Subsidy for television drama productions
Subsidy for television Sample Clauses
Related to Subsidy for television
Television Equipment Recycling Program If this Contract is for the purchase or lease of covered television equipment, then Contractor certifies that it is compliance with Subchapter Z, Chapter 361 of the Texas Health and Safety Code related to the Television Equipment Recycling Program.
MIDDLE SCHOOLS 1. Where there are no negotiated provisions concerning the implementation or operation of a middle school program, this article shall govern the implementation or operation of a middle school program in a school district. 2. Should the employer seek to establish a middle school program in one or more schools in a district, the employer and the local shall meet, no later than ten (10) working days from a decision of the employer to implement a middle school program, in order to negotiate any alternate or additional provisions to the Collective Agreement which are necessary to accommodate the intended middle school program. 3. In the absence of any other agreement with respect to the instructional day and preparation time, the provisions of the Collective Agreement with regard to secondary schools shall apply to middle schools. 4. If the employer and the local are unable to agree on what, if any, alternate or additional provisions of the collective agreement are necessary to accommodate the intended middle school program(s), either party may refer the matter(s) in dispute to expedited arbitration for final and binding resolution pursuant to Article D.5.5 below. a. The jurisdiction of the arbitrator shall be limited to the determination of alternate or additional provisions necessary to accommodate the intended middle school program(s). b. In the event the arbitration is not concluded prior to the implementation of the middle school program, the arbitrator will have remedial authority to make appropriate retroactive modifications and adjustments to the agreement. c. The arbitration shall convene within thirty (30) working days of referral to arbitration in accordance with the following: i. Within ten (10) working days of the matter being referred to arbitration, the parties shall identify all issues in dispute; ii. Within a further five (5) working days, there shall be a complete disclosure of particulars and documents; iii. Within a further five (5) working days, the parties shall exchange initial written submissions; iv. The hearing shall commence within a further ten (10) working days; and v. The arbitrator shall render a final and binding decision within fifteen (15) working days of the arbitration concluding. 6. Where a middle school program has been established on or prior to ratification of the 2006-2011 Provincial Collective Agreement, the existing provisions shall be retained unless the parties mutually agree that they should be amended.
Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx has requested an Unbundled Loop and BellSouth uses IDLC systems to provide the local service to the End User and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will implement one of the following alternative arrangements for Xxxx (e.g. hairpinning): 1. Roll the circuit(s) from the IDLC to any spare copper that exists to the customer premises. 2. Roll the circuit(s) from the IDLC to an existing DLC that is not integrated. 3. If capacity exists, provide "side-door" porting through the switch. 4. If capacity exists, provide "Digital Access Cross Connect System (DACS)- door" porting (if the IDLC routes through a DACS prior to integration into the switch). 2.6.2 Arrangements 3 and 4 above require the use of a designed circuit. Therefore, non- designed Loops such as the SL1 voice grade and UCL-ND may not be ordered in these cases. 2.6.3 If no alternate facility is available, and upon request from Xxxx, and if agreed to by both Parties, BellSouth may utilize its Special Construction (SC) process to determine the additional costs required to provision facilities. Xxxx will then have the option of paying the one-time SC rates to place the Loop.
Unbundled Copper Loop – Designed (UCL-D) 2.4.2.1 The UCL-D will be provisioned as a dry copper twisted pair (2- or 4-wire) Loop that is unencumbered by any intervening equipment (e.g., filters, load coils, range extenders, digital loop carrier, or repeaters). 2.4.2.2 A UCL-D will be 18,000 feet or less in length and is provisioned according to Resistance Design parameters, may have up to 6,000 feet of bridged tap and will have up to 1300 Ohms of resistance. 2.4.2.3 The UCL-D is a designed circuit, is provisioned with a test point, and comes standard with a DLR. OC is a chargeable option for a UCL-D; however, OC is always required on UCLs where a reuse of existing facilities has been requested by Telepak Networks. 2.4.2.4 These Loops are not intended to support any particular services and may be utilized by Telepak Networks to provide a wide-range of telecommunications services as long as those services do not adversely affect BellSouth’s network. This facility will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the Loop to the customer’s inside wire. 2.4.2.5 Upon the Effective Date of this Agreement, Unbundled Copper Loop – Long (UCL-L) elements will no longer be offered by BellSouth and no new orders for UCL-L will be accepted. Any existing UCL-Ls that were provisioned prior to the Effective Date of this Agreement will be grandfathered at the rates set forth in the Parties’ interconnection agreement that was in effect immediately prior to the Effective Date of this Agreement. Existing UCL-Ls that were provisioned prior to the Effective Date of this Agreement may remain connected, maintained and repaired according to BellSouth’s TR73600 and may remain connected until such time as they are disconnected by Telepak Networks or BellSouth provides ninety
