State Ambient Air Quality Standard definition

State Ambient Air Quality Standard means an ambient standard established or adopted by the Department.
Sample 1Sample 2Sample 3
State Ambient Air Quality Standard means the maximum amount of an air contaminant that is permissible in outdoor air.
Sample 1Sample 2Sample 3

Examples of State Ambient Air Quality Standard in a sentence

  • Discussion: A substantial adverse effect on Air Quality would occur if: • Emissions of ROG and Nox, will result in construction or operation emissions greater than 82lbs/day (See Table 5.2, of the El Dorado County Air Pollution Control District – CEQA Guide); • Emissions of PM10, CO, SO2 and Nox, as a result of construction or operation emissions, will result in ambient pollutant concentrations in excess of the applicable National or State Ambient Air Quality Standard (AAQS).

  • Discussion: A substantial adverse effect on Air Quality would occur if: • Emissions of ROG and Nox will result in construction or operation emissions greater than 82lbs/day (See Table 5.2, of the El Dorado County Air Pollution Control District – CEQA Guide); • Emissions of PM10, CO, SO2 and Nox as a result of construction or operation emissions, will result in ambient pollutant concentrations in excess of the applicable National or State Ambient Air Quality Standard (AAQS).

  • A substantial adverse effect on Air Quality would occur if: • Emissions of ROG and Nox, will result in construction or operation emissions greater than 82lbs/day (See Table 5.2, of the El Dorado County Air Pollution Control District – CEQA Guide); • Emissions of PM10, CO, SO2 and Nox, as a result of construction or operation emissions, will result in ambient pollutant concentrations in excess of the applicable National or State Ambient Air Quality Standard (AAQS).

  • UWS 17.17(5), the university shall provide the complainant and respondent and their advisors, if any, the evidence gathered during the university’s investigation that is directly related to the allegations of sexual misconduct in an electronic format or hard copy.

  • These concentrations are all lower than the New York State Ambient Air Quality Standard of 14 mcg/m3 (10 ppb), and also do not exceed the available short-term health comparison values for hydrogen sulfide of 42 mcg/m3 and 97 mcg/m3 established by the California Environmental Protection Agency (Cal EPA, 1999) and ATSDR (ATSDR, 1999d), respectively.

  • Air Resources Board, 1989: Proposed Identification of Districts Affected by Transported Air Pollutants which contribute to violations of the State Ambient Air Quality Standard for Ozone.

  • Potentially Significant Impact Discussion: A substantial adverse effect on Air Quality would occur if: • Emissions of ROG and Nox, will result in construction or operation emissions greater than 82lbs/day (See Table 5.2, of the El Dorado County Air Pollution Control District – CEQA Guide); • Emissions of PM10, CO, SO2 and Nox, as a result of construction or operation emissions, will result in ambient pollutant concentrations in excess of the applicable National or State Ambient Air Quality Standard (AAQS).

  • The Federal Ambient Air Quality Standard, which is based on an annual arithmetic mean, is 0.053 ppm and the State Ambient Air Quality Standard, which is based on a one hour averaging time, is 0.25 ppm (Table 5).

  • The statistics below summarize the number of days that any single monitor in Sacramento County violates the State Ambient Air Quality Standard.

  • X Discussion: A substantial adverse effect on Air Quality would occur if:• Emissions of ROG and Nox, will result in construction or operation emissions greater than 82lbs/day (See Table 5.2, of the El Dorado County Air Pollution Control District – CEQA Guide); • Emissions of PM10, CO, SO2 and Nox, as a result of construction or operation emissions, will result in ambient pollutant concentrations in excess of the applicable National or State Ambient Air Quality Standard (AAQS).

Related to State Ambient Air Quality Standard

  • Ambient air quality standard means an established concentration, exposure time, and frequency of occurrence of air contaminant(s) in the ambient air which shall not be exceeded.

