Proper practices means those set out in The Practitioners’ Guide
Good Industry Practices means the practices that would be adopted by, and the exercise of that degree of care, skill, diligence, prudence and foresight that reasonably would be expected from, a competent contractor in the international oil and gas industry experienced in performing work similar in nature, size, scope and complexity to the Work and under conditions comparable to those applicable to the Work, where such work is subject to, and such contractor is seeking to comply with, the standards and codes specified in the Contract or (to the extent that they are not so specified) such national or international standards and codes as are most applicable in the circumstances, and the applicable Law.
Best Practices means a term that is often used inter-changeably with “evidence-based 24 practice” and is best defined as an “umbrella” term for three levels of practice, measured in relation to 25 recovery-consistent mental health practices where the recovery process is supported with scientific 26 intervention that best meets the needs of the Client at this time.
27 a. EBP means Evidence-Based Practices and refers to the interventions utilized for which 28 there is consistent scientific evidence showing they improved Client outcomes and meets the following 29 criteria: it has been replicated in more than one geographic or practice setting with consistent results; it
New Jersey Stormwater Best Management Practices (BMP) Manual or “BMP Manual” means the manual maintained by the Department providing, in part, design specifications, removal rates, calculation methods, and soil testing procedures approved by the Department as being capable of contributing to the achievement of the stormwater management standards specified in this chapter. The BMP Manual is periodically amended by the Department as necessary to provide design specifications on additional best management practices and new information on already included practices reflecting the best available current information regarding the particular practice and the Department’s determination as to the ability of that best management practice to contribute to compliance with the standards contained in this chapter. Alternative stormwater management measures, removal rates, or calculation methods may be utilized, subject to any limitations specified in this chapter, provided the design engineer demonstrates to the municipality, in accordance with Section IV.F. of this ordinance and N.J.A.C. 7:8-5.2(g), that the proposed measure and its design will contribute to achievement of the design and performance standards established by this chapter.
Restorative practices means practices that emphasize repairing the harm to the victim and the school community caused by a student's misconduct.
Good Utility Practices mean any of the practices, methods or acts engaged in or approved by a significant portion of the electric energy industry with respect to similar facilities during the relevant time period which in each case, in the exercise of reasonable judgment in light of the facts known or that should have been known at the time a decision was made, could have been expected to accomplish the desired result at reasonable cost consistent with good business practices, reliability, safety, law, regulation, environmental protection and expedition. Good Utility Practices are not intended to be limited to the optimum practices, methods or acts to the exclusion of all others, but rather to delineate the acceptable practices, methods or acts generally accepted in such industry.
Good Industry Practice means standards, practices, methods and procedures conforming to the Law and the degree of skill and care, diligence, prudence and foresight which would reasonably and ordinarily be expected from a skilled and experienced person or body engaged in a similar type of undertaking under the same or similar circumstances.
Prudent Utility Practices means the practices, methods and standards that are generally accepted internationally from time to time by electric utilities for the purpose of ensuring the safe, efficient and economic design, construction, commissioning, operation and maintenance of power generation equipment and which practices, methods and standards shall be adjusted as necessary, to take account of: a) operation and maintenance guidelines recommended by the manufacturers of the plant and equipment to be incorporated in the Power Project; b) the requirements of Indian Law; and the physical conditions at the site of the Power Project
Community practice protocol means a written, executed agreement entered into voluntarily between an authorized pharmacist and a physician establishing drug therapy management for one or more of the pharmacist’s and physician’s patients residing in a community setting. A community practice protocol shall comply with the requirements of subrule 8.34(2).
Water quality standards means provisions of state or federal law which consist of a designated use or uses for the waters of the Commonwealth and water quality criteria for such waters based upon such uses. Water quality standards are to protect the public health or welfare, enhance the quality of water and serve the purposes of the State Water Control Law (§ 62.1-44.2 et seq. of the Code of Virginia) and the federal Clean Water Act (33 USC § 1251 et seq.).
