Examples of Excess air in a sentence
Excess air determined under paragraph (d)(7) of this section equal to or greater than 150 percent.
Excess air (gooseneck) shall be removed from bags prior to sealing using a vacuum equipped with a HEPA filtration system in accordance with OSHA regulation 29 CFR 1926.1101, as amended, and any subsequent amendments and editions.
Excess air shall be determined using resultant data from the EPA Method 3C tests and EPA Method 3B, 40 CFR part 60, Appendix A, equation 3B-1 or ANSI/ASME PTC 19.10, 1981-Part 10 (manual portion only) (incorporated by reference as specified in §63.14).
Excess air must be determined using resultant data from the EPA Method 3C tests and EPA Method 3B of appendix A–2 of this part, equation 3B– 1, or ANSI/ASME PTC 19.10–1981, Part 10 (manual portion only) (incorporated by reference as specified in § 60.17).
Excess air shall be determined using resultant data from the EPA Method 3C tests and EPA Method 3B, 40 CFR part 60, Appendix A, equation 3B– 1 or ANSI/ASME PTC 19.10, 1981-Part 10 (manual portion only) (incorporated by reference as specified in § 63.14).
Excess air should be excluded without compaction, prior to closure using a bag tie at the point of waste generation.
Any challenge to an amendment to this Declaration for the reason that the amendment was not adopted by the required number of Owners or was not adopted in accordance with the procedures set forth in this Section must be made within one (1) year after the Recording of the amendment.
That meant that, as long as the debtor wished to continue to use cash to operate its business, the judge was required to continue ordering protection payments to CCB – a point T-Green recognized by filing the Motion for Authority to Use Cash Collateral and Provide Adequate Protection to CCB.
Excess air calculation is used to correct SF6 data, which could be greatly influenced by this parameter in contrast to CFCs (Ayraud et al., 2008; Maiss and Brenninkmeijer, 1998; Plummer et al., 2001).The residence time corresponds to the groundwater transit time distribution in the saturated zone until the sampled point.
Excess air must be determined using resultant data from the EPA Method 3C tests and EPA Method 3B of appendix A-2 of this part, equation 3B-1, or ANSI/ASME PTC 19.10-1981, Part 10 (manual portion only) (incorporated by reference as specified in §60.17).