We use cookies on our site to analyze traffic, enhance your experience, and provide you with tailored content.

For more information visit our privacy policy.

Method Detection Level definition

Method Detection Level or “MDL” means the minimum concentration of an analyte (substance) that can be measured and reported with a ninety- nine percent (99%) confidence that the analyte concentration is greater than zero (0) as determined by procedure set forth in 40 CFR 136, Appendix B. The method detection level or MDL is equivalent to the LOD.
Method Detection Level or “MDL” means the minimum concentration of an analyte (substance) that can be measured and reported with a ninety- nine percent (99%) confidence that the analyte concentration is greater than zero (0) as determined by procedure set forth in 40 CFR 136,
Method Detection Level. The level above which a compound can be identified in a representative dietary supplement matrix using an established analytical method. It is a measure of the performance capability and sensitivity of the method.

Examples of Method Detection Level in a sentence

  • The permittee may determine a case-specific Method Detection Level (MDL) using one of the analytical methods specified below, or any other test method which is approved by IDEM prior to use.

  • The interim ML shall be calculated as 3.18 times the Method Detection Level (MDL) calculated pursuant to 40 CFR Part 136, Appendix B.

  • ParameterLODLOQChlorine0.020.06 Case-Specific MDL The permittee may determine a case-specific Method Detection Level (MDL) using one of the analytical methods specified above, or any other test method which is approved by IDEM prior to use.

  • Method Detection Level the permittee shall use analytical procedures approved under 40 CFR 136 with method detection levels (MDLs) less than or equal to those listed below to comply with the monitoring requirements for the following parameters: Outfall Parameter MDL (mg/L) 3ID00003005Total Residual Chlorine0.0103ID00003014Total Residual Chlorine0.0103ID00003022Total Residual Chlorine0.010 P.

  • Each laboratory analysis Reporting Level or Method Detection Level must, at a minimum, meet the Required Reporting Values Outlined in Table 3.

  • Method Detection Level (MDL)--The minimum concentration of a substance that can be measured and reported with 99% confidence that the analyte concentration is above zero and is determined from analysis of a sample in a given matrix containing the analyte.

  • While Method 1668B has not been officially proposed and adopted by U.S. EPA pursuant to 40 CFR Part 136, Method 1668B has an extremely sensitive Method Detection Level and a discharger would likely report detectable levels of the pollutant even though the ultimate source of PCBs could be intake water or atmospheric deposition.

  • The risks of engaging in parliament were well assessed prior to the start of the project, through the Parliament Needs Assessment, and the specific risk and assumptions section in the Project Document.

  • ACC examined the Excel spreadsheet in EPA’s Appendix D (Analysis of Representative Method Detection Level) to the MACT Floor memo.

  • Analyte detected at level between the Method Detection Level and the Practical Quantitation Level.

Related to Method Detection Level

  • Method detection limit means the minimum concentration of a hazardous substance that can be measured and reported with 99% confidence that the analyte concentration is greater than zero and is determined from analysis of a sample in a given matrix that contains the analyte.

  • Method Detection Limit (MDL means the minimum concentration of a substance (analyte) that can be measured and reported with 99 percent confidence that the analyte concentration is greater than zero and is determined from analysis of a sample in a given matrix containing the analyte.

  • Maximum Concentration Level Assessment means the Maximum Concentration Level Assessment for the purposes of a Basic Comprehensive Certificate of Approval, described in the Basic Comprehensive User Guide, prepared by a Toxicologist using currently available toxicological information, that demonstrates that the concentration at any Point of Impingement for a Compound of Concern that does not have a Ministry Point of Impingement Limit is not likely to cause an adverse effect as defined by the EPA. The concentration at Point of Impingement for a Compound of Concern must be calculated in accordance with O. Reg. 419/05.

  • Integration Level means the Social Security taxable wage base for the Plan Year, unless the Employer elects a lesser amount in (A) or (B) below.