Best management practices (BMP) means schedules of activities, prohibitions of practices, maintenance procedures, and other management practices to prevent or reduce the pollution of waters of the United States. BMPs include treatment requirements, operation procedures, and practices to control plant site runoff, spillage or leaks, sludge or waste disposal, or drainage from raw material storage.
Clean air standards, as used in this clause means:
Prudent Industry Practices means, at a particular time, any of the practices, methods, standards of care, skill, safety and diligence, as the same may change from time to time, but applied in light of the facts known at the time, that are consistent with the general standards applied or utilized under comparable circumstances by a reasonably prudent operator, in a good and workmanlike manner, with due diligence and dispatch, in accordance with good midstream industry practice.
Clean water standards, as used in this clause, means any enforceable limitation, control, condition, prohibition, standard, or other requirement promulgated under the Water Act or contained in a permit issued to a discharger by the Environmental Protection Agency or by a State under an approved program, as authorized by Section 402 of the Water Act (33 U.S.C. § 1342), or by local government to ensure compliance with pre-treatment regulations as required by Section 307 of the Water Act (33 U.S.C. § 1317).
Group practice means a group of two or more health care providers legally organized as a partnership, professional corporation, or similar association:
Stormwater Pollution Prevention Plan or "SWPPP" means a document that is prepared in accordance with good engineering practices and that identifies potential sources of pollutants that may reasonably be expected to affect the quality of stormwater discharges from the construction site, and otherwise meets the requirements of this Ordinance. In addition the document shall identify and require the implementation of control measures, and shall include, but not be limited to the inclusion of, or the incorporation by reference of, an approved erosion and sediment control plan, an approved stormwater management plan, and a pollution prevention plan.
Employment Practices means any wrongful or unfair dismissal, denial of natural justice, defamation, misleading representation or advertising, unfair contracts, harassment or discrimination (sexual or otherwise) in respect of employment by the Insured.
Occupational Safety and Health Law means any Legal Requirement designed to provide safe and healthful working conditions and to reduce occupational safety and health hazards, including the Occupational Safety and Health Act, and any program, whether governmental or private (such as those promulgated or sponsored by industry associations and insurance companies), designed to provide safe and healthful working conditions.
Rail Safety Act means the Rail Safety Act 1998 (WA);
Good Laboratory Practices or “GLP” means the then-current Good Laboratory Practice (or similar standards) for the performance of laboratory activities for pharmaceutical products as are required by applicable Regulatory Authorities or Applicable Law. In the United States, Good Laboratory Practices are established through FDA regulations (including 21 C.F.R. Part 58), FDA guidance, FDA current review and inspection standards and current industry standards.
Stormwater runoff means water flow on the surface of the ground or in storm sewers, resulting from precipitation.
Applicable water quality standards means all water quality standards to which a discharge is subject under the federal Clean Water Act and which has been (a) approved or permitted to remain in effect by the Administrator following submission to the Administrator pursuant to Section 303(a) of the Act, or (b) promulgated by the Director pursuant to Section 303(b) or 303(c) of the Act, and standards promulgated under (APCEC) Regulation No. 2, as amended.
Environmental Policy means to conserve energy, water, wood, paper and other resources, reduce waste and phase out the use of ozone depleting substances and minimise the release of greenhouse gases, volatile organic compounds and other substances damaging to health and the environment, including any written environmental policy of the Customer;
Best Practice means solutions, techniques, methods and approaches which are appropriate, cost-effective and state of the art (at Member State and sector level), and which are implemented at an operational scale and under conditions that allow the achievement of the impacts set out in the award criterion ’Impact’ first paragraph (see below).
Privilege to practice means: an individual's authority to deliver emergency medical services in remote states as authorized under this compact.
Reliability Standards means the criteria, standards, rules and requirements relating to reliability established by a Standards Authority.