Minimum Setback Requirements Sample Clauses

Minimum Setback Requirements. (A) All buildings and structures shall have a minimum yard area and setback of the underlying zoning district from the perimeter boundary of the MPR. When the MPR is adjacent to a shoreline or other significant recreation amenity, this provision shall not apply to immediate vicinity of said shoreline or recreation amenity. (B) Interior required yards and setbacks shall be as established by the approved MPR plan. Required yards and setbacks established by the plan shall be reviewed for adequate light, air and life safety for all structures. (A) CCC 11.08.020(5) provides the building setbacks distances for the RR-20 property (where the development will take place). However, as part of the Mission Ridge Expansion Master Planned Resort, we have provided proposed minimum setbacks for different elements of the project (residential, commercial, and other) in addition to other bulk standard requirements such as maximum heights, lot widths, ect…. A table defining the proposed bulk standard requirements for this project can be found in Section D of the narrative. Once the Master Planned Resort Overlay is approved by the Hearing Examiner, the Bulk Standards table will be inserted into the Development Agreement. (4) Density. The maximum overall density for the MPR, including transient accommodation, shall not exceed two housing units per gross acre of the overall master planned resort, or as determined by the hearing examiner. The proposed Master Planned Resort will be approximately 502 acres which would allow a maximum of 1004 total units. We are only proposing a maximum of 873 units (which includes possible employee housing). We meet this requirement. (5) The maximum lot coverage, minimum setback, minimum lot area and width may be modified consistent with the MPR plan, as approved in conformance with the purpose of this chapter. The maximum building height will conform to that of the underlying zone, unless otherwise approved by the hearing examiner. For lot coverage, maximum lot coverage will be different for different types of uses. We would ask for 80% coverage for commercial and non-detached single-family sites. For single family detached homes, 80% would be preferred although in most cases, the coverage will be much lower. A higher lot coverage would allow, in some cases, smaller lots and more common open space areas, which could help in preserving the natural amenities and open space of the site. The maximum building height for the RR-20 zone is 35 feet. Howev...
AutoNDA by SimpleDocs

Related to Minimum Setback Requirements

  • Minimum System Requirements The following summarizes the minimum office system requirements for all Contractors and Architect/Engineer to possess in order to participate. It is the responsibility of all Contractors and Architect/Engineer to possess these minimum requirements at no additional cost to Princeton University.

  • Check Requirements Any image of a check that I transmit to you must accurately and legibly provide all the information on the front and back of the check at the time presented to me by the drawer. Prior to capturing the original check, I will indorse the back of the original check. My endorsement will include "For Directions E- Deposit Only" in addition to my signature. The image of the check transmitted to you must accurately and legibly provide, among other things, the following information: (1) the information identifying the drawer and the paying bank that is preprinted on the check, including complete and accurate MICR information and the signature(s); and (2) other information placed on the check prior to the time an image of the check is captured, such as any required identification written on the front of the check and any endorsements applied to the back of the check. The image quality for the check will meet the standards for image quality established by the American National Standards Institute ("ANSI"), the Board of Governors of the Federal Reserve, and any other regulatory agency, clearing house or association. Rejection of Deposit. You are not liable for any service or late charges levied against me due to your rejection of any item. In all cases, I am responsible for any loss or overdraft plus any applicable fees to my Account due to an item being returned. Items Returned Unpaid. A written notice will be sent to me of transactions you are unable to process because of returned items. With respect to any item that I transmit to you for remote deposit that you credit to my Account, in the event such item is dishonored, I authorize you to debit the amount of such item from the Account. Email Address. I agree to notify you immediately if I change my email address, as this is the email address where you will send me notification of receipt of remote deposit items.

  • Minimum Balance Requirements To be a member and maintain Accounts with Us You must purchase 1 share in the Credit Union. The par value of a share in this Credit Union is $10.00. If the balance in Your primary savings Account drops below 1 share ($10.00), at any time, We may, at Our option, close Your Account. Nonsufficient Funds Returns. Any check or pre-authorized transfer, or transaction made through the use of a debit card, or other electronic means, as is applicable (including any in-person transaction), that is presented to Us for payment on Your Account when Your Account lacks sufficient collected funds to pay any such item may, at Our option, be returned for nonsufficient funds or We may honor any such item and charge You a fee for doing so. Overdraft Balance Calculation. When processing transactions that debit or credit Your Account, We start each Business Day with Your final Account balance from the preceding Business Day. The final balance takes into Account all of the debit and credit transactions that were settled that Business Day pursuant to Our Funds Availability Policy, as well as any other debits or credits to Your Account that were finally settled that day, as described above in the "Deposit of Items" and "Collection and Processing of Items" sections of the Account Agreement. This starting balance at the beginning of a Business Day (the preceding Business Day's final balance) is sometimes referred to as Your "actual balance." As credits and debits to Your Account are received by Us, We add them to and subtract them from Your actual balance. Examples of credits include, but are not limited to, electronic direct deposits, check deposits that have been fully and finally collected, ACH credits that have settled that day, and cash deposits made to one of Our tellers. Examples of debits include, but are not limited to, checks drawn on Your Account that are presented to Us for payment together with such checks that are returned unpaid and subsequently represented for payment, electronic fund transfer (EFT) debit transactions (such as preauthorized payments and settled EFT debits) and all reinitiated electronic fund transfer (EFT) debit transactions (such as preauthorized payments), memo-posted EFT debits (EFT debits that We have authorized but which have not been settled), and all Credit Union fees and charges. As noted above, these examples are not an exhaustive list and should not be construed as such. The result of this calculation at any given point in time is called Your "available balance." For the purpose of determining whether an overdraft has occurred, We use Your available balance. First, We add all of the settled credit transactions to the beginning actual balance. Then, We subtract all of the debit transactions that settled that day. We also subtract all of the pending debit transactions. This determines the available balance for overdraft purposes. Each debit transaction that We process when Your Account has, or will have, a negative available balance is an overdraft, subject to an overdraft charge. Subject to applicable law, You are responsible for paying any overdraft fees and charges assessed in connection with Our payment of an overdraft, as well as any NSF fees charged to Your Account when We dishonor and return an item for non- sufficient funds. It is Your responsibility to know Your Account balance, and if You have any questions You should contact a Credit Union representative.

