Safety Design Sample Clauses

Safety Design. The Transmission Provider requires clearance of equipment during maintenance, modification, and testing. In accordance with the Transmission Provider’s Standards and Practices, facility interconnections between the Transmission Provider and the Network Customer are to be designed and constructed to allow clearance of equipment using isolation devices. Isolation devices must produce a visible air gap between the energized facilities and the equipment to be maintained, modified, or tested. Any operating procedures associated with this interconnection must comply with OSHA Standard 29 CFR 1910.269(m) and also the ANSI/IEEE National Electric Safety Code as amended or replaced from time to time.
Sample 1Sample 2Sample 3See All (5)
AutoNDA by SimpleDocs
Safety Design. The Transmission Provider requires clearance of equipment during maintenance, modification and testing. Facility interconnections between the Transmission Provider and the Transmission Customer are to be designed and constructed to allow clearance of equipment using isolation devices. Isolation devices must produce a visible air gap between the energized facilities and the equipment to be worked on. Operating procedures associated with this interconnection must comply with the Transmission Provider’s Accident Prevention Manual and also with the Transmission Customer’s safety manual as specified in writing by the Transmission Customer.
Sample 1

Related to Safety Design

  • Safety Data Sheets If specified by City in the solicitation or otherwise required by this Contract, Contractor must send with each shipment one (1) copy of the Safety Data Sheet (SDS) for each item shipped. Failure to comply with this procedure will be cause for immediate termination of the Contract for violation of safety procedures.

  • COVID-19 Protocols Contractor will abide by all applicable COVID-19 protocols set forth in the District’s Reopening and COVID-19 Mitigation Plan and the safety guidelines for COVID-19 prevention established by the California Department of Public Health and the Ventura County Department of Public Health.

  • Safety Plan Developer’s safety plan specifically adapted for the Project. Developer's Safety Plan shall comply with all provisions regarding Project safety, including all applicable provisions in these Construction Provisions.

  • MATERIAL SAFETY DATA SHEETS Contractor is required to ensure Material Safety Data Sheets (“MSDS”) are available, employees are trained in the use of MSDS, and MSDS are in a readily accessible place at the Site. This requirement applies to all materials with an associated MSDS per the federal “Hazard Communication” standard or employees’ Right-to-Know laws. Contractor is also required to ensure proper labeling and training on any substance brought onto the Site and that any person working with the material (or who is subject to possible exposure by use of the material or contact with the material), is informed of the possible and/or real hazards of the substance, and follows proper handling and protection procedures.

  • Material Safety Data Sheet Seller shall provide to Buyer with each delivery any Material Safety Data Sheet applicable to the work in conformance with and containing such information as required by the Occupational Safety and Health Act of 1970 and regulations promulgated thereunder or its State approved counterpart.

  • Safety Devices All Products provided under the Contract shall be equipped with required safety devices to comply with all applicable codes, laws, and regulations that are in effect at the time of delivery.

  • SAFETY & HEALTH The Employer and the IBTCoalition agree that the safety of employees and the general public is of utmost importance. Therefore, the Employer shall provide a safe work environment that is free of recognized hazards that could cause death, injury or illness.

  • Electrical appliance safety The Hirer shall ensure that any electrical appliances brought by them to the premises and used there shall be safe, in good working order, and used in a safe manner in accordance with the Electricity at Work Regulations 1989. Where a residual circuit breaker is provided the hirer must make use of it in the interests of public safety.

  • Product Safety Seller must maintain the state of the product so that it is able to perform to its designed or intended purpose without causing unacceptable risk of harm to a person or damage to property.

  • Development Plan document specifying the work program, schedule, and relevant investments required for the Development and the Production of a Discovery or set of Discoveries of Oil and Gas in the Contract Area, including its abandonment.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!