Instructions from Customer Processing on Legal Requirement. 28(3) (b) 3.3 Personnel. 28(3) (c) and 32 2 and Appendix 2 Security of Processing and Appendix 2, Technical and Organizational Measures. 28(3) (e) 3.4 Cooperation. 28(3) (f) and 32-36 2 and Appendix 2, 3.5, 3.6 Security of Processing and Appendix 2, Technical and Organizational Measures. Personal Data Breach Notification. Data Protection Impact Assessment. 28(3) (g) 4 Data export and Deletion 28(3) (h) 5 CERTIFICATIONS AND AUDITS
NETWORK INTERCONNECTION METHODS 64.1 This Section sets forth the terms and conditions for Network Interconnection Methods (NIMs) provided between CenturyLink and CLEC for the Interconnection Facilities established between the Parties’ networks. Additionally, this Section describes the physical architecture for the Interconnection of the Parties’ facilities and equipment required for the transmission and routing of Local Traffic, ISP-Bound Traffic, IntraLATA LEC Toll Traffic, VoIP-PSTN Traffic, Transit Traffic and Jointly Provided Switched Access Service Traffic.
Form instructions 1. This form does not mandate the use of a specific font size or style but the font must be legible.
Construction Methods No four course of brick-work, with three joints, shall exceed in height, when built, one inch more than the same bricks piles upon one another without mortar. The bricks are to be well soaked in water before use on works, in proper through so as to be thoroughly wet when layed. The Cessation of the bubbles through the water is an irldication of saturation being complete. For ensuring thorough soaking of the bricks every one or two bricklayers or more as necessary, shall be provided with tubs for use The wall of structures shall be carried up regularly in all cases 1` when the nature of the work will admit of it not leaving any part 915mm (3 feet) lower than another. Horizontal courses shalI be straight, level and even and faces of walls smooth and plumb. A straight edge and a plumb- xxx shall be used for constant checking during progress of the work. No brick-bats shall be permitted to be used except when necessary for obtaining the dimension of the different course or for obtaining the specified bond. All unfinished work must be raked back in course unless otherwise directed arid when new work is to be jointed to it the surface of unfinished work must be cleaned and wetted. The bricks shall be laid by placing sufficient mortar on the wall and forcing every brick into it in such a manner as to completely fill every joint with moratar whether at the bottom, side or end of the brick. The mortar to be used shall be that specified for the relevant schedule items and shall comply with the specification for the mortar specified. The bound used shall be English and shall be carried throughout the work. At all angles forming the junction of any two walls, the bricks shall, at each alternate course be carried into each of the respective walls, so as to thoroughly unite the work. V'Jhen the faces are to be plastered, the joints shall be well raked out before any plaster is laid on should the plaster from want of proper joint ranking detach and 7 fall off from the brick work, the contractor shall strip off the plaster bodily to the extent ordered by Superintending Engineer and shall re-do the work properly at his own expense. All requisite scaffolding shall be provided at the contractor's expense and shall be double i.e., must it have two sets of upright supports Care must be taken to ensure the safety of the work people and the contractor must comply with such instructions as the Superintending Engineer may issue to ensure such safety. The contractor will be entirely responsible for any damage or injuries to person or property resulting from ill-erected scaffolding, defective ladders, or otherwise arising out of his default in this respect. The brick work for the retaining wall shall proceed side by side with the depositing and compacting of earth between the retaining walls. At no time shall the brick-work be constructed more than 405mm (1'-4") above Y the compacted earth. In the retaining wall weep-holes shall be provided at suitable intervals as instructed during execution, with the inner surface of the weep-holed plastered 20mm (3/4") thick in cement mortar 1:4 crouched rock of grades in different layer shall be provided at the inner end of the weep-holes to prevent the choking of the weep-holes to have full drainage. No extra payment will be made for this and no deductions will be made for this in the brick-work.
INVOICING INSTRUCTIONS The A-E will provide an invoice on the A-E’s letterhead. Each invoice will have a unique number and will include the following information:
Billing Instructions Enter name and mailing address of nominating Agency Finance Office for billing purposes.
Instructional Framework The District and the Association have agreed to the adopted research-based instructional framework developed by Xxxxxxxxx Xxxxxxxxx and approved by OSPI. The Association and District have also agreed to Xxxxxxxxx Xxxxxxxxx’x frameworks for specialists for use with other certificated educators.
Special Instructions As used herein, the term "Special Instructions" shall mean Proper Instructions countersigned or confirmed in writing by the Treasurer or any Deputy or Assistant Treasurer of the applicable Fund or any other person designated by the Treasurer of such Fund in writing, which countersignature or confirmation shall be (i) included on the same instrument containing the Proper Instructions or on a separate instrument relating thereto, and (ii) delivered by hand, by facsimile transmission, or in such other manner as the applicable Fund and the Custodian agree in writing.
Payment – Invoicing Instructions The Contractor will provide an invoice on the Contractor’s letterhead for goods delivered and/or services rendered. In the case of goods, the Contractor will leave an invoice with each delivery. Each invoice will have a number and will include the following information:
SHIPPING INSTRUCTIONS On date of shipment send original xxxx of lading, air xxxx or express receipt reflecting this Purchase Order number to Buyer’s Traffic Department. Do not deliver ahead of schedule unless written authorization is received from Buyer. Describe shipments in accordance with the carrier’s tariffs to obtain the lowest freight rate. Do not insure or declare value on shipments beyond F.O.B point. When a shipment is subject to freight rates dependent upon value, annotate the xxxx of lading, air xxxx or express receipt to show that the shipment is released at the maximum value which applies to the lowest rate provided in applicable tariffs. Consolidate all shipments to be forwarded on one day. Articles furnished in excess of the quantity specified or in excess of quantity ordered will be retained by Buyer at no additional cost, unless Seller notifies Buyer within 30 days after shipment that it desires the return thereof. Seller will reimburse Buyer for the full cost of returning such over shipment or a minimum charge to $50, whichever is higher. No notification will be given to Seller of any over shipment. Mail original and two duplicate invoices to Buyer’s accounting Department when articles are shipped. STATE SHIPPING POINT ON ALL INVOICES. Each case or parcel and accompanying packing list of contents must show Buyer’s Purchase Order number. Seller shall label all packages according to Buyer’s bar coding requirements. If no packing List accompanies the shipment, Buyers count will be conclusive to Seller.
