Specific Conditions If applicable, specific conditions required after a risk assessment will be included in Exhibit G. Grantee shall adhere to the specific conditions listed therein.
Conditions for Participation III. 1.1) Suitability to pursue the professional activity, including requirements relating to enrolment on professional or trade registers
Conditions for Advance and Conditions to Closing Section 7.1.
Buyer’s Conditions for Closing Unless otherwise waived in writing, and without prejudice to Buyer’s right to terminate this Contract during the Review Period, the duties and obligations of Buyer to proceed to Closing under the terms and provisions of this Contract are and shall be expressly subject to strict compliance with, and satisfaction or waiver of, each of the conditions and contingencies set forth in this Section 9.1, each of which shall be deemed material to this Contract. In the event of the failure of any of the conditions set forth in this Section 9.1 or of any other condition to Buyer’s obligations provided for in this Contract, which condition is not waived in writing by Buyer, Buyer shall have the right at its option to terminate this Contract, in which case the Xxxxxxx Money Deposit shall be immediately returned to Buyer and each of the parties shall be relieved from further liability to the other, except as otherwise expressly provided herein, with respect to this Contract. (a) All of Seller’s representations and warranties contained in or made pursuant to this Contract shall be true and correct in all material respects as if made again on the Closing Date. (b) Buyer shall have received all of the instruments and conveyances listed in Section 10.2. (c) Seller shall have performed, observed and complied in all material respects with all of the covenants, agreements, closing requirements and conditions required by this Contract to be performed, observed and complied with by Seller, as and when required hereunder. (d) Third Party Consents in form and substance reasonably satisfactory to Buyer shall have been obtained and furnished to Buyer. (e) The Existing Franchise Agreement shall have been terminated. (f) The Existing Management Agreement shall have been terminated and Buyer and the Manager shall have executed and delivered the New Management Agreement consistent with the form attached hereto as Exhibit E. (g) Buyer and Franchisor shall have executed (or Franchisor has unconditionally committed to execute) the New Franchise Agreement. (h) Seller shall have complied, in all material respects, with its obligations under the thirteen (13) other purchase contracts (“Other Contracts”), each of even date herewith and all of which are more particularly described on Exhibit K hereto; and Seller shall be unconditionally prepared to close on the sale of the hotel properties described in the Other Contracts (“Other Properties”) simultaneously with Closing on the Property.
Conditions for Closing The Lender shall not be obligated to disburse the Bridge Loan until the Borrower shall have fulfilled and/or furnished to the Lender, at the Borrower’s own cost and expense, the following conditions (unless waived in writing by Lender): (a) The Loan Documents duly executed by the Borrower and each Guarantor (as applicable) along with evidence that all financing statements and other filings contemplated thereby have been made and the Security Documents to be placed of record or filed shall have been duly executed and recorded and filed in all appropriate offices and shall constitute a first and prior Lien on the Collateral, subject only to those matters set forth in Section 6.01 of this Agreement and all taxes, fees and charges in connection therewith shall have been paid. (b) Evidence, in form and substance satisfactory to the Lender, that the Aircraft, business and all assets of the Borrower are adequately insured as required by Section 5.04. (c) Payment of the Origination Fee and all reimbursable costs and expenses pursuant to the Loan Documents, together with evidence of payment to other parties of all fees and costs which Borrower is required under the Loan Documents to pay by the Closing Date. (d) Lien searches (including Uniform Commercial Code, judgments, bankruptcy and taxes) with respect to the Borrower and each Guarantor (at the state and county level) from the jurisdiction of its organization and each other jurisdiction in which it maintains an office, including the home airport of the Aircraft, (i) showing no existing Liens on the Collateral pledged by such Persons except as permitted hereunder or (ii) accompanied by necessary termination statements, release statements and any other types of release in connection with any impermissible Liens disclosed by such searches that have been filed or for which satisfactory arrangements have been made for such filing on the Closing Date. (e) With respect to the Aircraft, (i) an FAA and International Registry lien and title search acceptable to the Lender, (ii) a copy of Aircraft Registration Certificate, (iii) lien and title searches of the applicable Canadian government authorities, including without limitation under the Personal Property Security Act, in form acceptable to the Lender, (iv) evidence that the Borrower has become a Transaction User Entity (as defined in the International Registry) and appointed an administrator and a professional registry user entity, in form and substance satisfactory to the Lender, (v) reasonable evidence that the Aircraft is eligible for prompt issuance of a U.S. Certificate of Airworthiness following the Aircraft’s transfer of title to Borrower, (vi) Completed Customs and Border Protection Forms 7501 and 3461 evidencing importation into the U.S., and (vii) a copy of the airframe, engine, and avionics maintenance programs. (f) Copies of all of the Aircraft Contracts in effect as of the Closing Date, in form and substance reasonably acceptable to the Lender. (g) A copy of the Borrower’s and each Guarantor’s organizational documents, in form and substance satisfactory to the Lender. (h) A certificate of existence, authorization, good standing certificate, or its equivalent of each of the Borrower and the Guarantor from the Secretary of State of such Person’s jurisdiction of incorporation/formation/organization and the Secretary of State of each other jurisdiction in which such Person is qualified to do business as a foreign corporation/company/partnership, if any. (i) A certificate in form and substance satisfactory to Lender from the Borrower and each Guarantor, dated the Closing Date and signed on behalf of such Person by an authorized member/manager/officer of such Person certifying as to (i) true copies of the organizational documents of such Person and any amendments thereto, (ii) the resolutions of the directors/managers and/or shareholders/members (as the case may be) of such Person authorizing the execution and delivery of this Agreement and the other Loan Documents to which it is a party and (iii) the names, true signatures and incumbency of the members/managers/officers of such Person authorized to execute and deliver the Loan Documents