Physical Layout. At both Xxxxx and Green Haven, programs will be provided in a classroom with 6 restart chairs.
Physical Layout. (a) Program housing will be provided in 50 cells, consisting of 25 single cells and 25 double cells.
(b) Three classrooms, each with 8 restart chairs, will be constructed in the basement, and two classrooms, each with 10 restart chairs, will be constructed on the second floor.
(c) A semi-private area with separate seating will be provided for individual meetings with staff.
(d) One of the basement classrooms will be used for orientation and assessment of inmates newly admitted to the program. Upstairs classrooms will also be available for earned evening congregate leisure activities (e.g., movies, card games).
Physical Layout. (a) Participating inmates will be housed in 88 single cells in four galleries, with the remaining 12 cells of the former S-Block repurposed to provide three dedicated phone booths in each gallery.
(b) Three classrooms, each with 8 restart chairs, will be constructed in the facility basement, and two classrooms, each with 10 restart chairs, will be constructed on the second floor.
(c) A semi-private area will be provided with separate seating for individual meetings with staff.
(d) One of the basement classrooms will be used for orientation and assessment of inmates newly admitted to the program.
(e) Upstairs classrooms will also be available for earned evening congregate leisure activities (movies, card games, etc.).
Physical Layout. Participating inmates will be housed in 252 cells on three floors, each floor consisting of four 21-cell housing galleries and five classrooms. Orientation and program phases will be situated as follows:
(a) Orientation (63 beds): Housing Block C, 1st Floor
(b) Phase 1 (21 beds): Housing Block C, 1st Floor
(c) Phase 2 (84 beds): Housing Block C, 2nd Floor
(d) Phase 3 (84 beds): Housing Block C, 3rd Floor
Physical Layout. The design will be routed using Samsung layout software. Layout statistics shall be extracted to facilitate post layout simulations. [***] 11 Power simulation & IR drop analysis [***] 12 Post Layout Design Verification: Perform best, worst, and nominal case functional and performance simulations in supported simulator and compare to pre-layout simulations, adjusting design if necessary. Any functional differences at the test strobe points shall be identified to GCT. Layout data shall be provided to GCT for documentation purposes, and back-annotated simulations. [***] 13 Review post layout simulations and sign-off, also test vector hand-off for manufacturing. [***] 14 Prototype Manufacturing: The design shall be released to manufacturing and test program development. Manufacturing will include wafer processing and probe test. [***] 15 Process Characterization Data prior to Design Start [***] 16 Estimated Gross and Net DPW prior to Design Start [***] Exhibit D. Financial Terms and Other Special Terms
