Relocation of Existing Water Meters. When a service line has been extended and a line setter installed in a meter box, City forces will re-install meter. No compression fittings will be utilized.
Relocation of Existing Water Meters Sample Clauses
Related to Relocation of Existing Water Meters
CONDITIONS FOR EMERGENCY/HURRICANE OR DISASTER - TERM CONTRACTS It is hereby made a part of this Invitation for Bids that before, during and after a public emergency, disaster, hurricane, flood, or other acts of God that Orange County shall require a “first priority” basis for goods and services. It is vital and imperative that the majority of citizens are protected from any emergency situation which threatens public health and safety, as determined by the County. Contractor agrees to rent/sell/lease all goods and services to the County or other governmental entities as opposed to a private citizen, on a first priority basis. The County expects to pay contractual prices for all goods or services required during an emergency situation. Contractor shall furnish a twenty-four (24) hour phone number in the event of such an emergency.
Utilities; Amenities The following utilities are included in the Total Rent set forth in this Agreement: Internet access and trash disposal. Resident will pay as additional Rent a pro-rata share (based on the number of contracted residents in possession for the applicable period) for the apartment's usage of electricity and water, applied pro-rata to any partial billing cycle. Resident will be responsible for his or her pro-rata share of electricity and water charges during the term of this Agreement, regardless of actual date of move-in or move-out. No refund or credit will be provided for usage below any applicable allowance levels. In connection with the administration of utility billing during the term of this Agreement, Resident will pay prior to occupying the assigned apartment (or on the first utility bill, at Owner's discretion), a single up-front billing service fee of up to $72.00 (or alternately, at Owner's option, a service fee of up to $6.00 per monthly bill) for administration, billing, overhead and similar expenses and charges incurred by Owner for providing utility allocations and billing services. Upon Resident's request, Owner will provide copies of applicable utility bills. At Owner's option, to the extent permitted by law, Resident may be pre-billed for the estimated amount of charges for any electricity and/or water bills anticipated to be received during the final 30 days of the term or after the end of the term of this Agreement, calculated based on historical electricity and/or water charges for the apartment and pursuant to applicable utility billing laws and regulations. As part of each utility bill, Resident may be charged and agrees to pay promptly to Owner any other miscellaneous charges billed by the utility provider and payable by the customer of record, plus late payment fees and/or NSF fees, as may be applicable, in the amounts stated in paragraph 2 of this Agreement, as liquidated estimates of costs incurred in connection with the administration and collection of late payment. Owner may elect to use one or more third-party service providers for providing, billing and/or servicing utility accounts; Resident acknowledges that such third-party providers are not utility providers. Owner makes no representations and hereby disclaims any and all warranties, express or implied, with respect to any utilities provided, including but not limited to those warranties concerning merchantability and fitness for a particular purpose or use, whether made allegedly by Owner or its representatives or agents, whether in writing or otherwise, except as otherwise expressly stated in this Agreement. Owner does not warrant or guarantee the protection of Resident's privacy during operation of utilities, that such utilities will satisfy Resident's requirements, or that the operation of utilities will be uninterrupted or error free. Resident acknowledges and agrees that neither Owner nor its affiliates, agents, employees or representatives will be responsible to Resident for any non-economic, consequential, incidental, indirect or special damages, including incidental, economic or punitive damages, arising from breach of warranty, breach of contract, negligence or any other legal ground of action, or by reason of the use, discontinuation or modification of any utilities or the termination of any utilities, whether arising from Resident's use of (or inability to use) utilities, or otherwise, even if Owner has been advised of the possibility of such damage. In the event that any utility service proves defective, or is discontinued or terminated, Owner's and Manager's entire combined liability and Resident's exclusive remedy will be limited to a reimbursement of the approximate cost of that utility incurred by Resident, prorated by the day for each day the utility service proved defective, or was discontinued or terminated, for more than 24 hours. Resident agrees to indemnify, defend and hold harmless Owner and its employees, affiliates and agents, from any and all losses, claims, damages, expenses, other liabilities and causes of action of every nature, including attorney fees, which arise directly or indirectly in connection with: (i) violation by Resident of any laws, ordinances, regulations or rules regarding the utilities; or (ii) illegal or inappropriate use of the utilities. Any damage or loss to any utility devices during Resident's occupancy will be charged to Resident (and the other resident(s) in the apartment, as applicable) at the replacement cost. Management will establish schedules and policies for the use of recreation facilities, amenities and other common spaces. Owner may add, remove, close (temporarily or permanently), upgrade or modify any of the recreation facilities, amenities or common spaces in Owner's discretion, without notice or compensation; provided that if this Agreement expressly includes a separate Amenity Fee, Resident's sole remedy will be limited to a pro-rata credit of such Amenity Fee for the period a covered amenity is closed or fully unavailable. SAMPLE
Ownership and Location of Metering Equipment The Metering Equipment to be constructed, the capability of the Metering Equipment to be constructed, and the ownership thereof, are identified on the attached Schedule C to this ISA.
