PREVAILING WAGE RATES - PUBLIC WORKS AND BUILDING SERVICES CONTRACTS If any portion of work being Bid is subject to the prevailing wage rate provisions of the Labor Law, the following shall apply:
Work Performed on District Property Contractor shall comply with the following:
HOURS OF WORK AND SCHEDULING 15.01 The normal hours of work for an employee are not a guarantee of work per day or per week, or a guarantee of days of work per week. The normal hours of work shall be seven and one-half (7-1/2) hours per day, and seventy-five (75) hours in any bi-weekly period. 15.02 The normal daily shift shall consist of seven and one-half (7 ½) consecutive hours, exclusive of a one-half (1/2) hour unpaid meal period. For employees working the night shift, this one-half (1/2) hour will be paid. Employees shall be entitled to a fifteen (15) minute paid break during each half of the normal daily shift, at a time designated by the Employer. An employee may combine her rest periods in order to have one (1) thirty (30) minute break, providing she has prior approval from the Director of Nursing. When a meal period is interrupted requiring an employee to attend to a work related problem, then the balance of the unused meal period will be taken within two (2) hours of the interruption. If the employee is unable to reschedule such time, she shall be paid time and one-half (1½) her regular straight time hourly rate for all time worked in excess of her normal daily hours, in accordance with Article 16.01. 15.03 Employees required for reporting purposes shall remain at work for a period of up to fifteen (15) minutes which shall be unpaid. Should the reporting time extend beyond fifteen (15) minutes however, the entire period shall be considered overtime for the purposes of payment. 15.04 Requests for change in posted work schedules must be submitted in writing and co-signed by the employee willing to exchange days off or shifts and are subject to the discretion of the Administrator or her designate. In any event, it is understood that such a change initiated by the employee and approved by the Employer shall not result in overtime compensation or payment or any other claims on the Employer by any employee under the terms of this Agreement. 15.05 Where there is a change to Daylight Savings from Standard Time or vice-versa, an employee who is scheduled and works a full shift shall be paid for the actual hours worked at her regular straight time hourly rate. 15.06 There shall be no split shifts. (a) There shall be a minimum of sixteen (16) hours off between changes of shift unless mutually agreed otherwise. (b) An employee shall not be required to work more than seven (7) consecutive days without days off, unless mutually agreed to by the employee and the Employer. (a) Any employee who is working a permanent shift as of December 31, 1996 shall not be transferred to another shift without their consent. (b) Where possible, the employee will not be scheduled to work more than two
HOURS OF WORK AND OVERTIME A. The normal work week shall be from Monday to Friday both inclusive and shall comprise five (5) days of eight (8) hours each. B. All hours worked in excess of eight (8) hours in any day shall be paid at the rate of 1 ½ times the regular hourly rate. C. Any work performed on Saturday shall be considered overtime and shall be paid at the rate of 1 ½ times the hourly rate of pay except as provided in “E” or except for the Tuesday/Saturday shift at the high school and middle schools. D. All hours worked on a Sunday, shall be considered overtime, and shall be paid a rate of two (2) times the normal rate of pay, except as provided in “E” below. E. Part-time employees must satisfy the forty (40) hour week require- ment prior to receiving overtime pay for Saturdays or Sundays. F. Employees called to work prior to the start of their normal shift shall be paid overtime for any such time worked, but such overtime pay- ment shall not apply to any of the hours of the normal shift. G. Whenever possible, the Board shall notify the employees of any Sat- urday or Sunday work not later than the end of the shift on Thursday of that week only if such Saturday or Sunday work is scheduled prior to the end of the shift on Thursday of that week, except in cases of emergency. Nothing contained in this paragraph shall be construed to be a guarantee of overtime if such is scheduled nor shall the right of the Board to cancel such scheduled overtime be limited. Employees who are required to work on a Saturday or a Sunday shall be xxxxxx- xxxx a minimum of four hours of work at the overtime rates provided in B and C above. H. Overtime shall be distributed equally as practical by building and/or department among the employees qualified and capable of performing the work available. Individuals declining overtime will be required to sign off acknowledging refusal. During emergencies or when a re- placement is unavailable, working overtime may be mandatory. I. In the event an employee is called back to work after the conclusion of a normal work shift, the employee will be entitled to a minimum of four (4) hours pay at the overtime rate and the Board reserves the right to assign four (4) hours of work in such situations. If the call- back is for an open window or door, the payment shall be two (2) hours at the overtime rate. Failure of an employee to properly secure his/her area of responsibility shall result in disciplinary action. J. Except in case of emergency, or in the event of performance on an assigned job, or during July and August, no seasonal or substitute employees shall perform in excess of forty (40) hours per week the duties of employees in the bargaining unit, nor shall seasonal or sub- stitute employees be hired or retained if regular permanent employees are on a temporary lay-off due to a reduction in force. K. Employees shall be granted no more than a fifteen (15) minute coffee break in the morning. L. When an employee is required to work in excess of ten (10) hours or more, said employee shall be granted a second one-half (1/2) hour lunch period at no loss of pay for such lunch period, and shall be granted an additional one-half (1/2) hour lunch period for each five
GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site. Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer. Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations. Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage. Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer. Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized. Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel. Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations. Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job. Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours. Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement. Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.
Safe Working Conditions The Employer undertakes to maintain office furniture, equipment, etc., in a practical and safe condition in order to avoid injury to employees or damage to their attire. Employees, for their part and in their own interest, are expected to advise the Employer of any such potentially injurious equipment.
Technical Barriers to Trade 1. The Parties or Signatory Parties shall apply technical regulations, standards and conformity assessment procedures in accordance with the provisions of the WTO Agreement on Technical Barriers to Trade. 2. The Parties or Signatory Parties shall cooperate in the fields of technical regulations, standardization and conformity assessment procedures, with the aim of facilitating trade.
Unsafe Working Conditions Employees shall be recognized by the Employer to have the competence to determine what constitutes unsafe working conditions within their discipline. No employee shall be disciplined for refusal to work in a situation which is deemed unsafe beyond the reasonable requirements of the employee's job.
General specifications For the purpose of this Regulation, the vehicle shall fulfil the following requirements:
Design Criteria and Standards All Projects/Services shall be performed in accordance with instructions, criteria and standards set forth by the Director.
