Acceptable Quality Level definition

Acceptable Quality Level means the maximum percentage of failing vehi- cles that for purposes of sampling in- spection, can be considered satisfac- tory as a process average.
Sample 1Sample 2Sample 3
Acceptable Quality Level is the minimum performance of each requirement before the Government considers performance unsatisfactory. Specification of an acceptable quality level does not allow the Contractor to knowingly provide defective service; instead, it is recognition of the fact that defective performance may sometimes occur unintentionally. As long as performance does not fall below the specified acceptable performance level, the Government will not deduct for poor performance.
Sample 1
Acceptable Quality Level. (AQL) means the minimum level of performance that is acceptable. Failure to achieve the AQL renders the service being provided by the contractor unacceptable.
Sample 1

Examples of Acceptable Quality Level in a sentence

  • The Government shall use these standards to determine contractor performance and shall compare contractor performance to the Acceptable Quality Level (AQL).

  • AQL: Using ANSI Z1.4-2008: Acceptable Quality Level will be equal to 10% of the sample size for the surveillance period.

  • Sampling PlanUnless there is other agreement, the sampling plan for incoming inspection shall follow MIL-STD-105E LEVEL II.2.1 Lot size: Quantity per shipment as one lot (different model as different lot ).2.2 Sampling type: Normal inspection, single sampling.2.3 Sampling level: Level II.2.4 AQL: Acceptable Quality Level Major defect: AQL=0.65 Minor defect: AQL=1.0 3.

  • Service Provider shall be required to meet a minimum Acceptable Quality Level (AQL).

  • However, there is an Acceptable Quality Level (AQL) that will be provided for a newly Novated Contractor, which will allow for more than a single contract year to meet Production Standards for the following contract year and allow for less than the standard three Participation credits in the contract year the Contractor is Novated.

  • Analysis is based on an Acceptable Quality Level (AQL) of 90 percent.

  • IAW TB MED 530, Paragraph 4-603.14 AQL: Using ANSI Z1.4-2008: Acceptable Quality Level will be equal to 10% of the sample size for the surveillance period.

  • TB MED 530, Paragraph 5-503.11, Environmental Compliance and Protection Manual, MCO P5090.2. AQL: Using ANSI Z1.4-2008: Acceptable Quality Level will be equal to 10% of the sample size for the surveillance period.

  • The basis of payment for production lots of selected pay items is adjusted using statistical analysis of acceptance test results.Analysis is based on an Acceptable Quality Level (AQL) of 90 percent.

  • For the CuSum plans ref- erenced in these procedures, the prob- ability of acceptance at the Acceptable Quality Level (AQL) is approximately 95 percent.


More Definitions of Acceptable Quality Level

Acceptable Quality Level. (AQL) means the maximum percentage of failing engines that can be considered a satisfactory process average for sampling inspections.
Sample 1

Related to Acceptable Quality Level

  • Reportable quantity means one of the following:

  • Pre-Qualifying Criteria means the criteria set out in clause 27.3 of this Part C.

  • Mean Sea Level means the average height of the sea for all stages of the tide. It is used as a reference for establishing various elevations within the floodplain. For the purposes of this Ordinance, the term is synonymous with the National Geodetic Vertical Datum (NGVD) of 1929, the North American Vertical Datum (NAVD) of 1988, or other datum, to which Base Flood Elevations shown on a community's Flood Insurance Rate Map are referenced.

  • Applicable water quality standards means all water quality standards to which a discharge is subject under the federal Clean Water Act and which has been (a) approved or permitted to remain in effect by the Administrator following submission to the Administrator pursuant to Section 303(a) of the Act, or (b) promulgated by the Director pursuant to Section 303(b) or 303(c) of the Act, and standards promulgated under (APCEC) Regulation No. 2, as amended.

  • Definite quantity contract means a fixed price contract that provides for a

  • Maximum Concentration Level Assessment means the Maximum Concentration Level Assessment for the purposes of a Basic Comprehensive Certificate of Approval, described in the Basic Comprehensive User Guide, prepared by a Toxicologist using currently available toxicological information, that demonstrates that the concentration at any Point of Impingement for a Compound of Concern that does not have a Ministry Point of Impingement Limit is not likely to cause an adverse effect as defined by the EPA. The concentration at Point of Impingement for a Compound of Concern must be calculated in accordance with O. Reg. 419/05.

