remain the property of the Seller.
2. Xxxxx agrees to fumish to Seller electricity for operating Seller's meters, at not cost to Seller,
3. Xxxxx agrees to change the charts on Xxxxxx's meters at no cost to Seller and forward same to Seller.
4. Buyer hereby grants to Seller suitable rights-ot-way and easemenisnecessary or incidenial for ihe installation, maintenance, operation and removal of pipeline and other facilities together with rights of ingress thereto and egress there from at all times and hereby agrees to deliver to Seller, for the sum of one dollar ($1 ,00), an appropriate instrument or grant defining such rights and easements located on Buyer's plant site.
5. Buyer may install, maintain and operate such check measuring equipment, including a recording gravitometer and calorimeter as it shall desire, provided that such equipment shall be so installed so as not to interfere with the operation of Seller's measuring equipment at or near the point of deliver. However, all xxxxxxxx to the Buyer shall be based on the metering of the Seller, subject only to the provisions of Paragraph 8 of this Article,
6. Each party shall have the right to be present at the time of any installing, reading, cleaning, changing, repairing, inspecting, testing, calibrating, or adjusting done in connection with the other's measuring equipment used in measuring deliveries hereunder and each party shall advise the other of any intended major maintenance operation sufficiently in advance in order that the other party may conveniently have its representative present.
Computer Equipment Recycling Program If this Contract is for the purchase or lease of computer equipment, then Contractor certifies that it is in compliance with Subchapter Y, Chapter 361 of the Texas Health and Safety Code related to the Computer Equipment Recycling Program and the Texas Commission on Environmental Quality rules in 30 TAC Chapter 328.
Equipment Return You may use the Leased Equipment provided under this plan only while you remain an active customer in good standing and in compliance with this Agreement (including, without limitation, the RCA). You must return all Leased Equipment in good operating condition, normal wear and tear excepted, within 30 days following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment. If you acquired your Leased Equipment from a retailer, then you must return all Leased Equipment to: (A) your original retailer, if such cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs during the first 30 days following your initial activation of programming; or (B) DISH, if such cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs after such 30-day period. You are responsible for and shall bear all costs, expenses and risk of returning your Leased Equipment, including, without limitation, risk of loss during shipment. You are not responsible under the terms and conditions of this Agreement for the return of equipment other than your Leased Equipment. Following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment (unless you acquired your Leased Equipment from a retailer and the cancellation or disconnection of your DISH service or disconnection of your Leased Equipment occurs during the first 30 days following your initial activation of programming and you returned Leased Equipment to such retailer within 30 days following cancellation or disconnection of your DISH service or disconnection of your Leased Equipment), DISH will send you one or more return labels or empty boxes (depending on your Leased Equipment) to be used by you in returning your Leased Equipment and DISH will charge you up to $20.00 for each such return label or empty box (“Box Return Fee”). The BoxReturn Fee is subject to change at any time. Unless you are a resident of a Remote Area of Alaska, you also have the option of contacting DISH by calling 000-000-XXXX (000-000-0000) to request that DISH or our designee(s) perform an in-home service call to remove your Leased Equipment at DISH’s then-current in-home service call rate, which rate is subject to change at any time. Leased Equipment will not be deemed returned until received by DISH. DISH Protect is an optional service program currently priced as set forth in the table below. DISH Protect is offered in two (2) plans: Dish Protect and Plus. The services offered in each plan can be viewed at xxxxxx.xxx/xxxxxxxxxxx. If you enroll in a DISH Protect plan, you will receive an initial six (6) month trial offer of DISH Protect if you are eligible and if such plans are otherwise available to you at the time you sign this Agreement. During the trial offer period, you will be charged the monthly Trial Offer Price set forth below. By signing above, you are accepting the terms of this trial offer and understand that you may cancel or change your DISH Protect plan at any time by calling 000- 000-XXXX (3474) or by emailing xxxxxxxxxxxxxxxxxxxxxxxx@xxxx.xxx. You also agree that if you do not cancel your DISH Protect plan during the initial six (6) month trial offer period, DISH will automatically begin billing you the then-current monthly Regular Price of your DISH Protect plan upon the expiration of the six (6) month trial offer period until you cancel your DISH Protect plan. Not all DISH Protect plans are available to all customers. DISH Protect is not available to residents of Remote Areas of Alaska and/or residents of some Shared Dish MDU Properties. If you reside in a Shared Dish MDU Property and you are not sure if you qualify for DISH Protect, then please call 000-000-0000 to determine if you qualify. DISH Protect $11.99 $0.00 DISH Protect Plus $11.99 $0.00
Metering Equipment 13.01. Utility will furnish, install, own and maintain metering equipment capable of measuring the flow of kilowatt-hours (kWh) of energy. The Customer's service associated with the CRG will be metered at a single metering point. The metering equipment will measure energy delivered by Utility to Customer and also measure energy delivered by Customer to Utility. Customer agrees to provide safe and reasonable access to the premises for installation of this equipment and its future maintenance or removal.
Line Outage Costs Notwithstanding anything in the ISO OATT to the contrary, the Connecting Transmission Owner may propose to recover line outage costs associated with the installation of Connecting Transmission Owner’s Attachment Facilities or System Upgrade Facilities or System Deliverability Upgrades on a case-by-case basis.
New Equipment Where new types of equipment and/or operations, for which rates of pay are not established by this Agreement, are put into use after the ratification date of this Agreement within operations covered by this Agreement, rates governing such operations shall be subject to negotiations between the parties. This paragraph shall apply to all new types of equipment including office and clerical equipment. In the event an agreement cannot be reached within sixty (60) days after the date such equipment is put into use, the matter may shall be submitted to the National Grievance Committee for final disposition. Rates agreed upon or awarded shall be effective as of the date equipment is put to use
Mandatory equipment (a) All Employees engaged to work on site will be supplied with safety footwear and safety helmets appropriate to the work that they perform before commencing work on a Project. The safety footwear will be of an equivalent standard to those made by:
(i) Steel Blue;
(ii) Xxxxxx; and
(iii) Mongrel Boots.
(b) These items must be worn at all times as instructed during the Project induction process.
(c) Helmets must not be painted, drilled or modified in any way. Damaged and/or worn footwear and helmets will be replaced on demand.
Interconnection Customer Compensation for Actions During Emergency Condition The CAISO shall compensate the Interconnection Customer in accordance with the CAISO Tariff for its provision of real and reactive power and other Emergency Condition services that the Interconnection Customer provides to support the CAISO Controlled Grid during an Emergency Condition in accordance with Article 11.6.
Equipment Specifications All equipment must meet the contract specifications and all federal and State safety codes and regulations in effect at the date of manufacture. All equipment must be Original Equipment Manufacturer (OEM) equipment unless otherwise stated in the contract. All products, materials, supplies, replacement parts, and equipment offered and furnished must be new, of current manufacturer production, and must have been formally announced by the manufacturer as being commercially available, unless otherwise stated in this Contract.
Mileage Measurement Where required, the mileage measurement for LIS rate elements is determined in the same manner as the mileage measurement for V&H methodology as outlined in NECA Tariff No. 4.
