Please see the current Washtenaw Community College catalog for up-to-date program requirements Conditions & Requirements
Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.
System Upgrade Facilities and System Deliverability Upgrades Connecting Transmission Owner shall design, procure, construct, install, and own the System Upgrade Facilities and System Deliverability Upgrades described in Appendix A hereto. The responsibility of the Developer for costs related to System Upgrade Facilities and System Deliverability Upgrades shall be determined in accordance with the provisions of Attachment S to the NYISO OATT.
Lessee's Compliance with Applicable Requirements Except as otherwise provided in this Lease, Lessee shall, at Lessee's sole expense, fully, diligently and in a timely manner, materially comply with all Applicable Requirements, the requirements of any applicable fire insurance underwriter or rating bureau, and the recommendations of Lessor's engineers and/or consultants which relate in any manner to the Premises, without regard to whether said requirements are now in effect or become effective after the Start Date. Lessee shall, within ten (10) days after receipt of Lessor's written request, provide Lessor with copies of all permits and other documents, and other information evidencing Lessee's compliance with any Applicable Requirements specified by Lessor, and shall immediately upon receipt, notify Lessor in writing (with copies of any documents involved) of any threatened or actual claim, notice, citation, warning, complaint or report pertaining to or involving the failure of Lessee or the Premises to comply with any Applicable Requirements.
Certification of Meeting or Exceeding Tobacco-Free Workplace Policy Minimum Standards A. Grantee certifies that it has adopted and enforces a Tobacco-Free Workplace Policy that meets or exceeds all of the following minimum standards of: i. Prohibiting the use of all forms of tobacco products, including but not limited to cigarettes, cigars, pipes, water pipes (hookah), bidis, kreteks, electronic cigarettes, smokeless tobacco, snuff and chewing tobacco; ii. Designating the property to which this Policy applies as a "designated area,” which must at least comprise all buildings and structures where activities funded under this Grant Agreement are taking place, as well as Grantee owned, leased, or controlled sidewalks, parking lots, walkways, and attached parking structures immediately adjacent to this designated area; iii. Applying to all employees and visitors in this designated area; and iv. Providing for or referring its employees to tobacco use cessation services. B. If Grantee cannot meet these minimum standards, it must obtain a waiver from the System Agency.
Annual Reports on Assessment of Compliance with Servicing Criteria (a) On or before March 1 of each year commencing in March 2018, the Master Servicer, the Special Servicer, the Certificate Administrator, the Custodian, the Operating Advisor and, if it has made (or is required to make) an Advance during the applicable calendar year, the Trustee, each at its own expense, shall furnish (and each of the preceding parties, as applicable, (i) with respect to any Servicing Function Participant of such party that is a Mortgage Loan Seller Sub-Servicer, shall use commercially reasonable efforts to cause such Servicing Function Participant to furnish, and (ii) with respect to any other Servicing Function Participant of such party (other than any party to this Agreement), shall cause such Servicing Function Participant to furnish) (each Master Servicer, the Special Servicer, the Certificate Administrator, the Custodian, the Operating Advisor, any Servicing Function Participant and, if it has made (or is required to make) an Advance during the applicable calendar year, the Trustee, as the case may be, a “Reporting Servicer”) to the Certificate Administrator, the Trustee, the Serviced Companion Loan Holders (or, in the case of a Serviced Companion Loan that is part of an Other Securitization Trust, the applicable Other Depositor and Other Exchange Act Reporting Party), the Operating Advisor (only in the case of a report furnished by the Special Servicer) and the Depositor, a report on an assessment of compliance with the Relevant Servicing Criteria (together with a copy thereof in XXXXX-Compatible Format, or in such other format as otherwise agreed upon by the Depositor, the Certificate Administrator, the applicable Other Depositor, the applicable Other Exchange Act Reporting Party and the applicable Certifying Servicer) that complies in all material respects with the requirements of Item 1122 of Regulation AB and contains (A) a statement by such Reporting Servicer of its responsibility for assessing compliance with the Relevant Servicing Criteria, (B) a statement that such Reporting Servicer used the Servicing Criteria to assess compliance with the Relevant Servicing Criteria, (C) such Reporting Servicer’s assessment of compliance with the Relevant Servicing Criteria as of the end of and for the preceding calendar year, including, if there has been any material instance of noncompliance with the Relevant Servicing Criteria, a discussion of each such failure and the nature and status thereof and (D) a statement that a registered public accounting