RAILING OF STAIR CASE Sample Clauses

RAILING OF STAIR CASE. Railing of Iron/ Stainless steel 10.STAIR CASE PAINTING : Putty on inside Wall & Colour.
AutoNDA by SimpleDocs
RAILING OF STAIR CASE. Railing of Iron
RAILING OF STAIR CASE. Railing of Iron/ Stainless steel
RAILING OF STAIR CASE. Railing of iron. 10 STAIR CASE PAINTING: Plaster of Paris with colour. 11 LIFT: Standard Quality Lift.

Related to RAILING OF STAIR CASE

  • Service Commencement Date The date the Transmission Provider begins to provide service pursuant to the terms of an executed Service Agreement, or the date the Transmission Provider begins to provide service in accordance with Section 15.3 or Section 29.1 under the Tariff.

  • Heating of Room Throughout the Term the Manager will provide a heating system sufficient to provide a comfortable temperature in the Room and will operate, maintain and repair that heating system. During any period in which the heating system is not functioning to the standards set out above, the Manager will use commercially reasonable efforts, after receiving notice of the deficiency, to have the system repaired and functioning as soon as may be possible in the circumstances. In no event however, is the Manager liable to the Resident for any consequential illness or discomfort and the Manager shall not be deemed to be in default of its obligations under this Agreement, so long as it is using commercially reasonable efforts to have the system repaired.

  • Installation and Conversion State Street and the Fund shall be responsible for the technical installation and conversion (“Installation and Conversion”) of the Designated Configuration. The Fund shall have the following responsibilities in connection with Installation and Conversion of the System: (i) The Fund shall be solely responsible for the timely acquisition and maintenance of the hardware and software that attach to the Designated Configuration in order to use the Data Access Services at the Designated Locations, and (ii) State Street and the Fund each agree that they will assign qualified personnel to actively participate during the Installation and Conversion phase of the System implementation to enable both parties to perform their respective obligations under this Addendum.

  • Provisioning Line Splitting and Splitter Space 3.8.1 The Data LEC, Voice CLEC or BellSouth may provide the splitter. When Southern Telecom or its authorized agent owns the splitter, Line Splitting requires the following: a non-designed analog Loop from the serving wire center to the NID at the End User’s location; a collocation cross connection connecting the Loop to the collocation space; a second collocation cross connection from the collocation space connected to a voice port; the high frequency spectrum line activation, and a splitter. The Loop and port cannot be a Loop and port combination (i.e. UNE-P), but must be individual stand-alone Network Elements. When BellSouth owns the splitter, Line Splitting requires the following: a non designed analog Loop from the serving wire center to the NID at the End User’s location with CFA and splitter port assignments, and a collocation cross connection from the collocation space connected to a voice port. 3.8.2 An unloaded 2-wire copper Loop must serve the End User. The meet point for the Voice CLEC and the Data LEC is the point of termination on the MDF for the Data LEC's cable and pairs. 3.8.3 The foregoing procedures are applicable to migration to Line Splitting Service from a UNE-P arrangement, BellSouth Retail Voice Service, BellSouth High Frequency Spectrum (CO Based) Line Sharing. 3.8.4 For other migration scenarios to line splitting, BellSouth will work cooperatively with CLECs to develop methods and procedures to develop a process whereby a Voice CLEC and a Data LEC may provide services over the same Loop.

  • Commencement of Final Design This contract does not obligate the State to proceed with final design for any alternative. On completion of environmental documentation, the State will consider all reasonable alternatives in a fair and objective manner. Notwithstanding anything contained elsewhere in the contract or in any work authorization, the Engineer may not proceed with final design until after all relevant environmental decision documents have been issued.

  • Certification of Meeting or Exceeding Tobacco-Free Workplace Policy Minimum Standards A. Grantee certifies that it has adopted and enforces a Tobacco-Free Workplace Policy that meets or exceeds all of the following minimum standards of: i. Prohibiting the use of all forms of tobacco products, including but not limited to cigarettes, cigars, pipes, water pipes (hookah), bidis, kreteks, electronic cigarettes, smokeless tobacco, snuff and chewing tobacco; ii. Designating the property to which this Policy applies as a "designated area,” which must at least comprise all buildings and structures where activities funded under this Grant Agreement are taking place, as well as Grantee owned, leased, or controlled sidewalks, parking lots, walkways, and attached parking structures immediately adjacent to this designated area; iii. Applying to all employees and visitors in this designated area; and iv. Providing for or referring its employees to tobacco use cessation services. B. If Grantee cannot meet these minimum standards, it must obtain a waiver from the System Agency.

