Correction factor definition

Correction factor means the correction factor calculated in accordance with Article 7(2) of Implementing Regulation (EU) 2017/1153, which was used in calculating the average specific emissions of CO2 of the manufacturer (Table 1) or the pool (Table 2).
Sample 1Sample 2Sample 3
Correction factor means the dif- ference between the equilibrium mois- ture and the inherent moisture in low rank coals for the purpose of § 870.20(a).
Sample 1Sample 2Sample 3
Correction factor means a mathematical adjustment made to a calculation to account for deviations in either the sample or the method of measurement;
Sample 1Sample 2Sample 3

Examples of Correction factor in a sentence

  • Correction factor for 28-day minimum mix design concrete compressive strength (MPa (psi)), as specified in Section 110.10, Table B.

  • Correction factor for minimum allowable concrete compressive strength (MPa (psi)), as specified in Section 110.10, Table B.

  • Referencing the above calculations, these values are influenced by the Correction factor (Ka).

  • Correction factor to be used during the contest will be Superflow correction factors.

  • The SNLOT.DBF file contains the following fields: Part number (partno) Serial/lot number (snlotno) Total current quantity (snlotqty) Vendor's serial/lotnumber (vendlotno) Expiration date (expirdate) Correction factor (corfactor) Revision of part number (revision) The second database file named SNLOTDET contains all the transaction records that were used to increase or decrease the quantity onhand of each serial/lot number.

  • Correction factor is applied during analysis.The energy coming out of plate is written as:Eo = Qconv.j + Qconv.b + Qrad.t.b + Qcond (3)where, Eo – total energy coming out, Qconv.j – heat transfer due to convection by air jet, Qconv.b – heat transfer by convection from bottom side of plate, Qrad.t.b – heat radiated by top and bottom surfaces, and Qcond – heat conducted through plate.

  • Corrected air flow capacity = Air consumption ÷ (Correction factor A x B x C) Corrected air flow capacity = 31 m3/h ÷ (0.83 x 0.83 x 0.92) = 48.9 m3/h3 Select the model.Select the model which air flow capacity exceeds the corrected air flow capacity using the specification table.

  • Rules3.1 Correction factor = bottle area ÷ ring area.3.2 Record on the Single-ring Infiltrometer Data Form.rate” column of data form.5.3 Example:Distance traveled was 5.1 cm.

  • Humidity and air density Correction factor if less than 1.0 shall not be applied.

  • Correction factor = 1.2. Multiply this by the SP value gives the bed corrected SSP for the formation: SSP = 1.2 × –25 mV = -30 mV.


More Definitions of Correction factor

Correction factor means a factor that is applied to a meter reading to convert the volume to the volume at standard conditions. Factors may be applied to correct for deviations of temperature, pressure, altitude and compressibility.
Sample 1Sample 2
Correction factor means the difference between the equilibriummoisture and the inherent moisture in low rank coals for the purpose of§ 870.20(a).
Sample 1
Correction factor is a formula agreed for the adjustment of an Inter-connection financial calculation which data can’t be obtained in full from the call data record (CDR) or the other data sources;
Sample 1
Correction factor shall have the meaning set forth in Section 3.1.3(b).
Sample 1
Correction factor means a factor in the numerator or denominator of the CII formula which adjusts the calculation of the attained CII.
Sample 1
Correction factor means a formula for the financial calculation of Interconnection which data cannot be obtained in full from the calls recording source or any other data sources.
Sample 1

Related to Correction factor

  • Inflation Factor means a number determined for each tax year by dividing the consumer price index for June of the tax year by the consumer price index for June 2005.

  • Required Accumulation Factor Number shall be equal to a fraction, rounded upwards to the nearest whole number, the numerator of which is one and the denominator of which is equal to the lowest monthly principal payment rate on the Accounts, expressed as a decimal, for the three months preceding the date of such calculation.

  • Dilution Factors means, without duplication, with respect to any period, the aggregate amount of all deductions, credit memos, returns, adjustments, allowances, bad debt write-offs and other non-cash credits which are recorded to reduce accounts receivable in a manner consistent with current and historical accounting practices of the Loan Parties.

  • Expansion Factor has the meaning ascribed thereto in Section 2.3(a);

  • Load Factor means the percentage of aircraft seats actually occupied on a flight (RPMs divided by ASMs). “NMB” means the National Mediation Board.

  • emission factor means the average emission rate of a greenhouse gas relative to the activity data of a source stream assuming complete oxidation for combustion and complete conversion for all other chemical reactions;

  • Limited Indexation Factor means, in respect of a Limited Indexation Month or Limited Indexation Date, as the case may be, the ratio of the Index Figure applicable to that month or date, as the case may be, divided by the Index Figure applicable to the month or date, as the case may be, twelve months prior thereto, provided that (a) if such ratio is greater than the Maximum Indexation Factor specified in the relevant Final Terms, it shall be deemed to be equal to such Maximum Indexation Factor and (b) if such ratio is less than the Minimum Indexation Factor specified in the relevant Final Terms, it shall be deemed to be equal to such Minimum Indexation Factor;

  • Loss Factor means the scaling factor determined in accordance with clause 7 and applied by the reconciliation manager to volumes of electricity measured or estimated in respect of ICPs on the Network, in order to reflect the impact of the ICP on Losses within the Network;

  • Participation Factor means a percentage to be determined in the reasonable discretion of the Issuer (billiges Ermessen) (§ 315 BGB) on the Strike Date on the basis of the volatility of the Underlying and the market conditions prevailing on such date and will be published in accordance with § 14 hereof. The indication for the Participation Factor based on the market conditions as of 15 November 2017 is 100% (in any case, it will not be below 80%).