firm has issued an attestation report on such Reporting Servicer’s assessment of compliance with the Relevant Servicing Criteria as of and for such period. Copies of all compliance reports delivered pursuant to this Section 10.09 shall be provided to any Certificateholder, upon the written request thereof, by the Certificate Administrator. Each such report shall be addressed to the Depositor and each Other Depositor (if addressed) and signed by an authorized officer of the applicable company, and shall address each of the Relevant Servicing Criteria specified on a certification substantially in the form of Exhibit O to this Agreement delivered to the Depositor on the Closing Date. Promptly after receipt of each such report, (i) the Depositor and each Other Depositor may review each such report and, if applicable, consult with the each Reporting Servicer as to the nature of any material instance of noncompliance with the Relevant Servicing Criteria, and (ii) the Certificate Administrator shall confirm that the assessments, taken individually address the Relevant Servicing Criteria for each party as set forth on Exhibit O to this Agreement and notify the Depositor of any exceptions. For the avoidance of doubt, the Trustee shall have no obligation or duty to determine whether any such report (other than any such report furnished by the Trustee or any Servicing Function Participant of the Trustee) is in form and substance in compliance with the requirements of Regulation AB. (b) On the Closing Date, the Master Servicer, the Special Servicer, the Certificate Administrator, the Custodian, the Trustee and the Operating Advisor each acknowledge and agree that Exhibit O to this Agreement sets forth the Relevant Servicing Criteria for such party. (c) No later than the end of each fiscal year for the Trust, the Master Servicer, the Special Servicer, the Certificate Administrator, the Custodian, the Operating Advisor and, if it has made (or is required to make) an Advance during such fiscal year, the Trustee shall notify the Certificate Administrator, the Depositor, each Other Exchange Act Reporting Party and each Other Depositor as to the name of each Servicing Function Participant utilized by it, and the Certificate Administrator shall notify the Depositor and each Other Depositor as to the name of each Servicing Function Participant utilized by it, during such fiscal year, and each such notice will specify what specific Servicing Criteria will be addressed in the report on assessment of compliance prepared by such Servicing Function Participant. When the Master Servicer, the Special Servicer, the Certificate Administrator, the Custodian, the Trustee (if applicable), the Operating Advisor and any Servicing Function Participant submit their assessments pursuant to Section 10.09(a) of this Agreement, such parties will also at such time include the assessment (and related attestation pursuant to Section 10.10 of this Agreement) of each Servicing Function Participant engaged by it. The fiscal year for the Trust shall be January 1 through and including December 31 of each calendar year. (d) In the event the Master Servicer, the Special Servicer, the Certificate Administrator, the Custodian, the Trustee (if it has made, or is required to make, an Advance during the applicable period) or the Operating Advisor is terminated or resigns pursuant to the terms of this Agreement, such party shall provide, and each such party shall cause (or, if the Servicing Function Participant is a Mortgage Loan Seller Sub-Servicer, shall use commercially reasonable efforts to cause) any Servicing Function Participant of such party to provide (and the Master Servicer, the Special Servicer and the Certificate Administrator shall, with respect to any Servicing Function Participant that resigns or is terminated under any applicable servicing agreement, cause such Servicing Function Participant (or, in the case of each Servicing Function Participant that is a Mortgage Loan Seller Sub-Servicer, shall use commercially reasonable efforts to cause such Servicing Function Participant) to provide) an annual assessment of compliance pursuant to this Section 10.09, coupled with an attestation as required in Section 10.10 of this Agreement with respect to the period of time that the Master Servicer, the Special Servicer, the Certificate Administrator, the Custodian, the Trustee (if it has made, or is required to make, an Advance during such period of time) or the Operating Advisor was subject to this Agreement or the period of time that the applicable Servicing Function Participant was subject to such other servicing agreement. With respect to each Outside Serviced Mortgage Loan serviced under the applicable Outside Servicing Agreement, the Certificate Administrator shall use commercially reasonable efforts to obtain, and upon receipt deliver to the Depositor, an annual report on assessment of compliance as described in this Section and an attestation as described in Section 10.10 from the related Outside Servicer, Outside Special Servicer, Outside Custodian, Outside Trustee and Outside Paying Agent or Outside Certificate Administrator and in form and substance similar to the annual report on assessment of compliance described in this Section 10.09 and the attestation described in Section 10.10.
