BioRID II UN Reference measurement. 3.1.6.1. Using the 3D-H measuring machine, check that the H-point coincides with the R50 point, in accordance with the following requirements. The procedure set out in Annex 3 shall be used to verify the H-point relationship to the R50 point specified by the manufacturer. The relative positions of the R-point and the H-point relationship shall be considered satisfactory for the seating position in question if the actual "H"-point, lies within a square of 50 mm side length with horizontal and vertical sides F whose diagonals intersect at the R50 point, and the actual torso angle is within 5° of the design torso angle. 3.1.6.2. Back of the head reference position The back of the head reference position for the UN BioRID II is the value for the back of the head as determined for the 50th percentile in Table 10-1 of Annex 10 of this Regulation with reference to the specified torso angle minus 15 mm (increasing the backset as shown in figure 14-2 below).
Appears in 3 contracts
Samples: Agreement Concerning the Adoption of Harmonized Technical United Nations Regulations, Agreement Concerning the Adoption of Harmonized Technical United Nations Regulations for Wheeled Vehicles, Agreement Concerning the Adoption of Harmonized Technical United Nations Regulations for Wheeled Vehicles
BioRID II UN Reference measurement. 3.1.6.1. Using the 3D-H measuring machine, check that the H-point coincides with the R50 point, in accordance with the following requirements. The procedure set out in Annex 3 shall be used to verify the H-point relationship to the R50 point specified by the manufacturer. The relative positions of the R-point and the H-point relationship shall be considered satisfactory for the seating position in question if the actual "H"-pointH"- point, lies within a square of 50 mm side length with horizontal and vertical sides F whose diagonals intersect at the R50 point, and the actual torso angle is within 5° of the design torso angle.
3.1.6.2. Back of the head reference position The back of the head reference position for the UN BioRID II is the value for the back of the head as determined for the 50th percentile in Table 10-1 of Annex 10 of this Regulation with reference to the specified torso angle minus 15 mm (increasing the backset as shown in figure 14-2 below).. Where no design torso angle is specified, set the angle as specified in paragraph
Appears in 2 contracts
Samples: Agreement Concerning the Adoption of Harmonized Technical United Nations Regulations for Wheeled Vehicles, Agreement Concerning the Adoption of Harmonized Technical United Nations Regulations for Wheeled Vehicles