  • Reference Level means the level of the Index (excluding any flash estimates) published or announced by Eurostat (or any successor entity which publishes such index) in respect of the month that is 12 calendar months prior to the month referred to in “Latest Level” above.

  • Minimum Level (ML means the concentration at which the entire analytical system must give a recognizable signal and an acceptable calibration point. The ML is the concentration in a sample that is equivalent to the concentration of the lowest calibration standard analyzed by a specific analytical procedure, assuming that all the method-specified sample weights, volumes and processing steps have been followed.

  • Use Level means the license use meter or model (which may include operating system, hardware system, application or machine tier limitations, if applicable) by which Symantec measures, prices and licenses the right to use the Licensed Software, in effect at the time an order is placed for such Licensed Software, as indicated in this License Agreement and the applicable License Instrument.

  • regulatory action level RBC means the product of 1.5 and its authorized control level RBC;

  • Performance Level means a reference to one of Performance Level I, Performance Level II, Performance Level III, Performance Level IV or Performance Level V.

  • Table E academic outcomes at receiving institution

  • Severity Level means the actual impact of a Defect on a user’s operational environment as further described in the table below.

  • Action level means a rate of emissions of a hazardous air contaminant as specified in Appendix C or as may be determined under Section 5-261(3) of these regulations. Action Levels are used to determine the applicability of Section 5-261 to stationary sources and shall be derived in accordance with the method prescribed in Appendix E of these regulations.

  • Strike Level means the Strike Level as specified in § 1 of the Product and Underlying Data.

  • Acceptable earned value management system means an earned value management system that generally complies with system criteria in paragraph (b) of this clause.

  • Maximum contaminant level goal or “MCLG” means the maximum level of a contaminant in drinking water at which no known or anticipated adverse effect on the health of persons would occur, and which allows an adequate margin of safety. MCLGs are nonenforceable health goals.

  • Mid-level practitioner means a certified nurse-midwife engaging in the independent practice of midwifery under the independent practice of midwifery act, an advanced practice registered nurse issued a license pursuant to K.S.A. 65-1131, and amendments thereto, who has authority to prescribe drugs pursuant to a written protocol with a responsible physician under K.S.A. 65-1130, and amendments thereto, or a physician assistant licensed under the physician assistant licensure act who has authority to prescribe drugs pursuant to a written agreement with a supervising physician under K.S.A. 65-28a08, and amendments thereto.

  • RDDS test Means one query sent to a particular “IP address” of one of the servers of one of the RDDS services. Queries shall be about existing objects in the Registry System and the responses must contain the corresponding information otherwise the query will be considered unanswered. Queries with an RTT 5 times higher than the corresponding SLR will be considered as unanswered. The possible results to an RDDS test are: a number in milliseconds corresponding to the RTT or undefined/unanswered.

  • Base Level means the following amounts plus the percentage

  • authorized control level RBC means the number determined under the risk-based capital formula in accordance with the RBC instructions;

  • mandatory control level RBC ’ means the product of .70 and the authorized control level RBC.

  • Selection Criteria means and includes all of the requirements, considerations,

  • Yearly (1/Year) sampling frequency means the sampling shall be done in the month of September, unless specifically identified otherwise in the effluent limitations and monitoring requirements table.

  • Instantaneous flow measurement means the flow measured during the minimum time required for the flow-measuring device or method to produce a result in that instance. To the extent practical, instantaneous flow measurements coincide with the collection of any grab samples required for the same sampling period so that together the samples and flow are representative of the discharge during that sampling period.

  • Маrgin Level for CFD trading shall mean the percentage of Equity to Necessary Margin ratio. It is calculated as: Margin Level = (Equity / Necessary Margin) x 100%.

  • Balance Computation Method We use the daily balance method to calculate the interest on your account. This method applies a daily periodic rate to the balance in the account each day. Compounding and Crediting: Interest is compounded daily and calculated on a 365/366 day basis. Interest is credited on a monthly basis.