  • Recognition of the U.S. Special Resolution Regimes (i) In the event that any Underwriter that is a Covered Entity becomes subject to a proceeding under a U.S. Special Resolution Regime, the transfer from such Underwriter of this Agreement, and any interest and obligation in or under this Agreement, will be effective to the same extent as the transfer would be effective under the U.S. Special Resolution Regime if this Agreement, and any such interest and obligation, were governed by the laws of the United States or a state of the United States. (ii) In the event that any Underwriter that is a Covered Entity or a BHC Act Affiliate of such Underwriter becomes subject to a proceeding under a U.S. Special Resolution Regime, Default Rights under this Agreement that may be exercised against such Underwriter are permitted to be exercised to no greater extent than such Default Rights could be exercised under the U.S. Special Resolution Regime if this Agreement were governed by the laws of the United States or a state of the United States. As used in this Section 16(e):

  • Recognition of U.S. Special Resolution Regimes (a) In the event a Covered Party becomes subject to a proceeding under a U.S. Special Resolution Regime, the transfer of this Agreement (and any interest and obligation in or under, and any property securing, this Agreement) from such Covered Party will be effective to the same extent as the transfer would be effective under the U.S. Special Resolution Regime if this Agreement (and any interest and obligation in or under, and any property securing, this Agreement) were governed by the laws of the United States of America or a State of the United States of America. (b) In the event that a Covered Party or any BHC Affiliate of such Covered Party becomes subject to a proceeding under a U.S. Special Resolution Regime, any Default Right under this Agreement that may be exercised against such Covered Party is permitted to be exercised to no greater extent than such Default Right could be exercised under the U.S. Special Resolution Regime if this Agreement were governed by the laws of the United States of America or a State of the United States of America.

  • Tenants Selection of Contractors Tenant shall retain Landlord’s contractor, Commerce Construction Co., L.P. (the “Contractor”), as general contractor for the performance of the Work.

  • Site Selection 5.1.1 If the parties have not designated the street address of the Franchised Location on Exhibit A on the Effective Date, Franchisee shall identify, submit and obtain Franchisor’s prior written approval of the Franchised Location meeting the requirements of this Agreement prior to entering a lease or sublease for the Franchised Location. Franchisee shall provide Franchisor all information required by Franchisor, as determined by Franchisor in Franchisor’s sole determination, necessary for Franchisor to evaluate the Franchised Location. Franchisor shall have ten (10) business days to review Franchisee’s written site proposal for the Franchised Location and notify Franchisee of its approval or disapproval in writing. Franchisor’s failure to respond within ten (10) business days shall signify Franchisor’s disapproval of the site. Franchisor shall not unreasonably withhold Franchisor’s approval of a proposed site for the Franchised Location. 5.1.2 Franchisee must have a site for the Franchised Location approved by Franchisor, receive the opening notice from Franchisor described in Section 5.4 below, and open Franchisee’s Franchised Business for business within six (6) months from the Effective Date, except as otherwise provided in Section 5.1.3 All matters related in any way to Franchisee’s site are Franchisee’s sole responsibility, regardless of any assistance Franchisor may choose to provide. Franchisee is responsible for obtaining any architectural and engineering services required for Franchisee’s facility and for ensuring its compliance with local law. Neither Franchisor, nor any other person or company associated with Franchisor shall have any liability for any site‐related matter. Xxxxxxxxxx agrees not to make any claims against Franchisor and/or any of Franchisor’s affiliates or associates with regard to such matters. 5.1.4 If Franchisor makes a loan to Franchisee for (i) Franchisee’s purchase of the franchise for the Franchised Business; (ii) the remodeling of the Franchised Location; (iii) the transfer of any interest in this franchise or this Agreement; or (iv) any other purpose; Franchisee shall open (or re‐open, as the case may be), the Franchised Business for business within sixty (60) days from the loan origination date.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!