Minimum Coating Thickness. Apply materials at the manufacturer's recommended spreading rate. Provide total dry film thickness of the system as recommended by the manufacturer.
Minimum Coating Thickness Sample Clauses
Related to Minimum Coating Thickness
Requirement to Work Reasonable Overtime The Employer may require any Employee to work reasonable overtime at overtime rates and such an Employee shall work overtime in accordance with the requirement.
Geographic Area and Sector Specific Allowances, Conditions and Exceptions The following allowances and conditions shall apply where relevant. Where the Employer does work which falls under the following headings, the Employer agrees to pay and observe the relevant respective conditions and/or exceptions set out below in each case.
Completion of Concrete Pours and Emergency Work (a) Except as provided in this sub-clause an Employee shall nor work or be required to work in the rain. (b) Employees shall not be required to start a concrete pour in Inclement Weather. (c) Where a concrete pour has been commenced prior to the commencement of a period of Inclement Weather Employees may be required to complete such concrete pour to a practical stage and for such work shall be paid at the rate of double time calculated to the next hour, and in the case of wet weather shall be provided with adequate wet weather gear. (d) If an Employee’s clothes become wet as a result of working in the rain during a concrete pour the Employee shall, unless the Employee has a change of dry working clothes available, be allowed to go home without loss of pay. (e) The provisions of clauses 32.7(c) and 32.7(d) hereof shall also apply in the case of emergency work where the Employees concerned and their delegates agree that the work is of an emergency nature and can start and/or proceed.
GENERAL WORKING CONDITIONS Section 18-1. Employment begins and ends at each project site. Section 18-2. The selection of craft foremen and/or general foremen and the number of foremen required shall be entirely the responsibility of the Employer, it being understood that in the selection of such foremen and/or general foremen the Employer will give primary consideration to the qualified individuals available in the local area. After giving such consideration, the Employer may select such individuals from other areas. All foremen shall take orders from the designated Employer representatives. Craft foremen shall be designated working foremen at the request of the Employer. Section 18-3. There shall be no limit on production by employees nor restrictions on the full use of tools or equipment. Employees using tools shall perform any of the work of the trade and shall work under the direction of the craft foremen. There shall be no restrictions on efficient use of manpower other than as may be required by safety regulations. Section 18-4. Employees shall be at their place of work at the starting time and shall remain at their place of work performing their assigned functions under the supervision of the Employer until quitting time. The parties reaffirm their policy of a fair day’s work for a fair day’s wage. Section 18-5. All equipment assigned to a project shall be under the control of the Employer. The Employer shall have the right to determine how many pieces of equipment an individual employee shall operate. In an emergency, foremen shall operate any equipment assigned by the Employer, and there shall be no restriction on foremen in the use of the tools of his or her craft in such emergency. The foremen shall be from the craft normally operating the equipment. In accordance with currently recognized craft jurisdiction, the Employer shall determine the assignment of employees to start, stop, and maintain small portable construction equipment. Such work may be assigned to craft employees within a reasonable distance of their primary duties or an employee may be assigned full time to start, stop and maintain the Employer’s small, portable equipment on the job site. There shall be no over xxxxxxx of this type of equipment. The number of employees assigned to rigging and scaffolding operations shall be at the sole discretion of the Employer. The ratio of journeyperson to welders shall be determined solely by the Employer. Section 18-6. The Employer may utilize the most efficient methods or techniques of construction, tools or other labor saving devices to accomplish the work. Practices not a part of the terms and conditions of this Agreement, stand by crews and feather bedding practices will not be recognized. Section 18-7. It is recognized that specialized or unusual equipment may be installed and/ or serviced by individuals who have special training, skill, or qualifications and are not covered by this Agreement. Testing, inspection, or service performed on plant equipment under warranty may be performed by the vendor’s personnel. Section 18-8. Neither the Union nor its local unions shall coerce or in any way interfere with the Owner’s personnel, operation or facilities at the plant site. The Owner’s right to contract directly with other companies for work at the plant site shall not be limited, and the Union shall cooperate and not interfere with the Employer’s operations. Section 18-9. It is agreed that overtime is undesirable and not in the best interest of the industry or the employees; therefore, except in unusual circumstances, overtime will not be worked. Where unusual circumstances do exist, however, the Employer will have the right to assign specific employees and/or crews to perform such overtime work as is necessary to accomplish the job. Section 18-10. There will be no rest periods, organized coffee breaks or other non-working time established during working hours. Section 18-11. Individual seniority shall not be recognized or applied to employees working on projects under this Agreement. Section 18-12. The Employer shall establish such reasonable project rules as the Employer deems appropriate. These rules will be reviewed at the pre-job conference and posted at the project site by the Employer, and may be amended thereafter as necessary.
Access to Work District representatives shall at all times have access to the Work, wherever it is, in preparation or in progress. Contractor shall provide safe and proper facilities for such access.
Time Devoted to Work In performing the services contemplated under this Agreement, the services and the hours Consultant is to work on any given day will be on a mutually agreed upon basis, except for attendance at scheduled meetings, and City will rely upon Consultant to put in such number of hours as is reasonably necessary to fulfill the spirit and purpose of this Agreement. City understands that Consultant is engaged in the same or similar activities for others and that City may not be Consultant’s sole client or customer. However, Consultant represents and warrants that it is under no obligation or restriction, nor will it assume any such obligation or restriction, that would in any way interfere or be inconsistent with the services to be performed under this Agreement.
