Integration The Company shall not sell, offer for sale or solicit offers to buy or otherwise negotiate in respect of any security (as defined in Section 2 of the Securities Act) that would be integrated with the offer or sale of the Securities in a manner that would require the registration under the Securities Act of the sale of the Securities or that would be integrated with the offer or sale of the Securities for purposes of the rules and regulations of any Trading Market such that it would require shareholder approval prior to the closing of such other transaction unless shareholder approval is obtained before the closing of such subsequent transaction.
Configuration The configuration for the Purchase Right Aircraft will be the Detail Specification for Model 767-3S2F aircraft at the revision level in effect at the time of the Supplemental Agreement. Such Detail Specification will be revised to include (i) changes required to obtain required regulatory certificates and (ii) other changes as mutually agreed upon by Boeing and Customer.
AIRCRAFT CONFIGURATION The guarantees defined in Paragraphs 2 and 3 below (the “Guarantees”) are applicable to the A321 Aircraft as described in the A321 Standard Specification ***** as amended by the following SCNs:
Integration; Modification This Agreement constitutes the entire understanding and agreement between the Company and the Executive regarding its subject matter and supersedes all prior negotiations and agreements, whether oral or written, between them with respect to its subject matter. This Agreement may not be modified except by a written agreement signed by the Executive and a duly authorized officer of the Company.
Integration Clause Except for documents and instruments specifically referenced herein, this Agreement constitutes the entire agreement between Bank and Borrower regarding the Loan and all prior communications verbal or written between Borrower and Bank shall be of no further effect or evidentiary value.
SERVICE XXXX USE A. Controlled Affiliate recognizes the importance of a comprehensive national network of independent BCBSA licensees which are committed to strengthening the Licensed Marks and Name. The Controlled Affiliate further recognizes that its actions within its Service Area may affect the value of the Licensed Marks and Name nationwide.
Product Changes IDSI reserves the right to make design and other modifications in the Equipment at any time but shall not be obligated to implement such modifications in Equipment that has previously been delivered.
Assistance with Valuation The Sub-Adviser will provide reasonable assistance to the Adviser and the Custodian, Administrator or similar party designated by the Adviser in assessing the fair value of securities or other instruments held in the Allocated Portion for which market quotations are not readily available or for which the Adviser or the Board has otherwise determined to fair value such portfolio holdings.
Installation Tenant may install and use Tenant's Lines and make connections and disconnections at the terminal blocks as described above, provided Tenant shall: (i) obtain Landlord's prior written approval of all aspects thereof, (ii) use an experienced and qualified contractor designated or approved in writing in advance by Landlord (whom Landlord may require to enter an access and indemnity agreement on Landlord's then standard form of agreement therefor), (iii) comply with such inside wire standards as Landlord may adopt from time to time, and all other provisions of this Lease, including Paragraph 8 respecting alterations, and the Building rules respecting access to the wire closets, (iv) not install Lines in the same sleeve, chaseway or other enclosure in close proximity with electrical wire, and not install PVC-coated Lines under any circumstances, (v) thoroughly test any riser Lines to which Tenant intends to connect any Lines to ensure that such riser Lines are available and are not then connected to or used for telephone, data transmission or any other purpose by any other party (whether or not Landlord has previously approved such connections), and not connect to any such unavailable or connected riser Lines, and (vi) not connect any equipment to the Lines which may create an electromagnetic field exceeding the normal insulation ratings of ordinary twisted pair riser cable or cause radiation higher than normal background radiation, unless the Lines therefor (including riser Lines) are appropriately insulated to prevent such excessive electromagnetic fields or radiation (and such insulation shall not be provided by the use of additional unused twisted pair Lines). As a condition to permitting installation of new Lines, Landlord may require that Tenant remove any existing Lines located in or serving the Premises.
Maintenance and Support Services Distributor shall provide Maintenance and Support Services to all of its Customers of Licensed Software as set forth in Sections 3.4(a) and 3.4(b) below. Distributor may require Customers to provide the own First-Line Support: however, in no event shall Siebel be responsible for First-Line or Second-Line Support. Subject to Distributor's payment of the Maintenance Fees set forth in EXHIBIT A Siebel shall provide Third-Line Support to Distributor in accordance with Siebel's then current Maintenance and Support Services Policy. Distributor shall be responsible for all support related to the Value Added Offering.
