Permitted Use; Equipment; Location Sample Clauses

Permitted Use; Equipment; Location. The use permitted by this license ---------------------------------- is solely to install, operate, maintain and use, for the sole purpose of reception of communication and data signals, the following: (i) a maximum of two antennas (not more than one (1) Antenna on each Building, respectively housing the Penobscot Space and the Saginaw Space), as defined in Exhibit E hereto (as applicable, the "Antenna" or "Antennas") on the --------- open space of the roof (the "Roof") of the Building in the particular location described on Exhibit E hereto (the "Roof Space"); and --------- (ii) connections for the Antenna(s) for (x) electrical wiring to the Building's existing electrical supply and (y) cable or similar connection necessary to connect the Antenna(s) with Tenant's related equipment located in the Premises. The routes or paths for such connections shall be through the Building's existing risers, conduits and shafts, subject to reasonable space limitations and Landlord's requirements for use of such areas, and in all events subject to Landlord's approval of location, plans and installation pursuant to other provisions of this License (such routes or paths are collectively referred to as the "Cable Path" and all such electrical and other connections are referred to collectively as "Connections"). The Antenna(s) and Connections are collectively referred to as the "Equipment".
Sample 1
AutoNDA by SimpleDocs
Permitted Use; Equipment; Location. The use permitted by the Antenna. License is solely to install, operate, maintain and use, for the purpose of reception and transmission of communication and data signals, the following (a) one or more satellite antennae and related equipment, and other equipment related to and necessary for the conduct of Tenant’s business in the Premises as may be approved by Landlord, which approval shall not be withheld unless the Disapproval Conditions apply (the “Antennae”), to be located on the open space of the roof of the Building in a location designated by Landlord subject to Tenant’s reasonable approval; and (b) connections for the Antennae for (i) electrical wiring to the Building’s existing electrical supply and (ii) cable or similar connection necessary to connect the Antennae with Tenant’s related equipment located in the Premises. The routes or paths for such wiring and connections shall be through the Building’s existing risers, conduits and shafts, subject to reasonable space limitations and Landlord’s reasonable requirements for use of such areas, and in all events subject to Landlord’s reasonable approval of plans and installation pursuant to other provisions of this Antenna License, which approval shall not be withheld unless the Disapproval Conditions apply (all such electrical and other connections are referred to collectively as “Antennae Connections”). The Antennae and Antennae Connections are collectively referred to as the “Antennae Equipment”.
Sample 1
Permitted Use; Equipment; Location. The use permitted by the License is solely to install, operate, maintain and use the following: (a) One (1) satellite dish having a diameter not greater than twenty-four (24) inches ("Satellite Dish") on the space of the roof of the Building in a location reasonably determined by Landlord (the "Dish Roof Area"); and (b) connections for the Satellite Dish for (i) electrical wiring to the Building's existing electrical supply and (ii) cable or similar connection necessary to connect the Satellite Dish with Tenant's related equipment located in the Premises. The Satellite Dish shall be solely for the purpose of Tenant's and subtenant's use. The routes or paths for such wiring and connections shall be through the Building's existing risers, conduits and shafts, subject to reasonable space limitations and Landlord's reasonable requirements for use of such areas, and in all events subject to Landlord's reasonable approval of plans and installation pursuant to other provisions of this License (such routes or paths are collectively referred to as the "Dish Cable Path" and all such electrical and other connections are referred to collectively as "Dish Connections"). The Satellite Dish and Dish Connections are collectively referred to as the "Dish Equipment."
Sample 1
Permitted Use; Equipment; Location. The uses permitted by the Roof Top License are solely for the following: (a) install, operate, maintain and use, for the purpose of reception of communication and data signals, (i) one satellite dish and antennae system (with the dish having dimensions not greater than 36 inches by 36 inches) and related roof mount (the “Antenna”) on the open space of the roof of the Building in a location to be designated by Landlord (the “Antenna Roof Area”); and (ii) connections for the Antenna for (x) electrical wiring to the Building’s existing electrical supply and (y) cable or similar connection necessary to connect the Antenna with Tenant’s related equipment located in the Premises; and (b) install, operate, maintain and use, for the purposes of cooling the Premises, (i) up to four (4) rooftop condensers and related roof mounts (the “Condensers”) on the open space of the roof of the Building in a location to be reasonably designated by Landlord and such area having dimension of not greater than 10 feet by 10 feet (the “Condenser Roof Area”); and (ii) connections for the Condensers for electrical wiring to the Building’s existing electrical supply to connect the Condensers with Tenant’s related equipment located in the Premises. The “Antenna Roof Area” and the “Condenser Roof Area” are sometimes collectively referred to as the “Roof Top Area.” The routes or paths for any wiring and connections shall be through the Building’s existing risers, conduits and shafts, subject to space limitations and Landlord’s reasonable requirements for use of such areas, and in all events subject to Landlord’s reasonable approval of plans and installation pursuant to other provisions of this Article 36 (such routes or paths are collectively referred to as the “Cable Path” and all such electrical and other connections are referred to collectively as “Connections”). The Antenna, the Condensers and the Connections are sometimes collectively referred to as the “Roof Top Equipment.”
Sample 1

Related to Permitted Use; Equipment; Location

  • Equipment Location The Company recognizes that it is important when designing, constructing, and maintaining physical plant components, to have regard for the specific placement of equipment, with a view to the elimination of hazardous work situations. Accordingly, wherever practical to do so, new installations, or the rebuild of existing installations, will be designed accordingly.

