Short circuit definition

Short circuit means a fault condition in the circuit arising from the introduction of a path of low resistance to electric current;
View Source
Short circuit means an abnormal connection of relatively low resistance whether made accidentally or intentionally, between two points of different potential in a circuit.
View Source
Short circuit means short circuit of corresponding speaker or CIE circuit;
View Source

Examples of Short circuit in a sentence

  • Short circuit, loss of use, parts or labor covered under the manufacturer’s warranty, lack of maintenance, bodily injury, pre-existing conditions, manufacturer’s recall, periodic checkups or maintenance.

  • Short Circuit Violations Short circuit violations will be identified based on the following criteria: any contribution to an overloaded facility where the New Service Request increases the fault current impact by at least one percent or greater of the rating in the applicable model.

  • Short circuit withstand ratings of heaters shall also be furnished by the Contractor.

  • After preliminary site engineering, three phase WYE or delta grounded configuration as required, through resistance: Rated terminal voltage must meet local standards Rated power factor must meet local standards; Short circuit ratio (saturated).

  • Short circuit, loss of use, lack of maintenance, bodily injury, pre-existing conditions, periodic checkups or maintenance.

  • Short Circuit Violations Short circuit violations will be identified based on the following criteria: any contribution to an overloaded facility where the New Service Request increases the fault current impact by at least 1% or greater of the rating in the applicable model.

  • Short circuit impedance and short circuit power The end node (node in the feeder with the lowest voltage) is selected and a short circuit at that node is calculated.

  • Short circuit analysis and equipment ratings shall be determined by the electrical contractor.

  • Short circuit analyses will only be conducted on 26kV circuits and not secondary circuits.

  • Short circuit studies to determine the magnitude of currents that will occur during an electrical fault to include comparison of information to ratings of equipment in the field and protection devices.