Unbundled Copper Loop – Non-Designed (UCL-ND 2.4.3.1 The UCL–ND is provisioned as a dedicated 2-wire metallic transmission facility from BellSouth’s Main Distribution Frame to a customer’s premises (including the NID). The UCL-ND will be a “dry copper” facility in that it will not have any intervening equipment such as load coils, repeaters, or digital access main lines (“DAMLs”), and may have up to 6,000 feet of bridged tap between the end user’s premises and the serving wire center. The UCL-ND typically will be 1300 Ohms resistance and in most cases will not exceed 18,000 feet in length, although the UCL-ND will not have a specific length limitation. For loops less than 18,000 feet and with less than 1300 Ohms resistance, the loop will provide a voice grade transmission channel suitable for loop start signaling and the transport of analog voice grade signals. The UCL-ND will not be designed and will not be provisioned with either a DLR or a test point. 2.4.3.2 The UCL-ND facilities may be mechanically assigned using BellSouth’s assignment systems. Therefore, the Loop Make Up process is not required to order and provision the UCL-ND. However, Lightyear can request Loop Make Up for which additional charges would apply. 2.4.3.3 At an additional charge, BellSouth also will make available Loop Testing so that Lightyear may request further testing on the UCL-ND. Rates for Loop Testing are as set forth in Exhibit B of this Attachment. 2.4.3.4 UCL-ND loops are not intended to support any particular service and may be utilized by Lightyear to provide a wide-range of telecommunications services so long as those services do not adversely affect BellSouth’s network. The UCL-ND will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the loop to the customer’s inside wire. 2.4.3.5 Order Coordination (OC) will be provided as a chargeable option and may be utilized when the UCL-ND provisioning is associated with the reuse of BellSouth facilities. Order Coordination -Time Specific (OC-TS) does not apply to this product. 2.4.3.6 Lightyear may use BellSouth’s Unbundled Loop Modification (ULM) offering to remove bridge tap and/or load coils from any loop within the BellSouth network. Therefore, some loops that would not qualify as UCL-ND could be transformed into loops that do qualify, using the ULM process.
Unbundled Copper Loop – Designed (UCL-D) 2.4.2.1 The UCL-D will be provisioned as a dry copper twisted pair (2- or 4-wire) Loop that is unencumbered by any intervening equipment (e.g., filters, load coils, range extenders, digital loop carrier, or repeaters). 2.4.2.2 A UCL-D will be 18,000 feet or less in length and is provisioned according to Resistance Design parameters, may have up to 6,000 feet of bridged tap and will have up to 1300 Ohms of resistance. 2.4.2.3 The UCL-D is a designed circuit, is provisioned with a test point, and comes standard with a DLR. OC is a chargeable option for a UCL-D; however, OC is always required on UCLs where a reuse of existing facilities has been requested by Telepak Networks. 2.4.2.4 These Loops are not intended to support any particular services and may be utilized by Telepak Networks to provide a wide-range of telecommunications services as long as those services do not adversely affect BellSouth’s network. This facility will include a Network Interface Device (NID) at the customer’s location for the purpose of connecting the Loop to the customer’s inside wire. 2.4.2.5 Upon the Effective Date of this Agreement, Unbundled Copper Loop – Long (UCL-L) elements will no longer be offered by BellSouth and no new orders for UCL-L will be accepted. Any existing UCL-Ls that were provisioned prior to the Effective Date of this Agreement will be grandfathered at the rates set forth in the Parties’ interconnection agreement that was in effect immediately prior to the Effective Date of this Agreement. Existing UCL-Ls that were provisioned prior to the Effective Date of this Agreement may remain connected, maintained and repaired according to BellSouth’s TR73600 and may remain connected until such time as they are disconnected by Telepak Networks or BellSouth provides ninety
Company Intellectual Property The Executive agrees to promptly disclose to the Company any and all work product, inventions, artistic works, works of authorship, designs, methods, processes, technology, patterns, techniques, data, Confidential Information, patents, trade secrets, trademarks, domain names, copyrights, and the like, and all other intellectual property relating to the business of the Company and any of its affiliates which are created, authored, composed, invented, discovered, performed, perfected, or learned by the Executive (either solely or jointly with others) during the Employment Term (collectively, together with such intellectual property as may be owned or acquired by the Company, the “Company Intellectual Property”). The Company Intellectual Property shall be the sole and absolute property of the Company and its affiliates. All work performed by the Executive in authoring, composing, inventing, creating, developing or modifying Company Intellectual Property and/or other work product to which copyright protection may attach during the course of the Executive’s employment with the Company shall be considered “works made for hire” to the extent permitted under applicable copyright law and will be considered the sole property of the Company. To the extent such works, work product or Company Intellectual Property are not considered “works made for hire,” all right, title, and interest to such works, work product and Company Intellectual Property, including, but not limited to, all copyrights, patents, trademarks, rights of publicity, and trade secrets, is hereby assigned to the Company and the Executive agrees, at the Company’s expense, to execute any documents requested by the Company or any of its affiliates at any time in relation to such assignment. The Executive acknowledges and agrees that the Company is and will be the sole and absolute owner of all trademarks, service marks, domain names, patents, copyrights, trade dress, trade secrets, business names, rights of publicity, inventions, proprietary know-how and information of any type, whether or not in writing, and all other intellectual property used by the Company or held for use in the business of the Company, including all Company Intellectual Property. The Executive further acknowledges and agrees that any and all derivative works, developments, or improvements based on intellectual property, materials and assets subject to this Section 6 created during the Employment Term (including, without limitation, Company Intellectual Property) shall be exclusively owned by the Company. The Executive will cooperate with the Company and any of its affiliates, at no additional cost to such parties (whether during or after the Employment Term), in the confirmation, registration, protection and enforcement of the rights and property of the Company and its affiliates in such intellectual property, materials and assets, including, without limitation, the Company Intellectual Property.