  • Basic Requirements To be eligible for PayPal’s Seller Protection program, all of the following basic requirements must be met, as well as any applicable additional requirements: • The primary address for your PayPal account must be in the United States. • The item must be a physical, tangible good that can be shipped, except for items subject to the Intangible Goods Additional Requirements. Transactions involving items that you deliver in person in connection with payment made in your physical store, may also be eligible for PayPal’s Seller Protection program so long as the buyer paid for the transaction in person by using a PayPal goods and services QR code. • You must ship the item to the shipping address on the Transaction Details page in your PayPal account for the transaction. If you originally ship the item to the recipient’s shipping address on the Transaction Details page but the item is later redirected to a different address, you will not be eligible for PayPal’s Seller Protection program. We therefore recommend not using a shipping service that is arranged by the buyer, so that you will be able to provide valid proof of shipping and delivery. • The shipping requirement does not apply to eligible transactions involving items that you deliver in person; provided, however, that you agree to provide us with alternative evidence of delivery or such additional documentation or information relating to the transaction that we may request. • You must respond to PayPal’s requests for documentation and other information in a timely manner as requested in our email correspondence with you or in our correspondence with you through the Resolution Center. If you do not respond to PayPal’s request for documentation and other information in the time requested, you may not be eligible for PayPal’s Seller Protection program. • If the sale involves pre-ordered or made-to-order goods, you must ship within the timeframe you specified in the listing. Otherwise, it is recommended that you ship all items within 7 days after receipt of payment. • You provide us with valid proof of shipment or delivery. • The payment must be marked “eligible” or “partially eligible” in the case of Unauthorized Transaction claims, or “eligible” in the case of Item Not Received claims, for PayPal’s Seller Protection program on the Transaction Details page. • In the case of an Unauthorized Transaction claim, you must provide valid proof of shipment or proof of delivery that demonstrates that the item was shipped or provided to the buyer no later than two days after PayPal notified you of the dispute or reversal. For example, if PayPal notifies you of an Unauthorized Transaction claim on September 1, the valid proof of shipment must indicate that the item was shipped to the buyer no later than September 3 to be eligible for PayPal’s Seller Protection program. PayPal determines, in its sole discretion, whether your claim is eligible for PayPal’s Seller Protection program. PayPal will make a decision, in its sole discretion, based on the eligibility requirements, any information or documentation provided during the resolution process, or any other information PayPal deems relevant and appropriate under the circumstances. Item Not Received additional requirements To be eligible for PayPal’s Seller Protection program for a buyer’s Item Not Received claim, you must meet both the basic requirements and the additional requirements listed below: • Where a buyer files a chargeback with the issuer for a card-funded transaction, the payment must be marked “eligible” for PayPal’s Seller Protection on the Transaction Details page. • You must provide proof of delivery as described below.

  • Trunk Forecasting Requirements 14.2.1 Initial trunk forecast requirements. At least ninety (90) days before initiating interconnection in a LATA, Alltel shall provide Verizon a two (2)-year traffic forecast that complies with the Verizon Interconnection Trunking Forecast Guide, as revised from time to time. This initial traffic forecast will provide the amount of traffic to be delivered to and from Verizon over each of the Interconnection Trunk groups in the LATA over the next eight (8) quarters.

  • Minimum Insurance Requirements Contractor shall procure and maintain for the duration of the contract insurance against claims for injuries or death to persons or damages to property which may arise from or in connection with the performance of the work hereunder and the results of that work by the Contractor, his agents, representatives, employees or sub-contractors. Coverage - Coverage shall be at least as broad as the following:

  • Minimum Requirements Consultant shall, at its expense, procure and maintain for the duration of the Agreement insurance against claims for injuries to persons or damages to property which may arise from or in connection with the performance of the Agreement by the Consultant, its agents, representatives, employees or subconsultants. Consultant shall also require all of its subconsultants to procure and maintain the same insurance for the duration of the Agreement. Such insurance shall meet at least the following minimum levels of coverage:

  • Forecasting Requirements 19.5.1 The Parties shall exchange technical descriptions and forecasts of their Interconnection and traffic requirements in sufficient detail necessary to establish the Interconnections necessary for traffic completion to and from all Customers in their respective designated service areas.

  • Coverage Minimum Requirement Commercial General Liability Insurance, including Bodily Injury, Personal Injury, Property Damage, Advertising Injury, and Medical Payments Each Occurrence General Aggregate $ 1,000,000 $ 2,000,000 Automobile Liability Insurance - Any Auto Each Occurrence General Aggregate $ 1,000,000 $ 2,000,000 Professional Liability $ 1,000,000 Workers Compensation Statutory Limits Employer’s Liability $ 1,000,000

  • Testing Requirements 12.1. Workplaces -

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!