Unassigned emissions definition

Unassigned emissions means the amount of emissions that are in excess of the PSEL but less than the netting basis.

Examples of Unassigned emissions in a sentence

  • Unassigned emissions may only be used for netting purposes, and cannot be sold or banked.

  • However, the precipitation data available for use by the accounting procedure prior to WY 1990 (particularly WYs 1984–1989) displayed patterns inconsistent with known long-term Chicago area patterns (e.g., Changnon, 1961, 1968; Huff and Changnon, 1973; Vogel, 1988, 1989; Peppler, 1990, 1991a, 1993a).

  • Unassigned emissions are emissions in excess of the PSEL but less than the netting basis, and are limited to a value equivalent to the SER.

  • Unassigned emissions do not qualify as emission "credits" and cannot be banked, traded, or sold externally.

  • Transportation tariffs are set by the Danish energy regulator and divided in a capacity component depending on the capacity booked by the shipper and a commodity charge depending on the volume of gas transported.

  • The best localization accuracy (e¯loc = 0.96 m and s¯att = 0.063) is achieved when m = 3.

  • Unassigned emissions may not be banked or transferred to another source.

  • The remainder of the emission reductions were identified as unassigned emissions in the last permit renewal in accordance with OAR 340-222-0045.30.b. Unassigned emissions can be used at the facility for one permit term.

  • Unassigned emissions equal the netting basis minus the source’s current PTE, minus any banked emission reduction credits.

  • Unassigned emissions are that portion of the baseline emission rate that is greater than the source‟s current capacity, excluding any credits.

Related to Unassigned emissions

  • Excess emissions - means an emission rate that exceeds any applicable emission limitation or standard allowed by any rule in Sections .0500, .0900, .1200, or .1400 of Subchapter 02D; or by a permit condition; or that exceeds an emission limit established in a permit issued under 15A NCAC 02Q .0700. (Note: Definitions of excess emissions under 02D .1110 and 02D .1111 shall apply where defined by rule.)

  • Secondary emissions means emissions which occur as a result of the construction or operation of a major stationary source or major modification, but do not come from the major stationary source or major modification itself. For the purposes of this chapter, “secondary emissions” must be specific, well-defined, and quantifiable, and must impact the same general areas as the stationary source modification which causes the secondary emissions. “Secondary emissions” includes emissions from any offsite support facility which would not be constructed or increase its emissions except as a result of the construction or operation of the major stationary source or major modification. “Secondary emissions” does not include any emissions which come directly from a mobile source, such as emissions from the tailpipe of a motor vehicle, from a train, or from a vessel.

  • Underground injection means the subsurface emplacement of fluids through a bored, drilled or driven well; or through a dug well, where the depth of the dug well is greater than the largest surface dimension. (See also “injection well”.)

  • Actual emissions means the actual rate of emissions in tpy of any regulated pollutant (for fee calculation) emitted from a Part 71 source over the preceding calendar year. Actual emissions shall be calculated using each emissions unit’s actual operating hours, production rates, in-place control equipment, and types of materials processed, stored, or combusted during the preceding calendar year.

  • Routine Patient Costs means all health care services that are otherwise covered under the Group Contract for the treatment of cancer or other Life-threatening Condition that is typically covered for a patient who is not enrolled in an Approved Clinical Trial.

  • Facility Site means the site described in Schedule B. “FERC” means the Federal Energy Regulatory Commission.