Examples of ASME B31.1 in a sentence
Install hangers and supports to provide indicated pipe slopes and so maximum pipe deflections allowed by ASME B31.1 (for power piping) and ASME B31.9 (for building services piping) are not exceeded.
All insulated pipe supports shall be load rated by the manufacturer based upon testing and analysis in conformance with ASME B31.1, MSS SP-58, MSS SP-69 and MSS SP-89.
Beveling, alignment, heat treatment, and inspection of weld shall conform to ASME B31.1. Weld defects shall be removed and repairs made to the weld, or the weld joints shall be entirely removed and rewelded.
Comply with ASME B31.9 for building services piping and ASME B31.1 for power piping.
Welding procedures qualified by others, and welders and welding operators qualified by another employer, may be accepted as permitted by ASME B31.1. The Contracting Officer shall be notified 24 hours in advance of tests, and the tests shall be performed at the work site if practicable.
Conform to requirements of ASME B31.1. Welders shall show evidence of qualification.
The corrosion allowance is 2 mm (0.08 in) and the design code is ASME B31.1 (Power Piping).
These include steam, natural gas, ammonia, water, wastewater injection, hydrogen and other chemicals, which are jurisdictional to the requirements of ASME B31.1 and B31.3 as, depicted on Figure 3.2.1 – Piping System Code Boundaries.
Backing rings shall conform to ASME B31.1 and be compatible with materials being welded.
Therefore:occasional load criteria of ASME B31.1, paragraph 102.2.4, is applied, and it is assumed that the relief valve failure-to-open event occurs less than 1% of the time.