Two-Phase Flow Sample Clauses

Two-Phase Flow. Sw = [1 + (αβℓℓ' Pcℓℓ' )n ]−m (3.6) where βℓℓ' is the scaling coefficient for fluid pair ℓ and ℓ' ; α and n are the adjustable parameters, and m = 1−1/n. The implementation of this model in the simulator includes scaling with intrinsic permeability
Sample 1
AutoNDA by SimpleDocs
Two-Phase Flow. Sw = [1 + (αβAA' P cAA' )n ]−m (3.6) where βAA' is the scaling coefficient for fluid pair A and A'; α and n are the adjustable parameters, and m = 1−1/n. The implementation of this model in the simulator includes scaling with intrinsic permeability (k) and porosity (φ) where α is replaced by α k . β is approximated by the ratio of water-air interfacial φ tension (σaw) to the interfacial tension of the fluid pair. Here and elsewhere the subscript w applies to either water or microemulsion for the case of two-phase flow with oil. βAA' = σaw / σAA'
Sample 1

Related to Two-Phase Flow

  • Production Phase contract period in which the Development and the Production are to be performed.

  • Construction Phase Fee Contractor’s Construction Phase Fee is the maximum amount payable to Contractor for any cost or profit expectation incurred in the performance of the Work that is not specifically identified as being eligible for reimbursement by Owner elsewhere in this Agreement. References in the UGSC to Contractor’s “overhead” and “profit” mean Contractor’s Construction Phase Fee. The Construction Phase Fee includes, but is not limited to, the following items:

  • Development Phase contractual phase initiated with the approval of ANP for the Development Plan and which is extended during the Production Phase while investments in xxxxx, equipment, and facilities for the Production of Oil and Gas according to the Best Practices of the Oil Industry are required.

  • Construction Phase Services 3.1.1 – Basic Construction Services

  • Design Phase Services § 3.2.1 The Architect shall review the program and other information furnished by the Owner, and shall review laws, codes, and regulations applicable to the Architect’s services.

  • Design Phase All Basic Services set forth in the Agreement with the exception of Interdisciplinary Document Coordination Review, conducting a Card Trick session, Value-Engineering services, Estimating services. Bidding Phase • All Basic Services set forth in the Agreement. Construction Phase • All Basic Services set forth in the Agreement. Post-Construction • All Basic Services set forth in the Agreement.

  • Programming Phase 2.2.1.2. Schematic Design Phase: 2.2.1.3. Design Development Phase:

  • Preconstruction Phase Services Preconstruction Phase Services shall mean all services described in Article 3.1, and any similar services described in the Request for Proposals, including such similar services as are described in the Construction Manager at Risk’s Response to the Request for Proposals to the extent they are accepted by Owner, but excluding any Early Work. Early Work shall be considered part of Construction Phase Services.

  • Construction Phase Part 1 –

  • Design Development Phase INDICATE IN STATEMENT OF WORK “NOT APPLICABLE” IF SECTION IS NOT APPLICABLE

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!