Parent Tract Inset Sample Clauses

Parent Tract Inset. A small line drawing, to an appropriate scale, of the parent tract perimeter placed upon the right-of-way map in the proximity of the respective parcel. Parent tract insets are used in cases where the parent tract cannot be shown to the same scale as the right-of-way map. Since parent tract insets are used to identify the limits and location of parent tracts, they must include public right-of-ways, utility easements and fee strips, and identifiable water courses which bound the parent tract.
AutoNDA by SimpleDocs
Parent Tract Inset. A small line drawing, to an appropriate scale, of the parent tract perimeter placed upon the right-of-way map in the proximity of the respective parcel. Parent tract insets are used in cases where the parent tract cannot be shown to the same scale as the right-of-way map. Since parent tract DocuSign Envelope ID: D78C9312-D95C-4FD3-B00A-7CFCC10A2DB4 insets are used to identify the limits and location of parent tracts, they must include public right-of-ways, utility easements and fee strips, and identifiable water courses which bound the parent tract.

Related to Parent Tract Inset

  • Unbundled Copper Loop – Non-Designed (UCL-ND 2.4.3.1 The UCL–ND is provisioned as a dedicated 2-wire metallic transmission facility from BellSouth’s Main Distribution Frame to a customer’s premises (including the NID). The UCL-ND will be a “dry copper” facility in that it will not have any intervening equipment such as load coils, repeaters, or digital access main lines (“DAMLs”), and may have up to 6,000 feet of bridged tap between the end user’s premises and the serving wire center. The UCL-ND typically will be 1300 Ohms resistance and in most cases will not exceed 18,000 feet in length, although the UCL-ND will not have a specific length limitation. For loops less than 18,000 feet and with less than 1300 Ohms resistance, the loop will provide a voice grade transmission channel suitable for loop start signaling and the transport of analog voice grade signals. The UCL-ND will not be designed and will not be provisioned with either a DLR or a test point. 2.4.3.2 The UCL-ND facilities may be mechanically assigned using BellSouth’s assignment systems. Therefore, the Loop Make Up process is not required to order and provision the UCL-ND. However, Lightyear can request Loop Make Up for which additional charges would apply. 2.4.3.3 At an additional charge, BellSouth also will make available Loop Testing so that Lightyear may request further testing on the UCL-ND. Rates for Loop Testing are as set forth in Exhibit B of this Attachment. 2.4.3.4 UCL-ND loops are not intended to support any particular service and may be utilized by Lightyear to provide a wide-range of telecommunications services so long as those services do not adversely affect BellSouth’s network. The UCL-ND will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the loop to the customer’s inside wire. 2.4.3.5 Order Coordination (OC) will be provided as a chargeable option and may be utilized when the UCL-ND provisioning is associated with the reuse of BellSouth facilities. Order Coordination -Time Specific (OC-TS) does not apply to this product. 2.4.3.6 Lightyear may use BellSouth’s Unbundled Loop Modification (ULM) offering to remove bridge tap and/or load coils from any loop within the BellSouth network. Therefore, some loops that would not qualify as UCL-ND could be transformed into loops that do qualify, using the ULM process.

  • Unbundled Copper Loop – Designed (UCL-D) 2.4.2.1 The UCL-D will be provisioned as a dry copper twisted pair (2- or 4-wire) Loop that is unencumbered by any intervening equipment (e.g., filters, load coils, range extenders, digital loop carrier, or repeaters). 2.4.2.2 A UCL-D will be 18,000 feet or less in length and is provisioned according to Resistance Design parameters, may have up to 6,000 feet of bridged tap and will have up to 1300 Ohms of resistance. 2.4.2.3 The UCL-D is a designed circuit, is provisioned with a test point, and comes standard with a DLR. OC is a chargeable option for a UCL-D; however, OC is always required on UCLs where a reuse of existing facilities has been requested by Telepak Networks. 2.4.2.4 These Loops are not intended to support any particular services and may be utilized by Telepak Networks to provide a wide-range of telecommunications services as long as those services do not adversely affect BellSouth’s network. This facility will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the Loop to the customer’s inside wire. 2.4.2.5 Upon the Effective Date of this Agreement, Unbundled Copper Loop – Long (UCL-L) elements will no longer be offered by BellSouth and no new orders for UCL-L will be accepted. Any existing UCL-Ls that were provisioned prior to the Effective Date of this Agreement will be grandfathered at the rates set forth in the Parties’ interconnection agreement that was in effect immediately prior to the Effective Date of this Agreement. Existing UCL-Ls that were provisioned prior to the Effective Date of this Agreement may remain connected, maintained and repaired according to BellSouth’s TR73600 and may remain connected until such time as they are disconnected by Telepak Networks or BellSouth provides ninety

  • Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.

