Examples of E-Drive in a sentence
Press & Release the button on the EDrive until “Amps” is displayed, note the Amp draw.
Failure to observe this precaution could result in severe bodily injury or loss of life.Cette EDrive contient des condensateurs à haute tension qui mettent du temps à se décharger après le retrait de l’alimentation principale.
If an ELCB (Earth Leakage Circuit Breaker) is to be used, the following conditions apply:• A Type B Device must be used.• The device must be suitable for protecting equipment with a DC component in the leakage current.• Individual ELCBs should be used for each EDrive E3.
EDrive E3 ground connections should not loop from one drive to another, or to, or from any other equipment.
The EDrive is configured and its operation monitored via the keypad and display.
However, the power venter will only provide 25–30% of full capacity, will cause damage to components and should be avoided.Fan rotation can be changed on the EDrive by switching the attachment position of any two power leads.
For more information about the EDrive E3 please refer the Installation & Operating Manual.
The ground terminal of each EDrive E3 should be individually connected DIRECTLY to the source breaker panel ground bus bar (through the filter if installed).
The EDrive E3 is designed to produce the minimum possible leakage current whilst complying with worldwide standards.The level of current is affected by motor cable length and type, the effective switching frequency, the earth connections used and the type of RFI filter installed.
Some of these can be: high voltage battery state of charge (SOC), LVBN power consumption, vehicle speed, acceleration pedal position, ABS/ESP intervention, E-Drive button activation and so on.