  • Water quality standards means provisions of state or federal law which consist of a designated use or uses for the waters of the Commonwealth and water quality criteria for such waters based upon such uses. Water quality standards are to protect the public health or welfare, enhance the quality of water and serve the purposes of the State Water Control Law (§ 62.1-44.2 et seq. of the Code of Virginia) and the federal Clean Water Act (33 USC § 1251 et seq.).

  • Water quality volume means the volume equal to the first one-half inch of runoff multiplied by the impervious surface of the land development project.

  • Underground source of drinking water means an aquifer or its portion:

  • Aviation gasoline means fuel designed for use in the operation of aircraft other than jet aircraft,

  • New Jersey Stormwater Best Management Practices (BMP) Manual or “BMP Manual” means the manual maintained by the Department providing, in part, design specifications, removal rates, calculation methods, and soil testing procedures approved by the Department as being capable of contributing to the achievement of the stormwater management standards specified in this chapter. The BMP Manual is periodically amended by the Department as necessary to provide design specifications on additional best management practices and new information on already included practices reflecting the best available current information regarding the particular practice and the Department’s determination as to the ability of that best management practice to contribute to compliance with the standards contained in this chapter. Alternative stormwater management measures, removal rates, or calculation methods may be utilized, subject to any limitations specified in this chapter, provided the design engineer demonstrates to the municipality, in accordance with Section IV.F. of this ordinance and N.J.A.C. 7:8-5.2(g), that the proposed measure and its design will contribute to achievement of the design and performance standards established by this chapter.

  • Reliability Standards means the criteria, standards, rules and requirements relating to reliability established by a Standards Authority.

  • Reliability Standard means a requirement to provide for reliable operation of the bulk power system, including without limiting the foregoing requirements for the operation of existing bulk power system facilities, including cybersecurity protection, and the design of planned additions or modifications to such facilities to the extent necessary for reliable operation of the bulk power system, but shall not include any requirement to enlarge bulk power system facilities or to construct new transmission capacity or generation capacity.

  • air transport service means a service for the transport by air of persons, mails or any other thing, animate or inanimate, for any kind of remuneration whatsoever, whether such service consists of a single flight or series of flights;

  • Quality Standards means the quality standards published by BSI British Standards, the National Standards Body of the United Kingdom, the International Organisation for Standardisation or other reputable or equivalent body, (and their successor bodies) that a skilled and experienced operator in the same type of industry or business sector as the Contractor would reasonably and ordinarily be expected to comply with, and as may be further detailed in the Specification.

  • Solid Waste Disposal Site means, as defined in NCGS 130A-290(a)(36), any place at which solid wastes are disposed of by incineration, sanitary landfill, or any other method.

  • Biological safety cabinet means a containment unit suitable for the preparation of low to moderate risk agents where there is a need for protection of the product, personnel, and environment, according to National Sanitation Foundation (NSF) Standard 49.

  • Quality system means documented organizational procedures and policies: internal audits of those policies and procedures: management review and recommendation for quality improvement.”

  • Categorical pretreatment standard or "categorical standard" means any regulation containing pollutant discharge limits promulgated by the environmental protection agency in accordance with sections 307(b) and (c) of the Act (33 U.S.C. section 1317) that apply to a specific category of users and that appear in 40 CFR chapter I, subchapter N, parts 405 through 471.

  • health and safety specification means a site, activity or project specific document prepared by the client pertaining to all health and safety requirements related to construction work;

  • Radiopharmaceutical quality assurance means, but is not limited to, the performance of appropriate chemical, biological, and physical tests on potential radiopharmaceuticals and the interpretation of the resulting data to determine their suitability for use in humans and animals, including internal test assessment, authentication of product history, and the keeping of proper records.

  • Air transportation means the public carriage by aircraft of passengers, baggage, cargo, and mail, separately or in combination, for remuneration or hire;

  • Accessibility Standards means accessibility standards and specifications for Texas agency and institution of higher education websites and EIR set forth in 1 TAC Chapter 206 and/or Chapter 213.