to which it is a party. The Lender may conclusively rely on such certification unless and until a later certificate revising the prior certificate has been furnished to the Lender. (j) A certification regarding the beneficial ownership of the Borrower, as required by the Bank Secrecy Act (31 C.F.R. §1010.230 et. seq.), as amended from time to time, the regulations promulgated thereunder, and any successor statute, in form and substance satisfactory to the Lender. (k) Evidence, in form and substance acceptable to the Lender, that the Borrower has a tangible balance sheet equity of at least twenty percent (20%) on the Closing Date. (l) An opinion of counsel on behalf of the Borrower and the Guarantor, dated the Closing Date, in form and substance satisfactory to the Lender in absolute discretion. (m) An opinion of special FAA counsel, including an International Registry Priority Search Certificate, each dated the Closing Date, in form and substance satisfactory to the Lender in absolute discretion. (n) Listing of furniture, fixtures and equipment owned by the Borrower or a certification that the Borrower does not own any, satisfactory in form and content to the Lender, indicating that the estimated value of such furniture, fixtures and equipment. (o) An inventory of all Warranties (including copies all documentation with respect thereto) relating to the Aircraft. (p) The Borrower shall have executed and delivered all forms, documentation and information necessary for the establishment of the Cash Collateral Account at Lender, and shall have funded the Cash Collateral into the Cash Collateral Account (either prior to the Closing Date or contemporaneously therewith). (q) Such other instruments, documents, certificates, assurances and opinions as may be set forth in the preliminary closing checklist delivered to the Borrower in connection with this Agreement or as the Lender shall reasonably require to evidence and secure the Loan, to comply with the provisions hereof and the requirements of regulatory authorities to which the Lender is subject, all of which, including those referred to above in this Section 4.01 shall be satisfactory in form, content and substance to the Lender.
Terms & Conditions The Contractor agrees to comply with the Terms and Conditions.
Conditions for Award of Contract The Borrower shall not award any Works contract which involves environmental impacts until:
Attachment C, Standard State Provisions for Contracts and Grants Attachment C is hereby deleted in its entirety and replaced by the Attachment C December 15, 2017 attached to this Amendment. Child Support (Applicable to natural persons only; not applicable to corporations, partnerships or LLCs). Contractor is under no obligation to pay child support or is in good standing with respect to or in full compliance with a plan to pay any and all child support payable under a support order as of the date of this amendment.
Provisions for Payment The Securities shall be issuable as registered Securities and in the denominations of one thousand U.S. dollars ($1,000) or any integral multiple thereof, subject to Section 2.01(a)(13). The Securities of a particular series shall bear interest payable on the dates and at the rate specified with respect to that series. Subject to Section 2.01(a)(23), the principal of and the interest on the Securities of any series, as well as any premium thereon in case of redemption or repurchase thereof prior to maturity, and any cash amount due upon conversion or exchange thereof, shall be payable in the coin or currency of the United States of America that at the time is legal tender for public and private debt, at the office or agency of the Company maintained for that purpose. Each Security shall be dated the date of its authentication. Interest on the Securities shall be computed on the basis of a 360-day year composed of twelve 30-day months. The interest installment on any Security that is payable, and is punctually paid or duly provided for, on any Interest Payment Date for Securities of that series shall be paid to the Person in whose name said Security (or one or more Predecessor Securities) is registered at the close of business on the regular record date for such interest installment. In the event that any Security of a particular series or portion thereof is called for redemption and the redemption date is subsequent to a regular record date with respect to any Interest Payment Date and prior to such Interest Payment Date, interest on such Security will be paid upon presentation and surrender of such Security as provided in Section 3.03. Any interest on any Security that is payable, but is not punctually paid or duly provided for, on any Interest Payment Date for Securities of the same series (herein called “Defaulted Interest”) shall forthwith cease to be payable to the registered holder on the relevant regular record date by virtue of having been such holder; and such Defaulted Interest shall be paid by the Company, at its election, as provided in clause (1) or clause (2) below:
Applications for Payment 9.3.1 At least ten days before the date for each progress payment established in the State- Contractor Agreement, the Contractor shall submit to the Architect an itemized Application for Payment, notarized if required, supported by such data substantiating the Contractor's right to payment as the State or the Architect may require. The application for payment must, at a minimum, reflect retainage and the required waivers of lien and any other support documentation enumerated elsewhere in the Contract Documents. 9.3.2 Unless otherwise provided in the Contract Documents, payments will be made on account of materials or equipment not incorporated in the Work but delivered and suitably stored at the site and, if approved in advance by the State, payments may similarly be made for materials or equipment suitably stored at some other location agreed upon in writing. Payments for materials or equipment stored on or off the site shall be conditioned upon submission by the Contractor of bills of sale or such other procedures satisfactory to the State to establish the State's title to such materials or equipment or otherwise protect the State's interest, including applicable insurance and transportation to the site for those materials and equipment stored off the site. 9.3.3 The Contractor warrants that title to all Work, materials and equipment covered by an Application for Payment will pass to the State either by incorporation in the construction or upon the receipt of payment by the Contractor, whichever occurs first, free and clear of all liens, claims, security interests or encumbrances, hereinafter referred to in this Article 9 as "liens"; and that no Work, materials or equipment covered by an Application for Payment will have been acquired by the Contractor, or by any other person performing Work at the site or furnishing materials and equipment for the Project, subject to an agreement under which an interest therein or an encumbrance thereon is retained by the seller or otherwise imposed by the Contractor or such other person.