  • High quality waters means all state waters, except:

  • PJM Region Reliability Requirement means, for purposes of the Base Residual Auction, the Forecast Pool Requirement multiplied by the Preliminary PJM Region Peak Load Forecast, less the sum of all Preliminary Unforced Capacity Obligations of FRR Entities in the PJM Region; and, for purposes of the Incremental Auctions, the Forecast Pool Requirement multiplied by the updated PJM Region Peak Load Forecast, less the sum of all updated Unforced Capacity Obligations of FRR Entities in the PJM Region.

  • Minimum Level (ML means the concentration at which the entire analytical system must give a recognizable signal and an acceptable calibration point. The ML is the concentration in a sample that is equivalent to the concentration of the lowest calibration standard analyzed by a specific analytical procedure, assuming that all the method-specified sample weights, volumes and processing steps have been followed.

  • Water quality volume means the volume equal to the first one-half inch of runoff multiplied by the impervious surface of the land development project.

  • Quality factor (Q) means the modifying factor, listed in Tables I and II of 38.4(4), that is used to derive dose equivalent from absorbed dose.

  • Radiopharmaceutical quality assurance means, but is not limited to, the performance of appropriate chemical, biological, and physical tests on potential radiopharmaceuticals and the interpretation of the resulting data to determine their suitability for use in humans and animals, including internal test assessment, authentication of product history, and the keeping of proper records.

  • National Ambient Air Quality Standards or “NAAQS” means national ambient air quality standards that are promulgated pursuant to Section 109 of the Act, 42 U.S.C. § 7409.

  • Actual weight means the actual unladen weight of a vehicle or combination of

  • Three-Month Term SOFR means the rate for Term SOFR for a tenor of three months that is published by the Term SOFR Administrator at the Reference Time for any Floating Interest Period, as determined by the Calculation Agent after giving effect to the Three-Month Term SOFR Conventions.

  • the qualifying period means the period of 12 years immediately preceding the date of publication of the advertisements referred to in paragraph (A)(iv) above or of the first of the two advertisements to be published if they are published on different dates; and

  • Collateral Quality Test means a test that is satisfied if, as of any date of determination, in the aggregate, the Collateral Loans owned (or in relation to a proposed acquisition of a Collateral Loan, both owned and proposed to be owned) by the Borrower satisfy each of the tests set forth below, calculated in each case in accordance with Section 1.3:

  • Elevated blood lead level means a level of lead in blood that is any of the following:

  • Adjusted Term SOFR Rate means, for any Interest Period, an interest rate per annum equal to (a) the Term SOFR Rate for such Interest Period, plus (b) 0.10%; provided that if the Adjusted Term SOFR Rate as so determined would be less than the Floor, such rate shall be deemed to be equal to the Floor for the purposes of this Agreement.

  • Non-Participating Certified Clinical Nurse Specialist means a Certified Clinical Nurse Specialist who does not have a written agreement with the Claim Administrator or another Blue Cross and/or Blue Shield Plan to provide services to you at the time services are rendered.

  • Swap Specification means, with respect to any Swap, the Rules or other trading protocols containing specifications for such Swap, as adopted, amended, supplemented or otherwise modified from time to time by BSEF.

  • Categorical pretreatment standard or "categorical standard" means any regulation containing pollutant discharge limits promulgated by the environmental protection agency in accordance with sections 307(b) and (c) of the Act (33 U.S.C. section 1317) that apply to a specific category of users and that appear in 40 CFR chapter I, subchapter N, parts 405 through 471.

  • Acceptable earned value management system means an earned value management system that generally complies with system criteria in paragraph (b) of this clause.

  • Collateral Quality Tests means the Collateral Quality Tests set out in the Investment Management Agreement being each of the following:

  • Table E academic outcomes at receiving institution

  • Participating Certified Clinical Nurse Specialist means a Certified Clinical Nurse Specialist who has a written agreement with the Claim Administrator or another Blue Cross and/or Blue Shield Plan to provide services to you at the time services are rendered.