Explosives Explosives or other highly flammable substances shall not be stored or used on Railroad's property without the prior written approval of Railroad.
Safety Glasses Section 1. The City shall supply prescription safety glasses with plastic lenses to employees who are required to wear safety glasses and who are members of the classifications contained in Appendix C to this contract. Safety glasses which are authorized must be industrial grade safety glasses which meet or exceed the requirements of ANSI Specification Z87. 1. All employees who are required to wear safety glasses shall also be required to wear side xxxxxxx, either permanent or snap-on, whenever an eye hazard exists. Solid tinted glasses will not be approved unless required by prescription. Photogray, progressive, scratch coating and/or anti-glare lenses may be considered for those employees who primarily work outdoors or as prescribed. In the event that additional classes are identified as needing either prescription safety glasses or protective eyewear, such classes may be added to the classification list in Appendix C upon approval of PAGE and the City. Section 2. The City agrees to pay the full cost of required prescription safety glasses, with frames not to exceed $75.00. This excludes the cost of the eye examination which will be the responsibility of the employee. The effected employees will be allowed one (1) replacement of safety glasses every two (2) years. In the event the safety glasses become lost, unserviceable, or broken on the job, the employee must present a written request for replacement to the Department Head and Human Resources Director. If the employee breaks his safety glasses while on the job, the Department shall replace the glasses at no cost to the employee. The replacement of lost glasses or glasses that are broken off the job will be at the discretion of the Department Head and Human Resources Director. If an employee has been provided safety glasses by the City, the employee shall be permitted to retain possession of the glasses after separation from the City without reimbursing the City for any costs associated with the glasses. Section 3. An employee who is required to wear prescription safety glasses must present a written request to his department head or designated representative. Section 4. The employee must obtain a current prescription and the employee is authorized the use of sick leave not to exceed two (2) hours to accomplish this examination. The employee will obtain a purchase order from the Department Head prior to ordering the safety glasses. The employee will present the purchase order to the appropriate vendor when ordering. The vendor will contact the appropriate Department Head when the glasses are ready for delivery. The Department Head will then notify the employee who will present himself at the vendor for fitting and pickup. Section 5. In the event a probationary employee has been issued safety glasses and terminates his employment with the City for any reason during the probationary period, he shall be required to reimburse the City for any expenses incurred in the purchase of safety glasses.
Prescription Glasses This plan covers prescription glasses as follows: • Frames - one (1) collection frame per plan year; • Lenses - one (1) pair of glass or plastic collection lenses per plan year. This includes single vision, bifocal, trifocal, lenticular, and standard progressive lenses. This plan covers the following lens treatments: • UV treatment; • tint (fashion, gradient, and glass-grey); • standard plastic scratch coating; • standard polycarbonate; and • photocromatic/transitions plastic. This plan covers one (1) supply of contact lenses as follows: • conventional contact lenses - one (1) pair per plan year from a selection of • extended wear disposable lenses - up to a 6-month supply of monthly or two- week single vision spherical or toric disposable contact lenses per plan year; or • daily wear disposable lenses - up to a 3-month supply of daily single vision spherical disposable contact lenses per plan year. This plan also covers the evaluation, fitting, or follow-up care related to contact lenses. This plan covers additional contact lenses if your prescribing network provider submits a verification form, with the regular claim form, verifying that you have one of the following conditions: • anisometropia of 3D in meridian powers; • high ametropia exceeding -10D or +10D in meridian powers; • keratoconus when the member’s vision is not correctable to 20/25 in either or both eyes using standard spectacle lenses; and • vision improvement for members whose vision can be corrected two lines of improvement on the visual acuity chart when compared to the best corrected standard spectacle lenses.
Prescription Safety Glasses Prescription safety glasses will be furnished by the employer. The employer retains the authority to establish reasonable rules and procedures regarding frequency of issue, replacement of damaged glasses, limits on reimbursement costs and coordination with the employer's vision plan.
Medications Psychotropic medications and medications associated with treating a diagnosed mental health condition.
Labeling Upon request, Lessee will xxxx the Equipment indicating Lessor's interest with labels provided by Lessor. Lessee will keep all Equipment free from any other marking or labeling which might be interpreted as a claim of ownership.
Prescription Drugs The agreement may impose a variety of limits affecting the scope or duration of benefits that are not expressed numerically. An example of these types of treatments limit is preauthorization. Preauthorization is applied to behavioral health services in the same way as medical benefits. The only exception is except where clinically appropriate standards of care may permit a difference. Mental disorders are covered under Section A. Mental Health Services. Substance abuse disorders are covered under
SHOP DRAWINGS, PRODUCT DATA AND SAMPLES 4.12.1 Shop Drawings are drawings, diagrams, schedules and other, data specially prepared for the Work by the Contractor or any Subcontractor, manufacturer, supplier or distributor to illustrate some portion of the Work. 4.12.2 Product Data are illustrations, standard schedules, performance charts, instructions, brochures, diagrams and other information furnished by the Contractor to illustrate a material, product or system for some portion of the Work. 4.12.3 Samples are physical examples which illustrate materials, equipment or workmanship and establish standards by which the Work will be judged. 4.12.4 The Contractor shall review, approve and submit, with reasonable promptness and in such sequence as to cause no delay in the Work or in the work of the State or any separate contractor, all Shop Drawings, Product Data and Samples required by the Contract Documents. 4.12.5 By approving and submitting Shop Drawings, Product Data and Samples, the Contractor represents that he / she has determined and verified all materials, field measurements, and field construction criteria related thereto, or will do so, and that he / she has checked and coordinated the information contained within such submittals with the requirements of the Work and of the Contract Documents. 4.12.6 The Contractor shall not be relieved of responsibility for any deviation from the requirements of the Contract Documents by the Architect's approval of Shop Drawings, Product Data or Samples under Subparagraph 2.2.7 of these General Conditions unless the Contractor has specifically informed the Architect and the State in writing of such deviation at the time of sub- mission and the Architect and the State has given written approval to the specific deviation. The Contractor shall not be relieved from responsibility for errors or omissions in the Shop Drawings, Product Data or Samples by the Architect's approval thereof. 4.12.7 The Contractor shall direct specific attention, in writing or on resubmitted Shop Drawings, Product Data or Samples, to revisions other than those requested by the Architect on previous submittals. 4.12.8 No portion of the Work requiring submission of a Shop Drawing, Product Data or Sample shall be commenced until the submittal has been approved by the Architect as provided in Subparagraph 2.2.7 of these General Conditions. All such portions of the Work shall be in accordance with approved submittals.
Infectious Diseases The Employer and the Union desire to arrest the spread of infectious diseases in the nursing home. To achieve this objective, the Joint Health and Safety Committee may review and offer input into infection control programs and protocols including surveillance, outbreak control, isolation, precautions, worker education and training, and personal protective equipment. The Employer will provide training and ongoing education in communicable disease recognition, use of personal protective equipment, decontamination of equipment, and disposal of hazardous waste.
Firearms The Resident agrees to comply with University policy which states that firearms are not allowed on University property, and acknowledges that California Penal Code section 626.9 prohibits the possession of firearms on University of California property.
