Common use of Quality of Process Clause in Contracts

Quality of Process. The Contractor shall perform the Services in a manner consistent with the Specifications and any Quality Control and Assurance Plan attached as Schedule H (provided, however, that nothing in such Quality Control and Assurance Plan shall limit the Contractor’s responsibilities under the Specifications or otherwise under this Agreement). The Services shall further be performed in a good, safe and workmanlike manner and in compliance with this Agreement, all Laws, the rules, policies and procedures of the University, and all codes standards and specifications as may be applicable to the Services including, without limitation, those set forth below. a. Occupational Safety and Health Administration (OSHA) requirements; b. University policies and the provisions of the University’s “Construction, Service and Maintenance Contractors Manual”. The referenced manual can be found here: xxxx://xxx.xxxxx.xxx/ppp/Contractor_EHS_Manual.pdf; c. CHRO: As applicable, the laws and regulations enforced by the Commission on Human Rights and Opportunity and the Equal Employment Opportunity Commission; and d. University Standards and Requirements: The standards set by the University through the University’s Representative for the Services, now existing and as may be communicated from time to time by the University’s Representative to the Contractor.

Quality of Process. The Contractor shall perform the Services in a manner consistent with the Specifications and any Quality Control and Assurance Plan attached as Schedule H (provided, however, that nothing in such Quality Control and Assurance Plan shall limit the Contractor’s responsibilities under the Specifications or otherwise under this Agreement). The Services shall further be performed in a good, safe and workmanlike manner and in compliance with this Agreement, all Laws, the rules, policies and procedures of the University, and all codes standards and specifications as may be applicable to the Services including, without limitation, those set forth below. a. . Occupational Safety and Health Administration (OSHA) requirements; b. ; University policies and the provisions of the University’s “Construction, Service and Maintenance Contractors Manual”. The referenced manual can be found here: xxxx://xxx.xxxxx.xxx/ppp/Contractor_EHS_Manual.pdf; c. ; CHRO: As applicable, the laws and regulations enforced by the Commission on Human Rights and Opportunity and the Equal Employment Opportunity Commission; and d. and University Standards and Requirements: The standards set by the University through the University’s Representative for the Services, now existing and as may be communicated from time to time by the University’s Representative to the Contractor.