Liquidity Risk Measurement Services Not Applicable.
Builder’s Risk Insurance Contractor shall provide a Builder’s Risk Policy to be made payable to the Owner and Contractor, as their interests may appear. The policy amount should be equal to 100% of the Contract Sum, written on a Builder’s Risk “All Risk”, or its equivalent. The policy shall be endorsed as follows: The following may occur without diminishing, changing, altering or otherwise affecting the coverage and protection afforded the insured under this policy: (i) Furniture and equipment may be delivered to the insured premises and installed in place ready for use; and (ii) Partial or complete occupancy by Owner; and (iii) Performance of work in connection with construction operations insured by the Owner, by agents or lessees or other Contractors of the Owner or Using Agency In the event that the Contract is for renovation, addition or modification of an existing structure and Builders Risk Insurance is not available, the Owner will accept an Installation Floater Insurance Policy with the above endorsements in lieu of the Builders' Risk Insurance Policy. Such floater must insure loss to materials and equipment prior to acceptance by Owner and must be on an ALL RISK BASIS with the policy written on a specific job site.
Country Risk Country Risk shall mean, with respect to the acquisition, ownership, settlement or custody of Investments in a jurisdiction, all risks relating to, or arising in consequence of, systemic and markets factors affecting the acquisition, payment for or ownership of Investments including (a) the prevalence of crime and corruption, (b) the inaccuracy or unreliability of business and financial information, (c) the instability or volatility of banking and financial systems, or the absence or inadequacy of an infrastructure to support such systems, (d) custody and settlement infrastructure of the market in which such Investments are transacted and held, (e) the acts, omissions and operation of any Securities Depository, (f) the risk of the bankruptcy or insolvency of banking agents, counterparties to cash and securities transactions, registrars or transfer agents, and (g) the existence of market conditions which prevent the orderly execution or settlement of transactions or which affect the value of assets.
Food Service Waste Reduction Requirements Contractor shall comply with the Food Service Waste Reduction Ordinance, as set forth in San Francisco Environment Code Chapter 16, including but not limited to the remedies for noncompliance provided therein.
Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.
Builder’s Risk additional provisions The insurance specified shall be maintained in force until final acceptance of the project by the State. (5) Umbrella Excess Liability Policies may be used in conjunction with primary policies to comply with any of the limit requirements specified above. (6) Claims-made" coverage forms are not acceptable without the express written prior consent of the State. Each policy furnished shall contain a rider or non-cancellation clause reading in substance as follows: Anything herein to the contrary notwithstanding, notice of any cancellation, termination or alteration to the insurance contracts must be delivered by registered mail to the Commissioner, Department of Buildings and General Services, State of Vermont, Montpelier, Vermont, at least 60 days before effective cancellation, termination or alteration date unless all work required to be performed under the terms of the Contract is satisfactorily completed as evidenced by the formal acceptance by the State of Vermont. (7) No warranty is made that the coverages and limits listed herein are adequate to cover and protect the interests of the Contractor for the Contractor’s operations. These are solely minimums that have been set to protect the interests of the State. 11.3 The State shall have power to adjust and settle any loss with the insurers.
