Ammonia Slip definition

Ammonia Slip means emissions of unreacted ammonia that result from incomplete reaction of NOX and the reagent.

Ammonia Slip means that ammonia is released into the atmosphere without being completely consumed at the catalytic reaction. 202. Plans and Data1. Plans and specifications covering the Selective Catalytic Reduction(SCR) system are to be submitted and are, as applicable, to include:(1) General arrangement of the SCR installation, layout, and systems(2) Documentation detailing the SCR specification(3) Documentation demonstrating the 204. 2. (1). (A) (including recommendation from Engine maker)(4) Material specifications for the SCR equipment and associated systems, including blowers, pumps, valves, storage/process tanks, residue tanks, piping(5) Arrangement and capacity of tanks for reductant agents storage(6) Details of all piping systems(7) Descriptions and schematic diagrams for the control and monitoring systems

Ammonia Slip means when ammonia passes unreacted through an SCR system.

Examples of Ammonia Slip in a sentence

• Ammonia Slip – The Hydrogen Reformer Heater shall be tested initially within 180 days of Hydrogen Reformer Heater startup and then again two years later, and thereafter as requested by the Department to demonstrate compliance with the 10 ppm limit.

• Tradeoffs• Ammonia Slip The SCR process requires precise control of the ammonia injection rate.

• Comment VI.2. – Regulating Ammonia Slip as a Precursor to the Formation of Secondary Particulate Matter:The Air District received comments stating that it should undertake a BACT analysis for ammonia slip as a particulate matter precursor, based upon the potential for secondary PM formation.

• This is based in part on, ‘‘Measuring Ammonia Slip from Post Combustion NOX Reduction Systems,’’ James E.

• Appendix IV contains a synopsis of the Ammonia Slip Sampling during the initial performance test.

• Determination of whether acceptable operating and maintenance procedures are being used will be based on information available to the Department and the Administrator which may include, but is not limited to Ammonia Slip, monitoring results, opacity observations, review of operating and maintenance procedures, and inspection of the source.

• CEMEX also shall develop a protocol for operating the SNCR System at an Ammonia Slip setpoint of 15 ppm and to maintain Ammonia Slip below a maximum concentration of 25 ppm while following good engineering practices to minimize NOx emissions from the Lyons Kiln Main Stack.

• The owner or operator shall operate and maintain the SCR in accordance with good air pollution practice for minimizing emissions to the extent practicable, consistent with 40 CFR §60.11(d), taking into consideration the Ammonia Slip.

• CEMEX shall not be considered in violation of this Consent Decree if the Ammonia Slip is below 15 ppm.

• Ammonia Slip – The Hydrogen Reformer Heater shall be tested within two years of the initial source test and thereafter as requested by the Department to demonstrate compliance with the 10 ppm limit.

More Definitions of Ammonia Slip

Ammonia Slip means the amount of unreacted ammonia contained in emissions from the Lyons Kiln Main Stack when the SNCR System is operating as measured by the Ammonia Stack Monitor in parts per million. Ammonia Slip shall be calculated by subtracting Baseline Ammonia from Stack Ammonia;

Ammonia Slip means emissions of unreacted ammonia thatresult from incomplete reaction of NOx and the reagent.