Heating, Ventilation and Air Conditioning Landlord shall furnish to the Premises heating, ventilation and air-conditioning (“HVAC”) in accordance with the Design Standards set forth in Exhibit D during Ordinary Business Hours. Landlord shall have access to all air-cooling, fan, ventilating and machine rooms and electrical closets and all other mechanical installations of Landlord (collectively, “Mechanical Installations”), and Tenant shall not construct partitions or other obstructions which may interfere with Landlord’s access thereto or the moving of Landlord’s equipment to and from the Mechanical Installations. No Tenant Party shall at any time enter the Mechanical Installations or tamper with, adjust, or otherwise affect such Mechanical Installations. Landlord shall not be responsible if the HVAC System fails to provide cooled or heated air, as the case may be, to the Premises in accordance with the Design Standards by reason of (i) any equipment installed by, for or on behalf of Tenant, which has an electrical load in excess of the average electrical load and human occupancy factors for the HVAC System as designed, or (ii) any rearrangement of partitioning or other Alterations made or performed by, for or on behalf of Tenant. Tenant shall install, if missing, blinds or shades on all windows, which blinds and shades shall be subject to Landlord’s approval, and shall keep operable windows in the Premises closed, and lower the blinds when necessary because of the sun’s position, whenever the HVAC System is in operation or as and when required by any Requirement. Tenant shall cooperate with Landlord and shall abide by the rules and regulations which Landlord may reasonably prescribe for the proper functioning and protection of the HVAC System. Tenant acknowledges that the server room in the Premises currently has three heat pumps installed, being two 4-ton units, and one 2.5-ton unit (the “Existing Heat Pumps”). The 2.5-ton unit is currently connected and operational. Tenant shall determine whether it is satisfied with the condition of the Existing Heat Pumps and Landlord shall not have any responsibility or liability for the condition, operation, maintenance, repair or replacement of the Existing Heat Pumps. Tenant may operate the Existing Heat Pumps. Tenant shall be responsible for, and pay directly for, all necessary maintenance and repairs to the Existing Heat Pumps. Tenant shall reimburse Landlord monthly for the cost of all utility services used to operate the Existing Heat Pumps within 10 Business Days after receipt of Landlord’s invoice for such amount. Landlord may measure Tenant’s usage of such utility services by either a sub-meter or by other reasonable methods such as by temporary check meters or by survey. Tenant, at its cost, may replace the Existing Heat Pumps with one or more new heat pumps, provided, however, that the capacity of such replacement heat pump(s) shall not exceed the 10.5-ton capacity cooling capacity of the Existing Heat Pumps.
