Rupture disc definition

Rupture disc means a type of pressure relief device which is designed to fracture, rupture, or burst under pressure when the pressure within the system exceeds a set level. Such a device is commonly a diaphragm held between flanges, which under conditions of normal operation remains intact and prevents gases from being released from the system.

Examples of Rupture disc in a sentence

  • The immigration procedures, which reflect a policy emphasizing stricter control over new immigrants, are in the end exposing possible innocent persons to undue and unnecessary hardship.

  • DCS operational plant.4. Nitrogen blanketing in Hydrogenation reactor.5. Safety valve and Rupture disc provided on reactor.6. Cooling Chilling and power alternative arrangement have been made on reactor.7. Hydrogen and Nitrogen Cylinder bank away from the autoclave reactor.

  • Regular training is imparted to the employees on Safety.Earth rite system, Distributed Control System operation (DCS), Powder transfer system (PTS), Local exhaust ventilation, Rupture disc, Safety relief valve, dump tank, Water sprinklers, LEL detector, Multi gas detectors are installed where required.

  • For Chillers Using R-123: Rupture disc in series with a spring-loaded, re-seating relief valve to stop the flow of refrigerant to atmosphere below 13 psig.

  • Pressure gauge with red mark of S.W.P.5. Safety valve on Hydrogen and nitrogen line header.6. Double Safety valve on reactor.7. Rupture disc shall be provided for additional safety.8. Safety valves and rupture disc shall be connected to dumping vessel which is located away from the reactor area.

  • Tank Safety & Protection DevicesRupture Disc→ Applying Rupture Disc Using as a single safety device (Primary case)According to the ASME Code, the rupture pressure should, when Rupture disc is used in single as a safety device, be set the lesser value for the MAWP of pressure vessel, and it must be able to prevent the pressure elevation more the 10% for the MAWP of pressure vessel or 3 psi.

  • Rupture disc and safety seal-(1) At least two rupture discs of adequate size which shall blow off at a pressure twice the maximum operating pressure shall be provided on each furnace and shall either be mounted directly on the top of the furnace or each through an independent pipe as close as possible to the furnace.

  • Rupture disc and safety seal- At least: two rupture discs be fitted on the offtake pipe between the electric furnace and sulphur separator to prevent entry of pieces of charcoal into the condensers and piping.

  • Materials of construction include metals,graphite or plastic materials held between special flanges Rupture disc sizing is based on the premise that, if and of such a thickness, diameter and shape, and material, adequate flow is allowed from the disc, pressure will be that it will rupture at a pre-determined pressure.

  • Rupture disc burst sensor post-incident DuPont Belle used a “burst sensor” intended to notify the board operator that the rupture disk (Figure 5) activated.

Related to Rupture disc

  • Change in Use means altering the purpose of an existing room, within the facility, that requires structural changes.

  • Severe Disruption Event means any event specified as such in the Final Terms.

  • Communicable disease means an illness caused by an infectious agent or its toxins that occurs through the direct or indirect transmission of the infectious agent or its products from an infected individual or via an animal, vector or the inanimate environment to a susceptible animal or human host.

  • Force Majeure Delay means with respect to the Servicer, any cause or event which is beyond the control and not due to the negligence of the Servicer, which delays, prevents or prohibits such Person’s delivery of the reports required to be delivered or the performance of any other duty or obligation of the Servicer under the Indenture, as the case may be, including, without limitation, computer, electrical and mechanical failures, acts of God or the elements and fire; provided, that no such cause or event shall be deemed to be a Force Majeure Delay unless the Servicer shall have given the Indenture Trustee written notice thereof as soon as practicable after the beginning of such delay.

  • Haryana DISCOMs means the UTTAR HARYANA BIJLI VITRAN NIGAM LIMITED

  • Force Majeure Delays means any actual delay in the construction of the Tenant Improvements, which is beyond the reasonable control of Landlord or Tenant, as the case may be, as described in Paragraph 33 of the Lease.

  • Network Termination Point (NTP) means the physical point at which a subscriber is provided with access to a public communications network; in the case of networks involving switching or routing, the NTP is identified by means of a specific network address, which may be linked to a subscriber number or name;

  • Potential Termination Event means an event which, with the giving of notice and/or the lapse of time, would constitute a Termination Event.

  • Potential Change in Control means the occurrence of any of the following events:

  • Potential Change in Control Period shall commence upon the occurrence of a Potential Change in Control and shall lapse upon the occurrence of a Change in Control or, if earlier (i) with respect to a Potential Change in Control occurring pursuant to Section 16.20(A), immediately upon the abandonment or termination of the applicable agreement, (ii) with respect to a Potential Change in Control occurring pursuant to Section 16.20(B), immediately upon a public announcement by the applicable party that such party has abandoned its intention to take or consider taking actions which if consummated would result in a Change in Control, or (iii) with respect to a Potential Change in Control occurring pursuant to Section 16.20(C) or (D), upon the one year anniversary of the occurrence of a Potential Change in Control (or such earlier date as may be determined by the Board).

  • Excusable Delay means a delay due to acts of God, governmental restrictions, stays, judgments, orders, decrees, enemy actions, civil commotion, fire, casualty, strikes, work stoppages, shortages of labor or materials or other causes beyond the reasonable control of Borrower, but lack of funds in and of itself shall not be deemed a cause beyond the control of Borrower.

  • Third Party Terminating Carrier means a Telecommunications Carrier to which traffic is terminated when CLEC originates traffic that is sent through AT&T-TSP’s network, i.e., CLEC is using AT&T-TSP’s Transit Traffic Service.

