Optimize Energy Performance Sample Clauses

Optimize Energy Performance. The project will demonstrate a percentage improvement in the proposed building performance rating compared to the baseline building performance rating. The project will use on-site renewable energy systems (solar) to offset a portion of building energy cost.
AutoNDA by SimpleDocs
Optimize Energy Performance. Lighting Controls: Projects that install lightning controls such as daylight and occupancy sensors can achieve up to three points in and contribute towards increased energy conservation.
Optimize Energy Performance. HVAC: Through increased HVAC equipment efficiencies and appropriate zoning and controls, which result in HVAC performance above ASHRAE 90.1-2007, projects are eligible for up to 10 points. • High SEER condensing units – minimum 14 SEER. • Air source heat pump heating. • Electronically Controlled Motors (ECM) in fan coils. • Demand ventilation controls with CO2 sensors.
Optimize Energy Performance. Lighting Power: Projects can achieve up to five points for further reductions in lighting power density below ASHRAE 90.1-2007.

Related to Optimize Energy Performance

  • School Performance The School shall achieve an accountability designation of Good Standing or Honor on each of the three sections of the Performance Framework. In the event the School is a party to a third party management contract which includes a deficit protection clause, the School shall be exempt from some or all measures within the financial portion of the Performance Framework. In accordance with Charter School Law, the Authorizer shall renew any charter in which the public charter school met all of the terms of its performance certificate at the time of renewal.

  • Monitoring of Contract Performance The Contractor shall comply with the monitoring arrangements set out in the Monitoring Requirements Schedule including, but not limited to, providing such data and information as the Contractor may be required to produce under the Contract.

  • Contract Performance C19.1 The Contractor shall ensure that: C19.1.1 the Goods conform in all respects with the Specification and, where applicable, with any sample or performance demonstration approved by the Authority; C19.1.2 the Goods operate in accordance with the relevant technical specifications and correspond with the requirements of the Specification and any particulars specified in the Contract; C19.1.3 the Goods conform in all respects with all applicable Laws; and C19.1.4 the Goods are free from defects in design, materials and workmanship and are fit and sufficient for all the purposes for which such Goods are ordinarily used and for any particular purpose made known to the Contractor by the Authority.

  • Continuing Performance In the event of a dispute, the Owner and the Developer agree to continue their respective performance hereunder to the extent feasible in light of the dispute, including paying xxxxxxxx, and such continuation of efforts and payment of xxxxxxxx shall not be construed as a waiver of any legal right.

  • EVALUATING PERFORMANCE 7.1 The Performance Plan (Annexure A) to this Agreement sets out: 7.1.1 the standards and procedures for evaluating the Employee’s perfor- xxxxx; and 7.1.2 the intervals for the evaluation of the Employee’s performance. 7.2 Despite the establishment of agreed intervals for evaluation, the Employer may in addition review the Employee’s performance at any stage while the contract of employment remains in force. 7.3 Personal growth and development needs identified during any performance review discussion must be documented in a Personal Development Plan as well as the actions agreed to and implementation must take place within set time frames. 7.4 The Employee’s performance will measured in terms of contributions to the goals and strategies set out in the Employer’s IDP. 7.5 The annual performance appraisal will involve: 7.5.1. Assessment of the achievement of results as outlined in the perfor- xxxxx plan: (a) Each KPA should be assessed according to the extent to which the specified standards or performance indicators have been met and with due regard to ad hoc tasks that had to be performed under the KPA. (b) An indicative rating on the five-point scale should be provided for each KPA. (c) The applicable assessment rating calculator (refer to paragraph 7.5.3. below) must then be used to add the scores and calculate a final KPA score.

  • Substantial Performance This Contract shall be deemed to be substantially performed only when fully performed according to its terms and conditions and any written amendments or supplements.

  • Services Performance All services are performed using generally recognized commercial practices and standards. Customer agrees to provide prompt notice of any such service concerns and HP will re-perform any service that fails to meet this standard.

  • Product Performance Contractor hereby warrants and represents that the Products acquired by the Authorized User under the terms and conditions of this Contract conform to the specifications, performance standards and documentation in the Authorized User Agreement., and the documentation fully describes the proper procedure for using the Products. Contractor further warrants and represents that if the Products acquired by the Authorized User pursuant to an Authorized User Agreement under this Contract include software application development, software application customization, software programming, software integration or similar items (“Software Deliverables”) then such Software Deliverables shall be free from defects in material and workmanship and conform with all requirements of the Contract and Authorized User Agreement for the warranty period of one (1) year from the date of acceptance of the completed project (“Project warranty period”). Contractor also warrants that the Products, in the form provided to the Authorized User, do not infringe any copyright, trademark, trade secret or other right of any third party.

  • Software Performance HP warrants that its branded software products will conform materially to their specifications and be free of malware at the time of delivery. HP warranties for software products will begin on the date of delivery and unless otherwise specified in Supporting Material, will last for ninety (90) days. HP does not warrant that the operation of software products will be uninterrupted or error-free or that software products will operate in hardware and software combinations other than as authorized by HP in Supporting Material.

  • Reviewing Contract Performance The Contractor shall work with the Authority to establish and maintain an effective and beneficial working relationship to ensure the Contract is delivered to at least the minimum required standard as specified in the Schedule (The Services).

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!