Unbundled Loop Modifications (Line Conditioning 2.5.1 Line Conditioning is defined as routine network modification that BellSouth regularly undertakes to provide xDSL services to its own customers. This may include the removal of any device, from a copper Loop or copper Subloop that may diminish the capability of the Loop or Subloop to deliver high-speed switched wireline telecommunications capability, including xDSL service. Such devices include, load coils, excessive bridged taps, low pass filters, and range extenders. Excessive bridged taps are bridged taps that serves no network design purpose and that are beyond the limits set according to industry standards and/or the BellSouth’s TR 73600 Unbundled Local Loop Technical Specification. 2.5.2 BellSouth will remove load coils only on copper Loops and Subloops that are less than eighteen thousand (18,000) feet in length. 2.5.3 For any copper loop being ordered by NewPhone which has over six thousand (6,000) feet of combined bridged tap will be modified, upon request from NewPhone, so that the loop will have a maximum of six thousand (6,000) feet of bridged tap. This modification will be performed at no additional charge to NewPhone. Loop conditioning orders that require the removal of bridged tap that serves no network design purpose on a copper Loop that will result in a combined total of bridged tap between two thousand five hundred (2,500) and six thousand (6,000) feet will be performed at the rates set forth in Exhibit A. 2.5.4 NewPhone may request removal of any unnecessary and non-excessive bridged tap (bridged tap between zero (0) and two thousand five hundred (2,500) feet which serves no network design purpose), at rates pursuant to BellSouth’s SC Process as mutually agreed to by the Parties. 2.5.5 Rates for ULM are as set forth in Exhibit A. 2.5.6 BellSouth will not modify a Loop in such a way that it no longer meets the technical parameters of the original Loop type (e.g., voice grade, ADSL, etc.) being ordered. 2.5.7 If NewPhone requests ULM on a reserved facility for a new Loop order, BellSouth may perform a pair change and provision a different Loop facility in lieu of the reserved facility with ULM if feasible. The Loop provisioned will meet or exceed specifications of the requested Loop facility as modified. NewPhone will not be charged for ULM if a different Loop is provisioned. For Loops that require a DLR or its equivalent, BellSouth will provide LMU detail of the Loop provisioned. 2.5.8 NewPhone shall request Loop make up information pursuant to this Attachment prior to submitting a service inquiry and/or a LSR for the Loop type that NewPhone desires BellSouth to condition. 2.5.9 When requesting ULM for a Loop that BellSouth has previously provisioned for NewPhone, NewPhone will submit a SI to BellSouth. If a spare Loop facility that meets the Loop modification specifications requested by NewPhone is available at the location for which the ULM was requested, NewPhone will have the option to change the Loop facility to the qualifying spare facility rather than to provide ULM. In the event that BellSouth changes the Loop facility in lieu of providing ULM, NewPhone will not be charged for ULM but will only be charged the service order charges for submitting an order.
Notice of Non-Compliant Work A Notice of Non-Compliant Work shall be in writing, shall be dated, shall be signed by the Design Professional, and shall be addressed to the Contractor with a copy to the Owner, as set forth in Section 3, Part 4 (Correcting the Work) and Section 6, Part 6 (Correcting the Work after Final Payment).
Compliance with Accessibility Standards All parties to this Agreement shall ensure that the plans for and the construction of all projects subject to this Agreement are in compliance with standards issued or approved by the Texas Department of Licensing and Regulation (TDLR) as meeting or consistent with minimum accessibility requirements of the Americans with Disabilities Act (P.L. 101-336) (ADA).