  • Potential Change of Control shall be deemed to have occurred if:

  • Potential Change of Control Announcement means any public announcement or statement by the Issuer or by any actual or potential bidder or any designated adviser thereto relating to any specific or any near-term potential Change of Control (whereby "near-term" shall mean that such potential Change of Control is reasonably likely to occur, or is publicly stated by the Issuer or by any such actual or potential bidder or any such designated adviser to be intended to occur, within four months of the date of such announcement or statement).

  • Unavoidable Delay means an event which delays Closing which is a strike, fire, explosion, flood, act of God, civil insurrection, act of war, act of terrorism or pandemic, plus any period of delay directly caused by the event, which are beyond the reasonable control of the Vendor and are not caused or contributed to by the fault of the Vendor. “Unavoidable Delay Period” means the number of days between the Purchaser’s receipt of written notice of the commencement of the Unavoidable Delay, as required by paragraph 5(b), and the date on which the Unavoidable Delay concludes.

  • Anticipatory Termination means a termination of employment where PNC terminates your employment with PNC (other than for Misconduct or Disability) prior to the date on which a Change of Control occurs, and you reasonably demonstrated that such termination of employment (i) was at the request of a third party that has taken steps reasonably calculated to effect a Change of Control or (ii) otherwise arose in connection with or in anticipation of a Change of Control.

  • Customer channel termination point means the location where the customer either inputs or receives the communications.

  • Access Terminal means any device used to access any of Your Accounts, including without limitation an ATM, a computer, a portable hand-held device, or a telephone, including any form of mobile telephone or Mobile Device.

  • Blended learning means the delivery of instruction in a combination of time in a supervised physical location away from home and online delivery whereby the student has some element of control over time, place, path, or pace of learning.

  • Excluded Downtime has the meaning set forth in Section 2 below.

  • Excusable Delays means delays due to acts of terrorism, acts of war or civil insurrection, strikes, riots, floods, earthquakes, fires, tornadoes, casualties, acts of God, labor disputes, governmental restrictions or priorities, embargoes, national or regional material shortages, failure to obtain regulatory approval from any Federal or State regulatory body, unforeseen site conditions, extraordinary rainfall or snowfall, or any other condition or circumstances beyond the reasonable or foreseeable control of the applicable Party using reasonable diligence to overcome which prevents such Party from performing its specific duties or obligation hereunder in a timely manner; provided, however, Excusable Delay does not include lack of financing, unanticipated or unexpected increases in the costs of construction, or errors in business judgment by a Party; and provided further that Excusable Delay shall only extend the time of performance for the period of such Excusable Delay, which shall begin on the date which the event of Excusable Delay first occurs and extend until the date which the event which has caused the Excusable Delay has been corrected or performed, or reasonably should have been corrected or performed.

  • Prepaid wireless calling service means a telecommunications service:

  • Discontinuation Event means (i) when the Commission notifies the Company whether there will be a “review” of such Registration Statement and whenever the Commission comments in writing on such Registration Statement (the Company shall provide true and complete copies thereof and all written responses thereto to each of the Holders); (ii) any request by the Commission or any other Federal or state governmental authority for amendments or supplements to such Registration Statement or Prospectus or for additional information; (iii) the issuance by the Commission of any stop order suspending the effectiveness of such Registration Statement covering any or all of the Registrable Securities or the initiation of any Proceedings for that purpose; (iv) the receipt by the Company of any notification with respect to the suspension of the qualification or exemption from qualification of any of the Registrable Securities for sale in any jurisdiction, or the initiation or threatening of any Proceeding for such purpose; and/or (v) the occurrence of any event or passage of time that makes the financial statements included in such Registration Statement ineligible for inclusion therein or any statement made in such Registration Statement or Prospectus or any document incorporated or deemed to be incorporated therein by reference untrue in any material respect or that requires any revisions to such Registration Statement, Prospectus or other documents so that, in the case of such Registration Statement or Prospectus, as the case may be, it will not contain any untrue statement of a material fact or omit to state any material fact required to be stated therein or necessary to make the statements therein, in light of the circumstances under which they were made, not misleading.

  • Material Change in Formula means the occurrence since the Launch Date of a material change in the formula for, or the method of, calculating the Reference Price.

  • Unavoidable Delays means delays due to any of the following, and only the following, (provided that such delay is beyond Construction Manager’s reasonable control): war, insurrection, civil commotion, strikes, slowdowns, lock outs, riots, flood, earthquakes, fires, casualties, acts of God, acts of a public enemy, acts of terrorism, epidemics, quarantine restrictions, freight embargoes, lack of transportation, governmental moratoriums, unusually severe or abnormal weather conditions, failure of utilities, or a court order which causes a delay (unless resulting from a wrongful act of Construction Manager). In no event shall the application to Construction Manager of any applicable law, regulation, rule or other governmental requirement constitute an Unavoidable Delay. Contractor shall use reasonable good faith efforts to notify Owner not later than five (5) days after Construction Manager knows of the occurrence of an Unavoidable Delay. An extension of time for an Unavoidable Delay shall only be for the period of the Unavoidable Delay, which period shall commence to run from the time of the commencement of the cause of the Unavoidable Delay.

  • Force Majeure Events means acts of war, domestic and/or international terrorism, civil riots or rebellions, quarantines, embargoes and other similar unusual governmental actions, extraordinary elements of nature or acts of God.