Loads and Loading Combinations Sample Clauses

Loads and Loading Combinations. Climatic loads for the design of plant building and other associated structures will conform to the local codes as well as industry codes and standards. Analysis of all structures will be performed to predict the structural responses to normal loads. Floors will be designed for minimum live loads as given in the ASCE 7-95. However, in certain cases these loads may be greater, depending on the final layout. In such cases these floors will be designed for the larger loads. The loads and applicable load combinations for which each structure will be designed will depend on the conditions to which that particular structure may be subjected. The loads normally applicable or most likely to be encountered during normal station operation include: 1.3.2.1 Loads D = Dead loads or their related moments and forces, including any permanent equipment loads and hydrostatic loads. L = Live loads or their related internal moments and forces, including any moveable equipment loads and other loads that vary with intensity and occurrence produced by the intended use or occupancy, but in no case less than minimum uniformly distributed unit loads specified in the ASCE 7-95. W, E = Wind & seismic will be in accordance with the ASCE 7-95. T = Loads, forces, and effects due to contraction or expansion resulting from temperature changes, shrinkage, moisture changes, creep in component materials, movement due to differential settlement, or combination thereof. -------------------------------------------------------------------------------- Proprietary Information Page 4 AES IRONWOOD CONTRACT FINAL ISSUE - OCTOBER 30, 1998 --------------------------------------------------------------------------------
AutoNDA by SimpleDocs

Related to Loads and Loading Combinations

  • Keys and Locks Landlord will furnish Tenant, free of charge, two keys to each door or lock in the Premises. Landlord may make a reasonable charge for any additional or replacement keys. Tenant will not duplicate any keys, alter any locks or install any new or additional lock or bolt on any door of its Premises or on any other part of the Building without the prior written consent of Landlord and, in any event, Tenant will provide Landlord with a key for any such lock. On the termination of the Lease, Tenant will deliver to Landlord all keys to any locks or doors in the Building which have been obtained by Tenant.

  • Investments and Loans No Company shall: (a) create, acquire or hold any Subsidiary, (b) make or hold any investment in any stocks, bonds or securities of any kind, (c) be or become a party to any joint venture or other partnership, (d) make or keep outstanding any advance or loan to any Person, or (e) be or become a Guarantor of any kind; provided, that this Section shall not apply to: (i) any endorsement of a check or other medium of payment for deposit or collection through normal banking channels or similar transaction in the normal course of business; (ii) any investments in cash or Cash Equivalents; (iii) the holding of Subsidiaries listed on Schedule 7.1 hereto as of the Closing Date; (iv) intercompany loans to the extent permitted under Section 5.8(d); (v) any advance or loan to an officer, director or employee of a Company made in the ordinary course of such Company’s business, so long as all such advances and loans from all Companies aggregate not more than the maximum principal sum of $25,000 at any time outstanding; (vi) the creation, acquisition or holding of any Wholly-Owned Subsidiary that is a Domestic Subsidiary so long as such Subsidiary is in compliance with Section 5.22 of this Agreement; (vii) extensions of trade credit in the ordinary course of business; (viii) investments by Borrowers in Hedge Agreements other than for speculative purposes; (ix) investments acquired by Borrowers (a) in exchange for any other investment held by Borrowers in connection with or as a result of a bankruptcy, workout, reorganization or recapitalization of the issuer of such other investment or (b) as a result of the foreclosure by Borrowers with respect to any secured investment or other transfer of title with respect to any secured investment in default; (x) investments, loans and guaranties described on Schedule 5.11 hereto and any renewal or replacement thereof; (xi) investments that constitute Restricted Payments permitted under Section 5.20 hereof; (xii) Investments in Capital Expenditures to the extent permitted hereunder; (xiii) guaranties permitted under Section 5.8 hereof; (xiv) contributions of capital by any Credit Party to any other Credit Party until such time as Agent or the Required Lenders directs the Credit Parties during the existence of a Default or Event of Default, that no such contribution of capital may be made; or (xv) other investments in an aggregate amount not to exceed $100,000.

  • STRIKES AND LOCK-OUTS The Contractor shall forthwith notify the Engineer of the commencing of any strike or lock-out and the Engineer on account of any delay caused thereby may, after consultation with the Employer, grant such extension of time as he considers reasonable without prejudice to the right of the Employer to exercise after the expiration of such reasonable extension of time the rights and powers under these Conditions in case of default by the Contractor.

  • UNDERGROUND LOCATIONS Prior to the Company commencing any work the Customer must advise the Company of the precise location of all underground services on the site and clearly xxxx the location. The underground mains and services the Customer must identify include, but are not limited to, telephone cables, fibre optic cables, electrical services, gas services, sewer services, pumping services, sewer connections, sewer sludge mains, water mains, irrigations pipes, oil pumping mains and any other services that may be on site. Whilst the Company will take all care to avoid damage to any underground services the Customer agrees to indemnify the Company in respect of all any liability claims, loss, damage, cost and fines as a result of damage to services not precisely located and notified pursuant to this clause.

  • Log and Load Reporting Service This contract may at the States discretion, require the services of a State approved third party log and load reporting service. Purchaser shall ensure log volume measurement, weight, or scale and weight data for each load is received by the log and load reporting service within 1 business day of logs being measured or weighed. If during the term of this contract, the State discontinues use of the Log and Load Reporting Service, the State will notify the Purchaser in writing, and will approve an alternative log and load reporting process. Determination of volume and grade of any forest products shall be conducted by a state approved third party scaling organization and in accordance with the Westside log scaling and grading rules and Xxxxxxxx Volume Table, revised July 1, 1972, contained in the Northwest Log Rules Eastside and Westside Log Scaling Handbook (developed and produced by the Northwest Log Rules Advisory Group) and in effect on the date of confirmation of this contract. Special scaling specifications shall be noted on the State’s Brand Designation form which is hereby incorporated to this contract by reference. Forest Product measurement and weighing facilities required by this contract must be approved by the State. Forest products sold under the contract which require log scaling shall be scaled, measured, or counted by a State approved third party log scaling organization. Forest products sold under the contract which require weighing shall be weighed at a location that meets Washington State Department of Agriculture approval. Prior to forest products being hauled, the Contract Administrator must authorize in writing the use of State approved measurement and/or weighing facilities that are at or en-route to final destinations. Forest products from this sale shall be measured or weighed at facilities, which are currently approved for use by the State and are currently authorized for this sale. The State reserves the right to verify load volume and weights with State employees or contractors at the State's own expense. The State reserves the right to revoke the authorization of previously approved measurement locations.

  • Gaming, betting and lotteries The Hirer shall ensure that nothing is done on or in relation to the premises in contravention of the law relating to gaming, betting and lotteries.

  • Terminal Transfers You can get a receipt at the time you make any transfer at a First Hawaiian ATM, Network ATM, or POS terminal.

  • Meals and Lodging Meals and lodging expenses shall be paid in accordance with the Financial Policy and Procedures issued by the Administrative Office of the Courts.

  • Secure Information Handling and Transfers 7.1 Physical and electronic handling, processing and transferring of DWP Data, including secure access to systems and the use of encryption where appropriate.

  • Transfers Without Posting Lateral transfers or voluntary demotions may be granted, without posting for: (a) Compassionate or medical grounds to regular Employees who have completed their probationary period; (b) All Employees who have become incapacitated by industrial injury or industrial illness. In such cases, the Screening Committee outlined in 11.11 shall consider any applications or requests presented to the Committee. Each request for special consideration shall be judged solely on its merit.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!