Unbundled Network Element Combinations 5.1. Unbundled Network Element Combinations shall include: 1) Enhanced Extended Links (EELs); 2) UNE Loops/Special Access Combinations; 3) Loop/Port Combinations; and 4)
Unbundled Copper Loop – Non-Designed (UCL-ND 2.4.3.1 The UCL–ND is provisioned as a dedicated 2-wire metallic transmission facility from BellSouth’s Main Distribution Frame to a customer’s premises (including the NID). The UCL-ND will be a “dry copper” facility in that it will not have any intervening equipment such as load coils, repeaters, or digital access main lines (“DAMLs”), and may have up to 6,000 feet of bridged tap between the end user’s premises and the serving wire center. The UCL-ND typically will be 1300 Ohms resistance and in most cases will not exceed 18,000 feet in length, although the UCL-ND will not have a specific length limitation. For loops less than 18,000 feet and with less than 1300 Ohms resistance, the loop will provide a voice grade transmission channel suitable for loop start signaling and the transport of analog voice grade signals. The UCL-ND will not be designed and will not be provisioned with either a DLR or a test point. 2.4.3.2 The UCL-ND facilities may be mechanically assigned using BellSouth’s assignment systems. Therefore, the Loop Make Up process is not required to order and provision the UCL-ND. However, Lightyear can request Loop Make Up for which additional charges would apply. 2.4.3.3 At an additional charge, BellSouth also will make available Loop Testing so that Lightyear may request further testing on the UCL-ND. Rates for Loop Testing are as set forth in Exhibit B of this Attachment. 2.4.3.4 UCL-ND loops are not intended to support any particular service and may be utilized by Lightyear to provide a wide-range of telecommunications services so long as those services do not adversely affect BellSouth’s network. The UCL-ND will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the loop to the customer’s inside wire. 2.4.3.5 Order Coordination (OC) will be provided as a chargeable option and may be utilized when the UCL-ND provisioning is associated with the reuse of BellSouth facilities. Order Coordination -Time Specific (OC-TS) does not apply to this product. 2.4.3.6 Lightyear may use BellSouth’s Unbundled Loop Modification (ULM) offering to remove bridge tap and/or load coils from any loop within the BellSouth network. Therefore, some loops that would not qualify as UCL-ND could be transformed into loops that do qualify, using the ULM process.
Software Ownership If Contractor develops or pays to have developed computer software exclusively with funds or proceeds from the Contract to perform its obligations under the Contract, or to perform computerized tasks that it was not previously performing to meet its obligations under the Contract, the computer software shall be exclusively owned by or licensed to the Department. If Contractor develops or pays to have developed computer software which is an addition to existing software owned by or licensed exclusively with funds or proceeds from the Contract, or to modify software to perform computerized tasks in a manner different than previously performed, to meet its obligations under the Contract, the addition shall be exclusively owned by or licensed to the Department. In the case of software owned by the Department, the Department grants to Contractor a nontransferable, nonexclusive license to use the software in the performance of the Contract. In the case of software licensed to the Department, the Department grants to Contractor permission to use the software in the performance of the Contract. This license or permission, as the case may be, terminates when Contractor has completed its work under the Contract. If Contractor uses computer software licensed to it which it does not modify or program to handle the specific tasks required by the Contract, then to the extent allowed by the license agreement between Contractor and the owner of the software, Contractor grants to the Department a continuing, nonexclusive license for either the Department or a different contractor to use the software in order to perform work substantially identical to the work performed by Contractor under the Contract. If Contractor cannot grant the license as required by this section, then Contractor shall reveal the input screens, report formats, data structures, linkages, and relations used in performing its obligations under the contract in such a manner to allow the Department or another contractor to continue the work performed by contractor under the Contract.
Vlastnictví Zdravotnické zařízení si ponechá a bude uchovávat Zdravotní záznamy. Zdravotnické zařízení a Zkoušející převedou na Zadavatele veškerá svá práva, nároky a tituly, včetně práv duševního vlastnictví k Důvěrným informacím (ve smyslu níže uvedeném) a k jakýmkoli jiným Studijním datům a údajům.
Games The Private Party shall not be entitled to introduce any arcade type amusement or gaming machines into the Restaurant Facility without the prior written approval of SANParks.
Foreign-Owned Companies in Connection with Critical Infrastructure If Texas Government Code, Section 2274.0102(a)(1) (relating to prohibition on contracts with certain foreign-owned companies in connection with critical infrastructure) is applicable to this Contract, pursuant to Government Code Section 2274.0102, Contractor certifies that neither it nor its parent company, nor any affiliate of Contractor or its parent company, is: (1) majority owned or controlled by citizens or governmental entities of China, Iran, North Korea, Russia, or any other country designated by the Governor under Government Code Section 2274.0103, or (2) headquartered in any of those countries.