  • Project Location [Insert the location of the Project, if applicable]

  • Work Location While employed by the Company hereunder, the Executive shall perform his duties (when not traveling or engaged elsewhere in the performance of his duties) at the offices of the Company in Bermuda. The Executive shall travel to such places on the business of the Company in such manner and on such occasions as the Company may from time to time reasonably require.

  • Office Space, Equipment and Facilities Provide such office space, office equipment and office facilities as are adequate to fulfill the Adviser’s obligations hereunder.

  • Program Location A. Unless otherwise agreed upon in writing, the parties acknowledge and agree that the Work of this Agreement will be performed at the following Property address: Ktr Address1 Address2

  • Data Location 1.1. The CONTRACTOR shall not store or transfer non-public COUNTY data outside of the United States. This includes backup data and Disaster Recovery locations. The CONTRACTOR will permit its personnel and contractors to access COUNTY data remotely only as required to provide technical support. (Remote access to data from outside the continental United States is prohibited unless approved in advance and in writing by the County.) 1.2. The CONTRACTOR must notify the COUNTY in advance and in writing of any location changes to CONTRACTOR’s data center(s) that will process or store County data.

  • Business Locations Set forth on Schedule 6.20(a) is a list of all Real Properties located in the United States that are owned or leased by the Loan Parties as of the Closing Date. Set forth on Schedule 6.20(b) is a list of all locations where any tangible personal property of a Loan Party is located as of the Closing Date. Set forth on Schedule 6.20(c) is the chief executive office, jurisdiction of incorporation or formation and principal place of business of each Loan Party as of the Closing Date.

  • Office Equipment The Client must not install any cabling, IT or telecom connections without the Provider’s consent, which the Provider may refuse at its absolute discretion.

  • Access to Work Locations Reasonable access to employee work locations shall be granted officers of the Association and their officially designated representatives for the purpose of processing grievances or contacting members of the Association concerning business within the scope of representation. Such officers or representatives shall not enter any work location without the consent of the City Manager. Access shall be restricted so as not to interfere with the normal operations of the department or with established safety or security requirements. Solicitation of membership and activities concerned with the internal management of the Association, such as collecting dues, holding membership meetings, campaigning for office, conducting elections and distributing literature, shall not be conducted during working hours.

  • Rental Equipment 7.1 We will at all times own all Rental Equipment supplied to you. You will not let, sell, charge, assign, sub-license or allow a third party to use the Rental Equipment nor remove any labels, and shall not prejudice our rights in the Rental Equipment in any way. We may replace the Rental Equipment from time to time either with your prior consent or provided that the replacement Rental Equipment is of a specification that is at least equal to the Rental Equipment originally supplied and such change does not materially disrupt the provision of the Services. 7.2 Subject to the other terms of this paragraph 7, we (or our authorised representative) shall, during our usual working hours: 7.2.1 where necessary install the Rental Equipment at your premises at a time and date agreed with you; and 7.2.2 use our reasonable endeavours to repair any faults to the Rental Equipment in accordance with our standard procedures (which are available on request). 7.3 It is your responsibility to look after the Rental Equipment that is in your possession or custody and you agree to pay for the Rental Equipment to be replaced or repaired if it is lost, stolen or damaged. 7.4 You will notify us promptly of any faults which occur, any repairs which become necessary, and of any loss, theft or damage to the Rental Equipment. 7.5 You agree that you will only use the Rental Equipment in conjunction with the relevant Services and shall comply with our reasonable instructions in relation to its use. 7.6 You shall be responsible for maintaining adequate cover in place to insure the Rental Equipment while it remains in your possession and custody. You will also be responsible for obtaining and, where appropriate, paying for all necessary licenses, consents and approvals required for the installation and use of the Rental Equipment. 7.7 You will not (and you will ensure that no-one else will) repair, alter, modify or maintain, or make any additions or attachments to, or otherwise alter, the Rental Equipment without our prior written consent. We will not be liable for any costs or charges incurred, faults caused by, or repairs required as a result of, installation or programming of Rental Equipment that is carried out by any other person (other than our employees or agents). You agree to indemnify us for all losses, damages and expenses that are brought against or incurred by us, arising as a result of the same. 7.8 On expiry or termination of the Agreement or the relevant Service, all Rental Equipment must be returned to us in reasonable condition, subject to reasonable wear and tear. If you fail to return or make available for collection the Rental Equipment in a reasonable condition or at all we may, at our option, invoice you for a sum equal to the original cost of the Rental Equipment less any depreciation together with any costs reasonably incurred by us. 7.9 In the event that you return Rental Equipment to us and it is not received by us, in the absence of reasonable evidence that the Rental Equipment has been delivered to us you accept that you shall remain liable for the Rental Equipment.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!