Amount of Funds; Application of Funds Lender may, at any time, collect and hold Funds in an amount up to, but not in excess of, the maximum amount a lender can require under RESPA. Lender will estimate the amount of Funds due in accordance with Applicable Law. The Funds will be held in an institution whose deposits are insured by a U.S. federal agency, instrumentality, or entity (including Lender, if Lender is an institution whose deposits are so insured) or in any Federal Home Loan Bank. Lender will apply the Funds to pay the Escrow Items no later than the time specified under RESPA. Lender may not charge Borrower for: (i) holding and applying the Funds; (ii) annually analyzing the escrow account; or (iii) verifying the Escrow Items, unless Lender pays Borrower interest on the Funds and Applicable Law permits Lender to make such a charge. Unless Lender and Borrower agree in writing or Applicable Law requires interest to be paid on the Funds, Lender will not be required to pay Borrower any interest or earnings on the Funds. Lender will give to Borrower, without charge, an annual accounting of the Funds as required by RESPA.
Certification of the Settlement Class For purposes of this Settlement only, the Parties stipulate to the certification of the Settlement Class, which is contingent upon the Court entering the Final Approval Order and Judgment of this Settlement and the occurrence of the Effective Date.
AS9100 Certification AS9100 Certification, specifies requirements for a quality management system to demonstrate the Contractor’s ability to consistently meet the customer requirements as well as statutory and regulatory requirements for the aerospace industry. An AS9100 Certification, is not mandatory; however, Contractors who desire to compete for work within the aerospace industry are encouraged to have AS9100 Certification, during the entire term of OASIS. The Contractor shall notify the OASIS CO, in writing, if there are any changes in the status of their AS9100 Certification, and provide the reasons for the change and copies of audits from an AS9100 Certification Body, as applicable. If only part of a Contractor’s organization is AS9100, certified, the Contractor shall make the distinction between which business units or sites and geographic locations have been certified.
Instructions for Certification 1. By signing and submitting this CONTRACT, the prospective lower tier participant is providing the certification set out below.
Class Certification Solely for the purposes of this Settlement, the Parties stipulate and agree to certification of the claims asserted on behalf of Class Members. As such, the Parties stipulate and agree that in order for this Settlement to occur, the Court must certify the Class as defined in this Agreement.
Special Certification The individual or officer signing this agreement certifies by his or her signature that he or she is authorized to sign this agreement on behalf of the responsible governing board, official or Grantee.
E-VERIFY CERTIFICATION Pursuant to Executive Order RP-80, Engineer certifies and ensures that for all contracts for services, Engineer shall, to the extent permitted by law, utilize the United States Department of Homeland Security’s E-Verify system during the term of this agreement to determine the eligibility of:
Certification of Applicants The Employer will determine the number of applicants to be certified to the hiring official for consideration. All employees on the internal layoff list for the classification, and all promotional, transfer and voluntary demotion candidates, who have the skills and abilities to perform the duties of the position will be certified and will be considered by the Employer, prior to consideration of other candidates.
Certification of Contractor The Contractor shall certify, over his own signature, that the Work provided for by the Contract Documents has been completed under the terms and conditions thereof, and that the entire balance of the contract is due and payable.
Exhibit D - Debarment Certification By signing and submitting this Contract, the Contractor is agreeing to abide by the debarment requirements as set out below. • The certification in this clause is a material representation of fact relied upon by County. • The Contractor shall provide immediate written notice to County if at any time the Contractor learns that its certification was erroneous or has become erroneous by reason of changed circumstances. • Contractor certifies that none of its principals, affiliates, agents, representatives or contractors are excluded, disqualified or ineligible for the award of contracts by any Federal agency and Contractor further certifies to the best of its knowledge and belief, that it and its principals: • Are not presently debarred, suspended, proposed for debarment, declared ineligible, or voluntarily excluded by any Federal Department or Agency; • Have not been convicted within the preceding three-years of any of the offenses listed in 2 CFR 180.800(a) or had a civil judgment rendered against it for one of those offenses within that time period; • Are not presently indicted for or otherwise criminally or civilly charged by a governmental entity (Federal, State, or Local) with commission of any of the offenses listed in 2 CFR 180.800(a); • Have not had one or more public transactions (Federal, State, or Local) terminated within the preceding three-years for cause or default. • The Contractor agrees by signing this Contract that it will not knowingly enter into any subcontract or covered transaction with a person who is proposed for debarment, debarred, suspended, declared ineligible, or voluntarily excluded from participation in this covered transaction. • Any subcontractor will provide a debarment certification that includes the debarment clause as noted in preceding bullets above, without modification.
