Linear foot definition

Linear foot means a unit of length equal to one foot and may only be used for pipe measurement.
Linear foot means th e length in feet of cable, wire, fiber, conduit or other linear Facilities. Facilities that are physically connected, wrapped, or lashed as a single cable, conduit or bundle of cables or conduit shall be considered a single facility for purposes of calculating each Linear Foot, provided that each conduit or bundle of conduit up to and including 4" in exterior diameter shall constitute a separate Facility for calculating Linear Feet. Conduit having fiber optic or other cable or wire installed within it shall not be considered separate facilities but shall be considered part of the single "conduit" or bundle for purposes of calculating Linear Feet. Each Provider shall be subject to a separate Linear Foot charge for Facilities used by Provider and subject to this code.
Linear foot means a measurement that is 12 inches long and that is measured typically in a straight line,

Examples of Linear foot in a sentence

  • Linear foot (meter) of silt fence for ditch check properly cleaned out.

  • Temporary Walkways With Detectable Edging…… per Linear foot Item No. 150.

  • Incorporated KHz Kilohertz Kip thousand pounds Ksf Thousand pounds per square foot Ksi Thousand pounds per square inch Kv Kilovolt KVA Kilovolt amperes KW Kilowatt KWH Kilowatt hour LF Linear foot lb Pound LED Light emitting diode MBH 1000 BTUs per hour MHz Mega hertz mil Thousandth of an inch mm Millimeter mph Miles per hour oz.

  • Measured and paid for by the Linear foot that includes all the required equipment, materials, and labor to complete the work.

  • Payment will be made under: Pay Item Pay UnitSoil Nail Linear foot Payment for Soil Nail Wall will be full compensation for all work and materials required to complete the soil nail walls.

  • Linear foot or a straight line measurement between two points measured in feet.

  • However, the Utility estimates that the residual value of the leased vehicles will be adequate to satisfy most of the guaranteed amounts.

  • Item No.DescriptionESTQuantityUnitsUnit CostTotal Cost PROJECT 1 DANIELS PASS TRAILS:Note: Linear foot quantity estimate fornew trail includes the GPS alignment plus 8% BID FORM SIGNATURE PAGE The undersigned hereby certifies that at the time of this certification, the Bidder does not knowingly employ or contract with any illegal aliens and that the Bidder has participated or attempted to participate in the everify program in order to verify that the Contractor does not employ any illegal aliens.

  • The Advanced Linear foot pedal (ALP) used with the subject device is substantially equivalent to the foot pedal used with the secondary predicate device, the COMPACT INTUITIV System, cleared under K133115.

  • The materials, energy source, operating mechanism, fundamental scientific technology, physical properties, duration and type of contact, and intended use of the subject device are identical to those of AMO WHITESTAR Signature Phacoemulsification System’s console and remote control in K111697, and the COMPACT INTUITIV System’s foot pedal in K133115 for the subject device’s Advanced Linear foot pedal (APL).


More Definitions of Linear foot

Linear foot means the distance traversed by Conduit or innerduct underground. This number will be determined by either the data furnished by the City of Xxxxx maps/records or by the use of measured rodder to measure the length of the Conduit. Any dispute on distance will be resolved with the use of the rodder to measure the distance for the calculation of lease rate.
Linear foot means a unit of measurement in a straight line on a horizontal plane.
Linear foot. – means the length in feet of cable, wire, fiber, or other linear Facilities physically connected, wrapped, or lashed as a single cable or bundle of cables, or with respect to underground Facilities, means the length of a conduit or an array of conduits contemporaneously installed during the same construction project by a single provider. Where applicable, a separate Franchise shall be required for each separate entity who owns or controls Facilities within an array of conduits.
Linear foot means the length in feet of cable, wire, fiber, conduit, or other linear facilities. Facilities that are physically connected, wrapped or lashed as a single cable, conduit, or bundle of cables or conduit shall be considered a single facility for purposes of calculating each linear foot, provided that each conduit or bundle of conduit up to and including four (4) inches in exterior diameter shall constitute a separate Facility for calculating linear feet. Conduit having fiber optic or other cable or wire installed within it shall not be considered separate facilities but shall be considered part of the single "conduit" or bundle for purposes of calculating linear feet. Each provider shall be subject to a separate linear foot charge for facilities used by provider and subject to this Article.