Master Servicer Fidelity Bond and Master Servicer Errors and Omissions Insurance Policy (a) The Master Servicer, at its expense, shall maintain in effect a Fidelity Bond and an Errors and Omissions Insurance Policy, affording coverage with respect to all directors, officers, employees and other Persons acting on such Master Servicer’s behalf, and covering errors and omissions in the performance of the Master Servicer’s obligations hereunder. The Errors and Omissions Insurance Policy and the Fidelity Bond shall be in such form and amount that would meet the requirements of FNMA or FHLMC if it were the purchaser of the Mortgage Loans. The Master Servicer shall (i) require each Servicer to maintain an Errors and Omissions Insurance Policy and a Fidelity Bond in accordance with the provisions of the applicable Servicing Agreement, (ii) cause each Servicer to provide to the Master Servicer certificates evidencing that such policy and bond is in effect and to furnish to the Master Servicer any notice of cancellation, non-renewal or modification of the policy or bond received by it, as and to the extent provided in the applicable Servicing Agreement, and (iii) furnish copies of the certificates and notices referred to in clause (ii) to the Trustee upon its request. The Fidelity Bond and Errors and Omissions Insurance Policy may be obtained and maintained in blanket form. (b) The Master Servicer shall promptly report to the Trustee any material changes that may occur in the Master Servicer Fidelity Bond or the Master Servicer Errors and Omissions Insurance Policy and shall furnish to the Trustee, on request, certificates evidencing that such bond and insurance policy are in full force and effect. The Master Servicer shall promptly report to the Trustee all cases of embezzlement or fraud, if such events involve funds relating to the Mortgage Loans. The total losses, regardless of whether claims are filed with the applicable insurer or surety, shall be disclosed in such reports together with the amount of such losses covered by insurance. If a bond or insurance claim report is filed with any of such bonding companies or insurers, the Master Servicer shall promptly furnish a copy of such report to the Trustee. Any amounts relating to the Mortgage Loans collected by the Master Servicer under any such bond or policy shall be promptly remitted by the Master Servicer to the Trustee for deposit into the Certificate Account. Any amounts relating to the Mortgage Loans collected by any Servicer under any such bond or policy shall be remitted to the Master Servicer to the extent provided in the applicable Servicing Agreement.
Regulation RR Risk Retention Ford Credit, as Sponsor, and the Depositor agree that (i) Ford Credit will cause the Depositor to, and the Depositor will, retain the Residual Interest on the Closing Date and (ii) Ford Credit will not permit the Depositor to, and the Depositor will not, sell, transfer, finance or hedge the Residual Interest except as permitted by Regulation RR.
Name Collision Occurrence Assessment 6.2.1 Registry Operator shall not activate any names in the DNS zone for the Registry TLD except in compliance with a Name Collision Occurrence Assessment provided by ICANN regarding the Registry TLD. Registry Operator will either (A) implement the mitigation measures described in its Name Collision Occurrence Assessment before activating any second-‐level domain name, or (B) block those second-‐level domain names for which the mitigation measures as described in the Name Collision Occurrence Assessment have not been implemented and proceed with activating names that are not listed in the Assessment. 6.2.2 Notwithstanding subsection 6.2.1, Registry Operator may proceed with activation of names in the DNS zone without implementation of the measures set forth in Section 6.2.1 only if (A) ICANN determines that the Registry TLD is eligible for this alternative path to activation of names; and (B) Registry Operator blocks all second-‐level domain names identified by ICANN and set forth at <xxxx://xxxxxxxx.xxxxx.xxx/en/announcements-‐and-‐ media/announcement-‐2-‐17nov13-‐en> as such list may be modified by ICANN from time to time. Registry Operator may activate names pursuant to this subsection and later activate names pursuant to subsection 6.2.1. 6.2.3 The sets of names subject to mitigation or blocking pursuant to Sections 6.2.1 and 6.2.2 will be based on ICANN analysis of DNS information including "Day in the Life of the Internet" data maintained by the DNS Operations, Analysis, and Research Center (DNS-‐OARC) <xxxxx://xxx.xxx-‐xxxx.xxx/xxxx/xxxx/xxxx>. 6.2.4 Registry Operator may participate in the development by the ICANN community of a process for determining whether and how these blocked names may be released. 6.2.5 If ICANN determines that the TLD is ineligible for the alternative path to activation of names, ICANN may elect not to delegate the TLD pending completion of the final Name Collision Occurrence Assessment for the TLD, and Registry Operator’s completion of all required mitigation measures. Registry Operator understands that the mitigation measures required by ICANN as a condition to activation of names in the DNS zone for the TLD may include, without limitation, mitigation measures such as those described in Section 3.2 of the New gTLD Name Collision Occurrence Management Plan approved by the ICANN Board New gTLD Program Committee (NGPC) on 7 October 2013 as found at <xxxx://xxx.xxxxx.xxx/en/groups/board/documents/resolutions-‐ new-‐gtld-‐annex-‐1-‐07oct13-‐en.pdf>.
Periodic Risk Assessment Provider further acknowledges and agrees to conduct periodic risk assessments and remediate any identified security and privacy vulnerabilities in a timely manner.