  • SIGNIFICANT LANDS INVENTORY FINDING Find that this activity is consistent with the use classification designated by the Commission for the land pursuant to Public Resources Code section 6370 et seq.

  • Area of Concern Separation of xxxxxx and steps. Standard: So long as xxxxxx and steps do not separate an average of more than one (1) inch from the building, settling, heaving, and separation of such xxxxxx and steps is to be expected. Developer or Initial Purchaser must immediately seal cracks appearing with a waterproof substance.

  • Company is a Well-Known Seasoned Issuer (i) At the time of filing the Registration Statement, (ii) at the time of the most recent amendment thereto for the purposes of complying with Section 10(a)(3) of the Securities Act (whether such amendment was by post-effective amendment, incorporated report filed pursuant to Section 13 or 15(d) of the Exchange Act or form of prospectus), (iii) at the time the Company or any person acting on its behalf (within the meaning, for this clause only, of Rule 163(c) of the Securities Act) made any offer relating to the Notes in reliance on the exemption of Rule 163 of the Securities Act, and (iv) as of the Execution Time, the Company was and is a “well known seasoned issuer” as defined in Rule 405 of the Securities Act. The Registration Statement is an “automatic shelf registration statement,” as defined in Rule 405 of the Securities Act, that automatically became effective not more than three years prior to the Execution Time; the Company has not received from the Commission any notice pursuant to Rule 401(g)(2) of the Securities Act objecting to use of the automatic shelf registration statement form and the Company has not otherwise ceased to be eligible to use the automatic shelf registration form.

  • Unbundled Copper Loops (UCL) 2.4.1 BellSouth shall make available Unbundled Copper Loops (UCLs). The UCL is a copper twisted pair Loop that is unencumbered by any intervening equipment (e.g., filters, load coils, range extenders, digital loop carrier, or repeaters) and is not intended to support any particular telecommunications service. The UCL will be offered in two types – Designed and Non-Designed.

  • Purchaser Can Protect Its Interest Purchaser represents that by reason of its, or of its management’s, business or financial experience, Purchaser has the capacity to protect its own interests in connection with the transactions contemplated in this Agreement, and the Related Agreements. Further, Purchaser is aware of no publication of any advertisement in connection with the transactions contemplated in the Agreement.

  • IDENTITY OF THE PROPERTY 11.1 The Purchaser shall admit the identity of the Property with that described in the Proclamation of Sale and such other documents offered by the Assignee/Bank as the title to the Property by a comparison of the description in the Proclamation of Sale and the aforesaid documents. 11.2 Any error, misstatement, omission or misdescription of the Property in the Proclamation of Sale and the documents referred to in paragraph 11.1 above shall not annul the sale, nor shall any compensation be allowed therefor.

  • Existence; Business and Properties (a) Do or cause to be done all things necessary to preserve, renew and keep in full force and effect its legal existence, except, in the case of a Subsidiary of the Borrower, where the failure to do so would not reasonably be expected to have a Material Adverse Effect, and except as otherwise permitted under Section 6.05, and except for the liquidation or dissolution of Subsidiaries if the assets of such Subsidiaries to the extent they exceed estimated liabilities are acquired by the Borrower or a Wholly Owned Subsidiary of the Borrower in such liquidation or dissolution; provided, that Subsidiary Loan Parties may not be liquidated into Subsidiaries that are not Loan Parties and Domestic Subsidiaries may not be liquidated into Foreign Subsidiaries (except in each case as permitted under Section 6.05). (b) Except where the failure to do so would not reasonably be expected to have a Material Adverse Effect, do or cause to be done all things necessary to (i) lawfully obtain, preserve, renew, extend and keep in full force and effect the permits, franchises, authorizations, Intellectual Property, licenses and rights with respect thereto necessary to the normal conduct of its business, and (ii) at all times maintain, protect and preserve all property necessary to the normal conduct of its business and keep such property in good repair, working order and condition (ordinary wear and tear excepted), from time to time make, or cause to be made, all needful and proper repairs, renewals, additions, improvements and replacements thereto necessary in order that the business carried on in connection therewith, if any, may be properly conducted at all times (in each case except as permitted by this Agreement).

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!