Switching and Tagging Rules Each Party shall provide the other Parties a copy of its switching and tagging rules that are applicable to the other Parties’ activities. Such switching and tagging rules shall be developed on a non-discriminatory basis. The Parties shall comply with applicable switching and tagging rules, as amended from time to time, in obtaining clearances for work or for switching operations on equipment.
Working and Labor Synergies The Contractor shall be responsible for maintaining a tranquil working relationship between the Contractor work force, the Contractor Parties and their work force, State employees, and any other contractors present at the work site. The Contractor shall quickly resolve all labor disputes which result from the Contractor's or Contractor Parties’ presence at the work site, or other action under their control. Labor disputes shall not be deemed to be sufficient cause to allow the Contractor to make any claim for additional compensation for cost, expenses or any other loss or damage, nor shall those disputes be deemed to be sufficient reason to relieve the Contractor from any of its obligations under the Contract.
Night Shift Employees who are required to work at least five-eighths of their normal daily tour of duty after 4:30 p.m. and before 8:00 a.m. shall be paid at the rate of five percent over and above his/her normal biweekly or hourly rate of pay for the entire shift so worked.
Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.
Daylight Saving Time The changing of Daylight Saving Time to Standard Time, or vice versa, shall not result in Employees being paid more or less than their normal scheduled daily hours. The hour difference shall be split between the Employees completing their shift and those commencing their shift.
Daylight Saving Where by reason of State legislation, summer time is prescribed as being in advance of the standard time in that State the length of any shift: • Commencing before the time prescribed by the relevant legislation for the commencement of a summer time period, and • Commencing on or before the time prescribed by such legislation for the termination of a summer time period, shall be deemed to be the number of hours represented by the difference between the time recorded by the clock at the beginning of the shift and the time so recorded at the end of the shift. The time of the clock in each case is to be set to the time fixed by the relevant State legislation. In this subclause the expressions "standard time" and "summer time" shall bear the same meaning as are prescribed by the relevant State legislation.
Wage Scale The wages shown in Appendix A will be part of this Agreement.
Loading on Annual Leave During a period of annual leave an Employee covered by this clause shall receive a loading of 22.5% calculated on the all-purpose rate of wage prescribed by Appendix A, clause 2.3 of this Agreement.
Hour Shifts When the Employer deems it necessary to implement a twelve (12) hour work day, affected employees shall be notified pursuant to Clause 14.05. The following Clauses shall be replaced or added to the Collective Agreement where appropriate.
Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.
