Cable Management Clause Samples
Cable Management cables should be installed to the patch panel at the hinged end so that the articulation of the panel doesn’t stress the terminations - vertical cable trough on both sides of rack - horizontal cable troughs between patch panels - cable ladder assembly above rack for cable into closet to patch panels - “B” connection terminated at each end (▇▇▇▇ ▇▇▇▇ & comm closet, where applicable) IAW TIA/EIA standards
3.26. CONTRACTOR PERSONNEL SECURITY REQUIREMENTS:
Cable Management. Each console has integrated cable management providing continuous horizontal and vertical cable management allowing logical, discrete routing, and splitting of power and data cables throughout the entire console without obstruction. Adaptaspace’s open frame design allows power and data to be routed from the floor into the console interior. 4” wide by 1” deep horizontal sheet metal cable trays allow for wires to enter/exit at any point along the length of the tray with no need for fishing of cables and provide separation between AC power distribution and data/audio network cabling. Vertical cable management chains are provided on all consoles with height adjustable work surfaces that extend and retract with the up/down movement of the sit/stand work surface and protect the cables from entanglement and pinching. Grommets are provided on the rear of the work surfaces to route desktop cables to the underside of the work surfaces. Cables are then routed into the vertical cable management chains and brought down into the horizontal cable trays located in the console modules.
Cable Management. If applicable, tabletops shall offer cable management and capabilities shall be thoroughly described.