Cold Start definition

Cold Start means the start of an engine only after the engine oil and water temperatures are stabilized between 68 and 86 degrees F for a minimum of 15 minutes.

Split View

AI-Powered Contracts

Draft, Review & Redline at the Speed of AI

Get StartedSchedule a Demo

Cold Start means the period from the test start until the point when the vehicle has run for 5 minutes. If the coolant temperature is determined, the cold start period ends once the coolant is at least 70 °C for the first time but no later than 5 minutes after test start.

Cold Start means an engine coolant temperature (or equivalent temperature) at engine start less than or equal to 35 °C and less than or equal to 7 K higher than ambient temperature (if available) at engine start.

Examples of Cold Start in a sentence

• Full Load For Cold Start: For Warm Start: For Hot Start: Minimum time on-line (hours from start initiation to stop initiation) Minimum time off-line (hours from stop initiation to start initiation) Normal Ramp Rate within operating range: (MW/Min.) Increase: Decrease: Emergency Ramp Rate: (MW/Minute) Increase: _ Decrease: Time to transfer from combined cycle to duct firing min.

• Manufacturer provided Start-Up curves indicating maximum load ramping rates and temperature stabilisation periods for a Hot Start, Warm Start and Cold Start shall be submitted to BPDB by the Company prior to Financial Closing and shall thereon be considered as part of this Schedule 2.

• LD-0.8/10 Cold Start Unit Two-stage cold start compressor unit, belt drive, guard skid with 301 cc gasoline fuel engine.

• Dispatch Ramp Rate *** (note 1) STG Sync to Full Load (Boiler in “Hot” Conditions *** *** (note 1) *** *** (note 1) Cold Start (***) *** STG Synchronization (note 1) Warm Start (***) *** STG Synchronization (note 1) Hot Start (***) *** STG Synchronization (note 1) Note 1: Predicted value from vendor proposal.

• Full Load For Cold Start: For Warm Start: For Hot Start: Minimum time on-line (hours from start initiation to stop initiation) Minimum time off-line (hours from stop initiation to start initiation) Normal Ramp Rate within operating range: (MW/Min.) Increase: Decrease: Emergency Ramp Rate: (MW/Minute) Increase: Decrease: Time to transfer from combined cycle to duct firing min.

More Definitions of Cold Start

Cold Start means an engine coolant temperature (or equivalent temperature) at engine start less than or equal to 35 °C and less than or equal to 7 K higher than ambient temperature (if available) at engine start;

Cold Start means, in the context of the in use performance ratio of OBD monitors, an engine coolant temperature or equivalent temperature at engine start less than or equal to 35 °C and less than or equal to 7 °C higher than ambient temperature, if available.

Cold Start in relation to steam turbine means start up after a shutdown period exceeding 72 hours (turbine metal temperatures below approximately 40% of their full load values).

Cold Start means, in the context of the in use performance ratio of OBD monitors, an engine coolant temperature or equivalent temperature at engine start less than or equal to 35 °C and less than or equal to 7 °C higher than ambient temperature, if available;

Cold Start a start of a Unit in Combined Cycle Mode given that all of the breakers of that Unit's combustion turbine generator have been open for at least the previous [*] hours.

Cold Start. The start-up of a Unit is considered a “Cold Start” if the Facility output to the GPL Grid has been zero (0) MW for more than eight (8) consecutive hours prior to this start up.

Cold Start means recommencement of supply of Specification Gas through Sellers’ Facilities after the Sellers’ Facilities did not supply Specification Gas to any purchasers for a period of at least one (1) Hour which resulted in a shut-down of the Sellers’ Facilities.