  • Capacity Utilization Factor or “CUF” shall have the same meaning as provided in CERC (Terms and Conditions for Tariff determination from Renewable Energy Sources) Regulations, 2009 as amended from time to time; However, for avoidance of any doubt, it is clarified that the CUF shall be calculated on the Contracted Capacity; In any Contract Year, if ‘X’ MWh of energy has been metered out at the Delivery Point for ‘Y’ MW Project capacity, CUF= (X MWh/(Y MW*8766)) X100%; Declared CUF for this Project shall be % (to be revised as applicable).

  • Class Factor As to any date of determination and any Combinable Class, the then current Class Factor for the Related REMIC Class. As to any date of determination and any RCR Class, a fraction the numerator of which is the sum of the then current Class Balances of

  • Conversion Factor means 1.0, provided that in the event that the General Partner (i) declares or pays a dividend on its outstanding REIT Shares in REIT Shares or makes a distribution to all holders of its outstanding REIT Shares in REIT Shares, (ii) subdivides its outstanding REIT Shares, or (iii) combines its outstanding REIT Shares into a smaller number of REIT Shares, the Conversion Factor shall be adjusted by multiplying the Conversion Factor by a fraction, the numerator of which shall be the number of REIT Shares issued and outstanding on the record date for such dividend, distribution, subdivision or combination (assuming for such purposes that such dividend, distribution, subdivision or combination has occurred as of such time), and the denominator of which shall be the actual number of REIT Shares (determined without the above assumption) issued and outstanding on such date and, provided further, that in the event that an entity other than an Affiliate of the General Partner shall become General Partner pursuant to any merger, consolidation or combination of the General Partner with or into another entity (the “Successor Entity”), the Conversion Factor shall be adjusted by multiplying the Conversion Factor by the number of shares of the Successor Entity into which one REIT Share is converted pursuant to such merger, consolidation or combination, determined as of the date of such merger, consolidation or combination. Any adjustment to the Conversion Factor shall become effective immediately after the effective date of such event retroactive to the record date, if any, for such event; provided, however, that if the General Partner receives a Notice of Redemption after the record date, but prior to the effective date of such dividend, distribution, subdivision or combination, the Conversion Factor shall be determined as if the General Partner had received the Notice of Redemption immediately prior to the record date for such dividend, distribution, subdivision or combination.

  • Stress Factor means 2.25.

  • Adjustment Factor means, with respect to a share of the Fund (or one unit of any other security for which a Fund Closing Price must be determined), 1.0, subject to adjustment in the event of certain events affecting the shares of the Fund. See “—Anti-dilution Adjustments Relating to the Fund; Alternate Calculation —Anti-dilution Adjustments” below.

  • Accumulation Period Factor means, for any Collection Period, a fraction with:

  • Required Reserve Factor Floor means, for any Calculation Period, the sum (expressed as a percentage) of (a) 28.00% plus (b) the product of the Adjusted Dilution Ratio and the Dilution Horizon Ratio, in each case, as of the immediately preceding Cut-Off Date.

  • True-Up Adjustment means any Annual True-Up Adjustment or Interim True-Up Adjustment, as the case may be.

  • Lot line adjustment means the relocation of the property boundary line in a

  • Average Monthly Limit means the maximum allowable "Average Monthly Concentration" as defined in Section 22a-430-3(a) of the RCSA when expressed as a concentration (e.g. mg/l); otherwise, it means "Average Monthly Discharge Limitation" as defined in Section 22a-430-3(a) of the RCSA.

  • Excess Overcollateralized Amount With respect to the Class A Certificates and the Mezzanine Certificates and any Distribution Date, the excess, if any, of (i) the Overcollateralized Amount for such Distribution Date (calculated for this purpose only after assuming that 100% of the Principal Remittance Amount on such Distribution Date has been distributed) over (ii) the Overcollateralization Target Amount for such Distribution Date.

  • Power Factor means the ratio of usage power measured in kW to total power measured in kVA;

  • Power Transfer Distribution Factor or “PTDF” shall mean a measure of the responsiveness or change in electrical loadings on Transmission Facilities due to a change in electric power transfer from one area to another, expressed in percent (up to 100%) of the change in power transfer in the pre-contingency configuration of a system under study.

  • CPI Adjustment means the quotient of (i) the CPI for the month of January in the calendar year for which the CPI Adjustment is being determined, divided by (ii) the CPI for January of 2007.

  • Weighting factor wT for an organ or tissue (T) means the proportion of the risk of stochastic effects resulting from irradiation of that organ or tissue to the total risk of stochastic effects when the whole body is irradiated uniformly. For calculating the effective dose equivalent, the values of wT are:

  • Reserve Penalty Factor means the cost, in $/MWh, associated with being unable to meet a specific reserve requirement in a Reserve Zone or Reserve Sub-zone. A Reserve Penalty Factor will be defined for each reserve requirement in a Reserve Zone or Reserve Sub-zone.

  • S&P Volatility Factor means 277% or such other potential dividend rate increase factor as S&P advises the Corporation in writing is applicable.