Manufacturer/Source Clause Samples
The Manufacturer/Source clause identifies and specifies the origin or producer of goods or materials referenced in a contract. It typically requires that products supplied under the agreement come from a particular manufacturer or meet certain sourcing criteria, such as being produced in a specific country or by an approved supplier. This clause ensures that the buyer receives goods that meet agreed-upon standards or regulatory requirements, and helps prevent substitution with inferior or unauthorized products.
Manufacturer/Source. Where Specifications name a single manufacturer or source, provide a product by the named manufacturer or source that complies with requirements. Comparable products or substitutions for Contractor's convenience will not be considered.
Manufacturer/Source. (a) The Parties shall establish an appropriate facility or contract manufacturing organization for handling Finished Manufacture as follows: Rhizen shall be responsible for screening potential manufacturers, negotiating the applicable supply agreement, and effecting the technology transfer as necessary to establish and qualify Bulk API and Finished Product manufacturers, whether those are Rhizen, its Affiliates, or Third Parties; provided, that, TGTX shall have the right to provide reasonable input regarding the terms of such agreements (as well as any amendments thereof), review and comment on agreement drafts and forms, consult with Rhizen regarding the negotiation of such agreements between Rhizen and Third Party contract manufacturers, and conduct a general GMP/regulatory inspection of the proposed manufacturing facilities as the Parties may agree, it being understood that TGTX shall retain the final authority over the terms and conditions of any such agreements with such Third Party contractors..
(b) Notwithstanding 5.2(a), Rhizen shall be responsible for using Diligent Efforts to minimize the manufacturing cost of the Finished Product. In order to ensure a competitive rate of manufacturing cost is obtained, the facility or contract manufacturer used by Rhizen to produce the Finished Product must provide a total manufacturing cost within * % of the cost an alternative contract manufacturing organization of equal repute and quality, where the comparative manufacturing cost are measured as an average of such cost over the immediately preceding Twelve (12) month period. In the event that Rhizen does not provide manufacturing services at the cost required in this Section 5.2(b), then TGTX shall have the right to directly procure manufacturing services in its sole discretion.