Removal of DXC Trademarks Supplier shall remove from all Products rejected, returned or not purchased by DXC, DXC’s name and any of DXC’s trademarks, trade names, insignia, part numbers, symbols, and decorative designs, prior to any other sale, use, or disposition of such Products by Supplier.
CONFIDENTIAL/TRADE SECRET MATERIALS a. Contractor Confidential, trade secret or proprietary materials as defined by the laws of the State of New York must be clearly marked and identified as such upon submission by the Bidder. Marking the Bid as “confidential” or “proprietary” on its face or in the document header or footer shall not be considered by the Commissioner or Authorized User to be sufficient without specific justification as to why disclosure of particular information in the Bid would cause substantial injury to the competitive position of the Bidder. Bidders/Contractors intending to seek an exemption from disclosure of these materials under the Freedom of Information Law must request the exemption in writing, setting forth the reasons for the claimed exemption. Acceptance of the claimed materials does not constitute a determination on the exemption request, which determination will be made in accordance with statutory procedures. Properly identified information that has been designated confidential, trade secret, or proprietary by the Bidder will not be disclosed except as may be required by the Freedom of Information Law or other applicable State and federal laws.
OWNERSHIP IN INTELLECTUAL PROPERTY The Department and Contractor agree that each has no right, title, interest, proprietary or otherwise in the intellectual property owned or licensed by the other, unless otherwise agreed upon by the parties in writing. All deliverables, documents, records, programs, data, articles, memoranda, and other materials not developed or licensed by Contractor prior to the execution of this Contract, but specifically created or manufactured under this Contract shall be considered work made for hire, and Contractor shall transfer any ownership claim to the Department.
Anti-Dilution Rights (a) If at any time after the date hereof the Company declares or authorizes any dividend (other than a cash dividend), stock split, reverse stock split, combination, exchange of Shares, or there occurs any recapitalization, reclassification (including any consolidation or merger), sale or acquisition of property or stock, reorganization or liquidation, or if the outstanding Shares are changed into the same or a different number of Shares of the same or another class or classes of stock of the Company, then the Company shall cause effective provision to be made so that the Holder shall, upon exercise of this Warrant following such event, be entitled to receive the number of shares of stock or other securities or the cash or property of the Company (or of the successor corporation or other entity resulting from any consolidation or merger) to which the Warrant Shares (and any other securities) deliverable upon the exercise of this Warrant would have been entitled if this Warrant had been exercised immediately prior to the earlier of (i) such event and (ii) the record date, if any, set for determining the stockholders entitled to participate in such event, and the Exercise Price shall be adjusted appropriately so that the aggregate amount payable by the Holder upon the full exercise of this Warrant remains the same. The Company shall not effect any recapitalization, reclassification (including any consolidation or merger) unless, upon the consummation thereof, the successor corporation or entity shall assume by written instrument the obligation to deliver to the Holder the shares of stock, securities, cash or property that the Holder shall be entitled to acquire in accordance with the foregoing provisions, which instrument shall contain provisions calculated to ensure for the Holder, to the greatest extent practicable, the benefits provided for in this Warrant. (b) If, pursuant to the provisions of this paragraph 7, the Holder would be entitled to receive shares of stock or other securities upon the exercise of this Warrant in addition to the Shares issuable upon exercise of this Warrant, then the Company shall at all times reserve and keep available sufficient shares of other securities to permit the Company to issue such additional shares or other securities upon the exercise of this Warrant. (c) The Company shall at any time if so requested by the Holder furnish a written summary of all adjustments made pursuant to this paragraph 7 promptly following any such request.
Business Combination Marketing Agreement The Company and the Representative have entered into a separate business combination marketing agreement substantially in the form filed as an exhibit to the Registration Statement (the “Business Combination Marketing Agreement”).
SOURCE CODE ESCROW FOR LICENSED PRODUCT If Source Code or Source Code escrow is offered by either Contractor or Product manufacturer or developer to any other commercial customers, Contractor shall either: (i) provide Licensee with the Source Code for the Product; or (ii) place the Source Code in a third party escrow arrangement with a designated escrow agent who shall be named and identified to the State, and who shall be directed to release the deposited Source Code in accordance with a standard escrow agreement acceptable to the State; or (iii) will certify to the State that the Product manufacturer/developer has named the State, acting by and through the Authorized User, and the Licensee, as a named beneficiary of an established escrow arrangement with its designated escrow agent who shall be named and identified to the State and Licensee, and who shall be directed to release the deposited Source Code in accordance with the terms of escrow. Source Code, as well as any corrections or enhancements to such source code, shall be updated for each new release of the Product in the same manner as provided above and such updating of escrow shall be certified to the State in writing. Contractor shall identify the escrow agent upon commencement of the Contract term and shall certify annually that the escrow remains in effect in compliance with the terms of this clause. The State may release the Source Code to Licensees under this Contract who have licensed Product or obtained services, who may use such copy of the Source Code to maintain the Product.
Purchase Rights Fundamental Transactions In addition to any adjustments pursuant to Section 10 above, if at any time the Company grants, issues or sells any options, convertible securities or rights to purchase stock, warrants, securities or other property pro rata to the record holders of Common Stock (“Purchase Rights”), then the Holder will be entitled to acquire, upon the terms applicable to such Purchase Rights, the aggregate Purchase Rights which the Holder could have acquired if the Holder had held the number of shares of Common Stock acquirable upon complete exercise of this Warrant immediately before the date on which a record is taken for the grant, issuance or sale of such Purchase Rights, or, if no such record is taken, the date as of which the record holders of shares of Common Stock are to be determined for the grant, issue or sale of such Purchase Rights.
