Typical Sections The Engineer shall prepare typical sections for all proposed and existing roadways and structures. Typical sections must include width of travel lanes, shoulders, outer separations, border widths, curb offsets, managed lanes, and ROW. The typical section must also include Proposed Profile Gradeline (PGL), centerline, pavement design, longitudinal joints, side slopes, sodding or seeding limits, concrete traffic barriers and sidewalks, if required, station limits, common proposed and existing structures including retaining walls, existing pavement removal, riprap, limits of embankment and excavation, etc.
The following sections of Section 4 OGS Centralized Contract Terms and Conditions have been renumbered as depicted in the following chart: Current Amended Section Title 4.25 4.26 Severability 4.26 4.27 Entire Agreement
GEOGRAPHIC AREA AND SECTOR SPECIFIC ALLOWANCES, CONDITIONS AND EXCEPTIONS The following allowances and conditions shall apply where relevant: Where the company does work which falls under the following headings, the company agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.
DISCLAIMERS; EXCLUSIONS; LIMITATIONS Subject to §4, neither party makes any warranties (express, implied, or otherwise), including implied warranties of merchantability, non-infringement, fitness for a particular purpose, or title, related to its performance or anything else provided under this Agreement. Neither party will be liable for any special, incidental, punitive, or consequential damages of any kind for any reason whatsoever relating to this Agreement, even if such damages were reasonably foreseeable.
Tax Law Section 5-A Section 5-a of the Tax Law, requires certain Contractors awarded State Contracts for commodities, services and technology valued at more than $100,000 to certify to the NYS Department of Taxation and Finance (DTF) that they are registered to collect New York State and local sales and compensating use taxes. The law applies to Contracts where the total amount of such Contractors’ sales delivered into New York State are in excess of $300,000 for the four quarterly periods immediately preceding the quarterly period in which the certification is made, and with respect to any affiliates and subcontractors whose sales delivered into New York State exceeded $300,000 for the four quarterly periods immediately preceding the quarterly period in which the certification is made. A Vendor is required to file the completed and notarized Form ST-220-CA with OGS certifying that the Vendor filed the ST-220-TD with the NYS Department of Taxation and Finance (DTF). Please note that the NYS Department of Taxation and Finance should receive the completed Form ST-220-TD, not OGS. OGS should only receive the Form ST-220-CA. Proposed Contractors should complete and return the certification forms within five (5) business days of request (if the forms are not completed and returned with Vendor Submission). Failure to make either of these filings may render a Vendor non- responsive and non-responsible. Each Vendor shall take the necessary steps to provide properly certified forms within a timely manner to ensure compliance with the law. Website links to the Contractor certification forms and instructions are provided below. Form No. ST- 220-TD must be filed with and returned directly to DTF and can be found at xxxx://xxx.xxx.xx.xxx/pdf/current_forms/st/st220td_fill_in.pdf. Unless the information upon which the ST-220-TD is based changes, this form only needs to be filed once with DTF. If the information changes for the Contractor, its affiliate(s), or its subcontractor(s), a new Form No. ST-220-TD must be filed with DTF. Form ST-220-CA must be submitted to OGS. This form provides the required certification that the Contractor filed the ST-220-TD with DTF. This form can be found at xxxx://xxx.xxx.xx.xxx/pdf/current_forms/st/st220ca_fill_in.pdf. Vendors may call DTF at 000-000-0000 for any and all questions relating to §5-a of the Tax Law and relating to a company's registration status with the DTF. For additional information and frequently asked questions, please refer to the DTF web site: xxxx://xxx.xxx.xx.xxx.
Without prejudice to Sections 5.1 and 5.2 above, You are responsible for (a) any required notices, consents and/or authorizations related to Your provision of, and our processing of, Your Content (including any Personal Data) as part of the Services, (b) any security vulnerabilities, and the consequences of such vulnerabilities, arising from Your Content, including any viruses, Trojan horses, worms or other harmful programming routines contained in Your Content, and (c) any use by You or Your Users of the Services in a manner that is inconsistent with the terms of this Agreement. To the extent You disclose or transmit Your Content to a third party, we are no longer responsible for the security, integrity or confidentiality of such content outside of Oracle’s control.
Modification to Article V, Section 4 of the DPA Article V, Section 4 of the DPA (Data Breach.) is amended with the following additions: (6) For purposes of defining an unauthorized disclosure or security breach, this definition specifically includes meanings assigned by Texas law, including applicable provisions in the Texas Education Code and Texas Business and Commerce Code.
Reciprocal Compensation Arrangements Pursuant to Section 251(b (5) of the Act
Limitations and exclusions of liability 16.1 Nothing in this Agreement will:
Provisions Applicable to Certain Agreements The provisions in this section are applicable only to the types of orders specified in the first sentence of each subsection. If this Agreement is not of the type described in the first sentence of a subsection, then that subsection does not apply to the Agreement.
