Correctness Problem Sample Clauses

Correctness Problem. In the formation phase, a vehicle vi sends only {RIDi, Xi}. Thus, TA cannot know information si. However, in Xxxxxxxxx et al.’s protocol, TA computes Pprii using si. Therefore, Xxxxxxxxx et al.’s protocol has a correctness problem and it may derive the incorrect formation of vi.
AutoNDA by SimpleDocs

Related to Correctness Problem

  • Corrections to Factual Inaccuracies In the event that the LEA determines that the Provider is maintaining Student Data that contains a factual inaccuracy, and Provider cooperation is required in order to make a correction, the LEA shall notify the Provider of the factual inaccuracy and the correction to be made. No later than 90 calendar days after receiving the notice of the factual inaccuracy, the Provider shall correct the factual inaccuracy and shall provide written confirmation of the correction to the LEA.

  • Problems To endeavour to resolve in a fair and just manner any problems, grievances or difficulties which may be encountered while you volunteer with us;

  • FACTS The Superintendent is the official charged with administering and enforcing Maine’s insurance laws and regulations.

  • Problem Statement School bus fleets are aging, and our communities have poor air quality. Replacing school buses with zero emission school buses will address both of these issues.

  • Latent Defects Notwithstanding anything to the contrary set forth herein, no acceptance, or deemed acceptance, by City pursuant to this Section shall be applicable with respect to any Latent Defects. An acceptance, or deemed acceptance, by City pursuant to this Section shall not mean that City has accepted, or the other party has been relieved of, responsibility for: (i) compliance with the Laws; (ii) the proper application of construction means or methods; or (iii) correcting any portion of the Project if it later is determined that any portion of the Project is inconsistent with the Final Documents and Drawings.

  • Correction of Defects 35.1 The Engineer shall give notice to the Contractor of any Defects before the end of the Defects Liability Period, which begins at Completion and is defined in the Contract Data. The Defects Liability Period shall be extended for as long as Defects remain to be corrected. 35.2 Every time notice of a Defect is given, the Contractor shall correct the notified Defect within the length of time specified by the Engineer’s notice.

  • Adverse Weather Shall be only weather that satisfies all of the following conditions: (1) unusually severe precipitation, sleet, snow, hail, or extreme temperature or air conditions in excess of the norm for the location and time of year it occurred based on the closest weather station data averaged over the past five years, (2) that is unanticipated and would cause unsafe work conditions and/or is unsuitable for scheduled work that should not be performed during inclement weather (i.e., exterior finishes), and (3) at the Project.

  • CONTRACTOR’S REPRESENTATIONS A. In order to induce Owner to enter into this Contract, Contractor makes the following representations: 1. Contractor has examined and carefully studied the Contract Documents, including Addenda. 2. Contractor has visited the Site, conducted a thorough visual examination of the Site and adjacent areas, and become familiar with the general, local, and Site conditions that may affect cost, progress, and performance of the Work. 3. Contractor is familiar with all Laws and Regulations that may affect cost, progress, and performance of the Work. 4. Contractor has carefully studied the reports of explorations and tests of subsurface conditions at or adjacent to the Site and the drawings of physical conditions relating to existing surface or subsurface structures at the Site that have been identified in the Supplementary Conditions, with respect to the Technical Data in such reports and drawings. 5. Contractor has carefully studied the reports and drawings relating to Hazardous Environmental Conditions, if any, at or adjacent to the Site that have been identified in the Supplementary Conditions, with respect to Technical Data in such reports and drawings. 6. Contractor has considered the information known to Contractor itself; information commonly known to contractors doing business in the locality of the Site; information and observations obtained from visits to the Site; the Contract Documents; and the Technical Data identified in the Supplementary Conditions or by definition, with respect to the effect of such information, observations, and Technical Data on (a) the cost, progress, and performance of the Work; (b) the means, methods, techniques, sequences, and procedures of construction to be employed by Contractor; and (c) Contractor’s safety precautions and programs. 7. Based on the information and observations referred to in the preceding paragraph, Contractor agrees that no further examinations, investigations, explorations, tests, studies, or data are necessary for the performance of the Work at the Contract Price, within the Contract Times, and in accordance with the other terms and conditions of the Contract. 8. Contractor is aware of the general nature of work to be performed by Owner and others at the Site that relates to the Work as indicated in the Contract Documents. 9. Contractor has given Engineer written notice of all conflicts, errors, ambiguities, or discrepancies that Contractor has discovered in the Contract Documents, and of discrepancies between Site conditions and the Contract Documents, and the written resolution thereof by Engineer is acceptable to Contractor. 10. The Contract Documents are generally sufficient to indicate and convey understanding of all terms and conditions for performance and furnishing of the Work. 11. Contractor’s entry into this Contract constitutes an incontrovertible representation by Contractor that without exception all prices in the Agreement are premised upon performing and furnishing the Work required by the Contract Documents.

  • Material Facts Metropolitan represents and warrants to Welco that at the time the Registration Statement and, at the time the Prospectus is filed with the Commission (including any preliminary prospectus and the form of prospectus filed with the Commission pursuant to Rule 424(b)) and at all times subsequent thereto, to and including the date on which payment for, and delivery of, the Preferred Stock to be sold in the Offering is made by the underwriter or underwriters, as the case may be, participating in the Offering and by Metropolitan (such date being referred to herein as the "Closing Date"), the Prospectus (as amended or supplemented if it shall have been so amended or supplemented) will contain all material statements which are required to be stated therein in accordance with the Act and will conform to all other requirements of the federal securities laws, and will not, on such date include any untrue statement of a material fact or omit to state a material fact required to be stated therein or necessary to make the statements therein not misleading and that all contracts and documents required by the Act to be filed or required as exhibits to said registration statement have been filed. Metropolitan further represents and warrants that any further filing, report, document, release or communication which in any way refers to Welco or to the services to be performed by Welco pursuant to this Agreement will not contain any untrue or misleading statement of a material fact or omit to state a material fact required to be stated therein or necessary to make the statements therein not misleading. Metropolitan further warrants and represents that: (a) All leases, contracts and agreements referred to in or filed as exhibits to the Registration Statement to which Metropolitan or its subsidiaries is a party or by which any of them is bound are in full force and effect.

  • Accuracy of Specified Information All applicable information that is furnished in writing by or on behalf of it to the other party and is identified for the purpose of this Section 3(d) in the Schedule is, as of the date of the information, true, accurate and complete in every material respect.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!