Audit of Existing Content and Functionality By September 1, 2017, the Recipient will propose for OCR’s review and approval the identity and bona fides of an Auditor (corporation or individual) to audit all content and functionality on its website, including, but not limited to, the home page, all subordinate pages, and intranet pages and sites, to identify any online content or functionality that is inaccessible to persons with disabilities, including online content and functionality developed by, maintained by, or offered through a third party vendor or an open source. The Auditor will have sufficient knowledge and experience in website accessibility for people with disabilities to carry out all related tasks, including developing a Proposed Corrective Action Plan. The Audit will use the Benchmarks for Measuring Accessibility set out above, unless the Recipient receives prior permission from OCR to use a different standard as a benchmark. During the Audit, the Recipient will also seek input from members of the public with disabilities, including parents, students, employees, and others associated with the Recipient, and other persons knowledgeable about website accessibility, regarding the accessibility of its online content and functionality.
Unbundled Loop Modifications (Line Conditioning 2.5.1 Line Conditioning is defined as routine network modification that BellSouth regularly undertakes to provide xDSL services to its own customers. This may include the removal of any device, from a copper Loop or copper Subloop that may diminish the capability of the Loop or Subloop to deliver high-speed switched wireline telecommunications capability, including xDSL service. Such devices include, load coils, excessive bridged taps, low pass filters, and range extenders. Excessive bridged taps are bridged taps that serves no network design purpose and that are beyond the limits set according to industry standards and/or the BellSouth’s TR 73600 Unbundled Local Loop Technical Specification. 2.5.2 BellSouth will remove load coils only on copper Loops and Subloops that are less than eighteen thousand (18,000) feet in length. 2.5.3 For any copper loop being ordered by NewPhone which has over six thousand (6,000) feet of combined bridged tap will be modified, upon request from NewPhone, so that the loop will have a maximum of six thousand (6,000) feet of bridged tap. This modification will be performed at no additional charge to NewPhone. Loop conditioning orders that require the removal of bridged tap that serves no network design purpose on a copper Loop that will result in a combined total of bridged tap between two thousand five hundred (2,500) and six thousand (6,000) feet will be performed at the rates set forth in Exhibit A. 2.5.4 NewPhone may request removal of any unnecessary and non-excessive bridged tap (bridged tap between zero (0) and two thousand five hundred (2,500) feet which serves no network design purpose), at rates pursuant to BellSouth’s SC Process as mutually agreed to by the Parties. 2.5.5 Rates for ULM are as set forth in Exhibit A. 2.5.6 BellSouth will not modify a Loop in such a way that it no longer meets the technical parameters of the original Loop type (e.g., voice grade, ADSL, etc.) being ordered. 2.5.7 If NewPhone requests ULM on a reserved facility for a new Loop order, BellSouth may perform a pair change and provision a different Loop facility in lieu of the reserved facility with ULM if feasible. The Loop provisioned will meet or exceed specifications of the requested Loop facility as modified. NewPhone will not be charged for ULM if a different Loop is provisioned. For Loops that require a DLR or its equivalent, BellSouth will provide LMU detail of the Loop provisioned. 2.5.8 NewPhone shall request Loop make up information pursuant to this Attachment prior to submitting a service inquiry and/or a LSR for the Loop type that NewPhone desires BellSouth to condition. 2.5.9 When requesting ULM for a Loop that BellSouth has previously provisioned for NewPhone, NewPhone will submit a SI to BellSouth. If a spare Loop facility that meets the Loop modification specifications requested by NewPhone is available at the location for which the ULM was requested, NewPhone will have the option to change the Loop facility to the qualifying spare facility rather than to provide ULM. In the event that BellSouth changes the Loop facility in lieu of providing ULM, NewPhone will not be charged for ULM but will only be charged the service order charges for submitting an order.
Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.
Changes in Equipment, Systems, Etc USBFS reserves the right to make changes from time to time, as it deems advisable, relating to its systems, programs, rules, operating schedules and equipment, so long as such changes do not adversely affect the services provided to the Trust under this Agreement.
Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract. a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract. b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.
Place of Business; Location of Collateral The address set forth in the heading to this Agreement is Borrower's chief executive office. In addition, Borrower has places of business and Collateral is located only at the locations set forth on the Schedule. Borrower will give Silicon at least 30 days prior written notice before opening any additional place of business, changing its chief executive office, or moving any of the Collateral to a location other than Borrower's Address or one of the locations set forth on the Schedule.