Related to Linear foot

  • Linear Interpolation means the straight-line interpolation by reference to two rates based on the Reference Rate or the ISDA Rate, as the case may be, one of which will be determined as if the Specified Duration were the period of time for which rates are available next shorter than the length of the affected Interest Period and the other of which will be determined as if the Specified Duration or the Designated Maturity, as the case may be, were the period of time for which rates are available next longer than the length of such Interest Period.

  • Cubic Foot means the volume of gas which occupies one cubic foot when such gas is at a temperature of 60 degrees Fahrenheit, and at a pressure of 14.73 pounds per square inch absolute.

  • Acre-foot means the amount of water necessary to cover one acre of land to the depth of one foot, or 325,851 U.S. gallons of water.

  • Uppermost aquifer means the geologic formation nearest the natural ground surface that is an aquifer, as well as lower aquifers that are hydraulically interconnected with this aquifer within the facility's property boundary.

  • Modular building retailer means any person who purchases or acquires a modular building from a

  • Diameter means the diameter of the stem of a tree measured outside the bark at a specified point of measurement.

  • Lot width means the shorter of the following two linear measurements:

  • width means, in relation to a lot,

  • Cubic Metre means the volume of gas which occupies one cubic metre when such gas is at a temperature of 15 degrees Celsius, and at a pressure of 101.325 kilopascals absolute;

  • parking meter means an apparatus for use on or in the vicinity of a parking place for indicating, as respects a space provided at that parking place for the leaving of vehicles, whether the initial charge has been paid and whether the period for which payment was made by the initial charge has expired;

  • Lot Frontage means lot frontage as defined in Town's Zoning By-law No. 1136 (1987), as amended, or any successor thereto.

  • Near fatality means an injury that, as certified by a physician, places a child in serious or critical condition;

  • Points refers to Citi ThankYou Points or ThankYou Points earned on your Citi Corporate Card;

  • Intersection means (i) the area embraced within the prolongation or connection of the lateral

  • Basal area means the effective surface area available to transmit the treated effluent from the filter media in a mound system into the in-situ receiving soils. The perimeter is measured at the interface of the imported fill material and in-situ soil. On sloping sites, only the area down-gradient from the up-slope edge of the distribution media may be included in this calculation.

  • Tare Weight means the weight of an empty shipping container, excluding all materials used for wrapping, cushioning, banding, waterproofing, packaging, blocking and bracing articles within the exterior container.

  • Measurement Point means the emission source for which continuous emission measurement systems (CEMS) are used for emission measurement, or the cross-section of a pipeline system for which the CO2 flow is determined using continuous measurement systems;

  • On-premise beer retailer means a beer retailer who is:

  • Loop Concentrator/Multiplexer or "LCM" is the Network Element that does one or more of the following: aggregates lower bit rate or bandwidth signals to higher bit rate or bandwidth signals (multiplexing); disaggregates higher bit rate or bandwidth signals to lower bit rate or bandwidth signals (demultiplexing); aggregates a specified number of signals or channels to fewer channels (concentrating); performs signal conversion, including encoding of signals (e.g., analog to digital and digital to analog signal conversion); or in some instances performs electrical to optical (E/O) conversion. LCM includes DLC, and D4 channel banks and may be located in Remote Terminals or Central Offices.

  • Seasonal high water table means the level below the natural surface of the ground to which water seasonally rises in the soil in most years.

  • Life-cycle cost means the expected total cost of ownership during the life of a product, including disposal costs.

  • Extrapolation means that the total amount of overpayment or underpayment will be determined by using sample data meeting the confidence level requirement.

  • Rear Yard means a yard extending across the full width of a parcel measured perpendicularly from the rear wall(s) of the main building situated on the parcel to the rear property boundary of the parcel [see sketch in Schedule B];

  • Semi-annual (2/Year) sampling frequency means the sampling shall be done during the months of June and December, unless specifically identified otherwise.

  • RUNNING CHARGE PER KILOMETER means the rates payable against each KM run. and shall be deemed to include all the expenditures of the Transport Supplier viz., cost of fuel, tyre/tube, battery & consumables like lubricants etc. and other maintenance expenditures including accessories involved including GST element as applicable towards movement of the vehicle(s)/equipment.

  • Yearly (1/Year) sampling frequency means the sampling shall be done in the month of September, unless specifically identified otherwise in the effluent limitations and monitoring requirements table.