WORK CLOTHING Two sets of cotton drill protective clothing will be issued to all employees, upon request, within two weeks of commencing work with the Company. Employees will be made aware of these entitlements at the time of employment. A set of clothing will consist of either: • Two pairs of overalls; or • Two combination bib and brace; or • Two pairs of long trousers and two long sleeved shirt; or • Work denims at cost no greater than the above three choices • Clothing and footwear will be replaced on a fair wear and tear basis.
Access to Work Locations Reasonable access to employee work locations shall be granted officers of the Association and their officially designated representatives for the purpose of processing grievances or contacting members of the Association concerning business within the scope of representation. Such officers or representatives shall not enter any work location without the consent of the City Manager. Access shall be restricted so as not to interfere with the normal operations of the department or with established safety or security requirements. Solicitation of membership and activities concerned with the internal management of the Association, such as collecting dues, holding membership meetings, campaigning for office, conducting elections and distributing literature, shall not be conducted during working hours.
SAFETY CONDITIONS 8.1 The District shall make every effort to provide a place of employment which is safe. A unit member shall not be required to perform duties under conditions which endanger his/her health or safety. 8.2 The District shall make a good faith effort to reduce or alleviate those conditions which cause stress. The reduction of threats or intimidation by students or other members of the public shall be a continuous effort of both the District and unit members working together. 8.3 Unit members who feel they are being required to work under unsafe or unsanitary conditions, or to perform tasks that endanger their health or safety, shall submit written recommendations for changes to the principal or site administrator. The principal or site administrator shall respond and take corrective action as needed. 8.4 The District shall ensure that each unit member has access to a lockable desk, cupboard or other lockable space. 8.5 Unit members other than the school nurse, shall not be required to provide specialized physical health care. 8.6 Unit members are authorized to administer discipline to students in accordance with the Education Code and the rules and regulations of the District. A written description of the rights and duties of unit members with respect to student discipline shall be provided to unit members at the beginning of each school year. In addition, said written descriptions shall be available at each school site. The District shall not take action against a unit member who uses reasonable and lawful force in the performance of his/her duties. Unit members shall report any physical assault against the unit member to the principal or site administrator, who shall report the incident to the appropriate law enforcement agency. 8.7 During conditions of excessive heat, the Superintendent or designee, whenever appropriate, will reduce the school day for students in schools with non-operable air conditioning, to the State required minimum day. Unit members may be directed to proceed to a district air conditioned location for the remainder of the service day. The Superintendent or designee shall have the discretion to reduce the school day to the State required minimum day whenever other weather conditions pose a danger to students and unit members. Unit members may be directed to proceed to another District location for the remainder of the service day. 8.8 For protection of unit members whose normal duties may require transportation of students in unit member's vehicles, the District shall provide secondary insurance against personal liability for damages for death, injury to a person, or damage or loss of property caused by the negligent act or omission of the unit member when acting within the scope of his/her employment. Additionally, the District will provide this same coverage to unit members who are required to travel from site-to- site or make home visitations in order to perform assigned duties. When a loss occurs, the unit member's primary insurance deductible will be reimbursed up to a maximum of $500.00. If administrator approval is unobtainable, the teacher's best judgment for the protection of student safety shall be included in the above. 8.9 Restrooms shall be available to unit members whenever they are required to render service. 8.10 Adequate lounge facilities shall be provided for unit members' use. Additionally, the District shall provide, when fiscally possible, at least one piece of furniture per site where a staff member may recline. The site safety committee shall determine the placement of these facilities and furniture. 8.11 Unit members shall have the right to refer to the office, a student who exhibits symptoms of illness which endanger the health of other students or the unit member. The student shall not return to the classroom until it is determined by the principal/site administrator that his/her health is not a clear and present danger to those with whom he/she shares space. The student shall be given a pass to return to class signed by the principal/site administrator confirming the decision. 8.12 The District shall reimburse or repair articles of clothing, glasses and hearing aids damaged while the unit member is acting in the proper discharge of disciplinary/ supervisorial duties. In addition, all other accessories damaged under the conditions listed above shall be reimbursed up to a maximum of $200.00.
Certification of Meeting or Exceeding Tobacco-Free Workplace Policy Minimum Standards A. Grantee certifies that it has adopted and enforces a Tobacco-Free Workplace Policy that meets or exceeds all of the following minimum standards of: i. Prohibiting the use of all forms of tobacco products, including but not limited to cigarettes, cigars, pipes, water pipes (hookah), bidis, kreteks, electronic cigarettes, smokeless tobacco, snuff and chewing tobacco; ii. Designating the property to which this Policy applies as a "designated area,” which must at least comprise all buildings and structures where activities funded under this Grant Agreement are taking place, as well as Grantee owned, leased, or controlled sidewalks, parking lots, walkways, and attached parking structures immediately adjacent to this designated area; iii. Applying to all employees and visitors in this designated area; and iv. Providing for or referring its employees to tobacco use cessation services. B. If Grantee cannot meet these minimum standards, it must obtain a waiver from the System Agency.
